In situ localization and structural analysis of the malaria pigment hemozoin.

Raman microspectroscopy was applied for an in situ localization of the malaria pigment hemozoin in Plasmodium falciparum-infected erythrocytes. The Raman spectra (lambdaexc=633 nm) of hemozoin show very intense signals with a very good signal-to-noise ratio. These in situ Raman signals of hemozoin were compared to Raman spectra of extracted hemozoin, of the synthetic analogue beta-hematin, and of hematin and hemin. beta-Hematin was synthesized according to the acid-catalyzed dehydration of hematin and the anhydrous dehydrohalogenation of hemin which lead to good crystals with lengths of about 5-30 microm. The Raman spectra (lambdaexc=1064 nm) of hemozoin and beta-hematin show almost identical behaviors, while some low wavenumber modes might be used to distinguish between the morphology of differently synthesized beta-hematin samples. The intensity pattern of the resonance Raman spectra (lambdaexc=568 nm) of hemozoin and beta-hematin differ significantly from those of hematin and hemin. The most striking difference is an additional band at 1655 cm(-1) which was only observed in the spectra of hemozoin and beta-hematin and cannot be seen in the spectra of hematin and hemin. Raman spectra of the beta-hematin dimer were calculated ab initio (DFT) for the first time and used for an assignment of the experimentally derived Raman bands. The calculated atomic displacements provide valuable insight into the most important molecular vibrations of the hemozoin dimer. With help from these DFT calculations, it was possible to assign the Raman band at 1655 cm(-1) to a mode located at the propionic acid side chain, which links the hemozoin dimers to each other. The Raman band at 1568 cm(-1), which has been shown to be influenced by an attachment of the antimalarial drug chloroquine in an earlier study, could be assigned to a C=C stretching mode spread across one of the porphyrin rings and is therefore expected to be influenced by a pi-pi-stacking to the drug.

Ultrasensitive in situ tracing of the alkaloid dioncophylline A in the tropical liana Triphyophyllum peltatum by applying deep-UV resonance Raman microscopy.

UV resonance Raman microspectroscopy was applied for a localization of the antiplasmodial naphthylisoquinoline alkaloid dioncophylline A in very low concentrations in different parts of the samples (e.g., in the roots) of the tropical liana Triphyophyllum peltatum. The application of resonance Raman microspectroscopy was characterized by a very high sensitivity and selectivity. It was possible to assign the resonance Raman spectra of dioncophylline A, dioncophylline C, and dioncopeltine A by means of a combination of NIR Raman spectroscopy and DFT calculations. The UV resonance Raman spectra of T. peltatum are very well resembled by the spectra of dioncophylline A, while they can be clearly distinguished from the spectra of dioncophylline C and dioncopeltine A. This distinction between the various naphthylisoquinolines was possible by the two modes at 1356 and 1613 cm-1. These two modes were assigned to C=C stretching and CH bending vibrations. The presented results of a highly sensitive and selective in situ localization of the active agent dioncophylline A in different parts of the plant material of T. peltatum are of high importance for the acquisition of new antimalarials and for plant science in general.

Determination of mechanical strength properties of hemp fibers using near-infrared fourier transform Raman microspectroscopy.

Fourier transform near-infrared (FT-NIR) Raman microspectroscopy was adopted for analyzing the micro mechanical tensile deformation behavior of cellulosic plant fibers. Mechanical strength parameters such as tensile strength, failure strain, and Young's modulus of diversified hemp fibers were determined within the range of single fiber cells and fiber filaments. The analysis of fiber deformation at the molecular level was followed by the response of a characteristic Raman signal of fiber cellulose that is sensitive to the tensile load applied. The frequency shift of the Raman signal at 1095 cm(-1) to lower wavenumbers was observed when the fibers were subjected to tensile strain. Microstructural investigations using electron microscopy under environmental conditions supported the discussion of mechanical properties of hemp fibers in relation to several fiber variabilities. Generally, mechanical strength properties of diversified hemp fibers were discussed at the molecular, microstructural, and macroscale level. It was observed that mechanical strength properties of the fibers can be controlled in a broad range by appropriate mercerization parameters such as alkali concentration, fiber shrinkage, and tensile stress applied to the fibers during the alkaline treatments.

In vivo localization and identification of the antiplasmodial alkaloid dioncophylline A in the tropical liana Triphyophyllum peltatum by a combination of fluorescence, near infrared Fourier transform Raman microscopy, and density functional theory calculations.

Near infrared Fourier transform (NIR FT) micro Raman spectroscopy in combination with density functional theory (DFT) calculations has been applied for an in vivo localization of the antiplasmodial naphthylisoquinoline alkaloid dioncophylline A (1) in the tropical liana Triphyophyllum peltatum. Fluorescence microscopy images suggest finding this active agent in 10 mum big inclusions located in the cortex of the stem or the beginning of the leaves. By means of spatially resolved FT Raman micro spectroscopy, we could detect dioncophylline A (1) in these inclusions. FT Raman spectroscopy is an extremely selective tool capable of differentiating between various structurally similar naphthylisoquinoline alkaloids. With the help of DFT calculations, we succeeded in assigning the differences found in the FT Raman spectra of the various naphthylisoquinolines to nuC=C vibrations of the naphthyl ring. The presented results are of relevance for the investigation and extraction of new antimalarial active agents.