Molecular Control of the Donor/Acceptor Interface Suppresses Charge Recombination Enabling High-Efficiency Single-Component Organic Solar Cells.

Single-component organic solar cells based on double cable polymers have achieved remarkable performance, with DCPY2 reaching a high efficiency of over 13%. In this study, DCPY2 is further optimized with an efficiency of 13.85%, maintaining a high fill factor (FF) without compromising the short circuit current. Despite its intermixed morphology, DCPY2 shows a reduced recombination rate compared to their binary counterpart (PBDB-T:Y-O6). This slower recombination in DCPY2 is attributed to the reduced wavefunction overlap of delocalized charges, achieved by spatially separating the donor and acceptor units with an alkyl linker, thereby restricting the recombination pathways. Adding 1,8-diiodooctane (DIO) into DCPY2 further reduced the recombination rate by facilitating acceptor aggregation, allowing free charges to become more delocalized. The DIO-assisted aggregation in DCPY2 (5% DIO) is evidenced by an increased pseudo-pure domain size of Y-O6. Fine molecular control at the donor/acceptor interface in the double-cable polymer achieves reduced non-geminate recombination under efficient charge generation, increased mobility, and charge carrier lifetime, thereby achieving superior performance. Nevertheless, the FF is still limited by relatively low mobility compared to the blend, suggesting the potential for further mobility improvement through enhanced higher-dimensional packing of the double-cable material.

Robust All-Day Frostphobic Surfaces.

The application of solar-thermal surfaces for antifrosting and defrosting has emerged as a passive and environmentally friendly approach to mitigate the negative consequences of frost formation, such as structural damage and reduced heat transfer efficiency. However, achieving robust all-day frostphobicity solely through interfacial modification and solar-thermal effects is challenging in practical applications: The thick frost that accumulates at night strongly scatters solar radiation, rendering the solar-thermal coatings ineffective during the daytime. Additionally, these nanostructured coatings are susceptible to wear and tear when exposed to the outdoors for extended periods of time. To address these challenges, we present an innovative frostphobic surface that incorporates V-grooved structures with superhydrophobic solar-thermal layers (VSSs). The out-of-plane gradient structures facilitate spatially regulated vapor diffusion, an enhanced photothermal effect, and robust water repellency. These features not only prevent frost from covering the entire surface overnight, enabling effective solar-thermal defrosting during the daytime, but also protect the surface from deterioration. The combined merits ensure robust all-day frostphobicity and exceptional durability, making the VSS surface promising for practical applications and extending the lifespan in extreme environments.

Slow Hot-Exciton Cooling and Enhanced Interparticle Excitonic Coupling in HgTe Quantum Dots.

Rapid hot-carrier/exciton cooling constitutes a major loss channel for photovoltaic efficiency. How to decelerate the hot-carrier/exciton relaxation remains a crux for achieving high-performance photovoltaic devices. Here, we demonstrate slow hot-exciton cooling that can be extended to hundreds of picoseconds in colloidal HgTe quantum dots (QDs). The energy loss rate is 1 order of magnitude smaller than bulk inorganic semiconductors, mediated by phonon bottleneck and interband biexciton Auger recombination (BAR) effects, which are both augmented at reduced QD sizes. The two effects are competitive with the emergence of multiple exciton generation. Intriguingly, BAR dominates even under low excitation fluences with a decrease in interparticle distance. Both experimental evidence and numerical evidence reveal that such efficient BAR derives from the tunneling-mediated interparticle excitonic coupling induced by wave function overlap between neighboring HgTe QDs in films. Thus, our study unveils the potential for realizing efficient hot-carrier/exciton solar cells based on HgTe QDs. Fundamentally, we reveal that the delocalized nature of quantum-confined wave function intensifies BAR. The interparticle excitonic coupling may cast light on the development of next-generation photoelectronic materials, which can retain the size-tunable confinement of colloidal semiconductor QDs while simultaneously maintaining high mobilities and conductivities typical for bulk semiconductor materials.

Red-Emitting CsPbI3/ZnSe Colloidal Nanoheterostructures with Enhanced Optical Properties and Stability.

Producing heterostructures of cesium lead halide perovskites and metal-chalcogenides in the form of colloidal nanocrystals can improve their optical features and stability, and also govern the recombination of charge carriers. Herein, the synthesis of red-emitting CsPbI3/ZnSe nanoheterostructures is reported via an in situ hot injection method, which provides the crystallization conditions for both components, subsequently leading to heteroepitaxial growth. Steady-state absorption and photoluminescence studies alongside X-ray photoelectron spectroscopy and ultraviolet photoelectron spectroscopy analysis evidence on a type-I band alignment for CsPbI3/ZnSe nanoheterostructures, which exhibit photoluminescence quantum yield of 96% due to the effective passivation of surface defects, and an enhancement in carrier lifetime. Furthermore, the heterostructure growth of ZnSe domains leads to significant improvement in the stability of the CsPbI3 nanocrystals under ambient conditions and against thermal and UV irradiation stress.

Non-Polio Enterovirus Surveillance in the Ural Federal District and Western Siberia, 2022: Is There a Need for a Vaccine?

Human non-polio enteroviruses (NPEVs) are the etiological agents involved in most cases of hand-foot-and-mouth disease (HFMD), herpangina and aseptic meningitis. Information on the epidemiology profiles of NPEV in the Ural Federal District and Western Siberia is very limited, with no published data available. The aim of this study is to describe NPEV incidence in the Ural Federal District and Western Siberia among patients with different forms of non-polio enterovirus infections (NPEVIs) during 2022, stratified by age and clinical manifestations. A total of 265 samples that tested positive for NPEV using a polymerase chain reaction (PCR) were genotyped by semi-nested PCR for the VP1 gene. The results showed that 21 genotypes were identified among patients in this study. CVA6 was the most common genotype for HFMD. CVA6, along with CVA10, accounted for the majority of herpangina cases, while CVA9 was implicated in most meningitis cases. Sequence and phylogenetic analysis showed that nearly all of the CVA6 strains identified in this study displayed a close genetic relationship to strains identified in other cities in Russia and strains from China. NPEV surveillance allows for monitoring the circulation of clinically relevant genotypes, resulting in continuous data about NPEV epidemiology. This is important for improving case prevention, diagnosis and guiding clinical management.

Quasi-2D Dion-Jacobson phase perovskites as a promising material platform for stable and high-performance lasers.

Metal halide perovskites have shown outstanding optoelectronic and nonlinear optical properties; yet, to realize wafer-scale high-performance perovskite-integrated photonics, the materials also need to have excellent ambient stability and compatibility with nanofabrication processes. In this work, we introduce Dion-Jacobson (D-J) phase perovskites for photonic device applications. By combining self-assembled monolayer-assisted film growth with thermal pressing, we obtain a series of compact and extremely smooth D-J phase perovskite thin films that exhibit excellent stability during electron-beam lithography, solvent development, and rinse. Combining spectroscopic and morphological characterizations, we further demonstrate how organic spacers can be used to fine-tune the photophysical properties and processability of the perovskite films. The distributed-feedback lasers based on the D-J phase perovskites exhibit a low lasing threshold (5.5 µJ cm-2 pumped with nanosecond laser), record high Q factor (up to 30,000), and excellent stability, with an unencapsulated device demonstrating a T90 beyond 60 hours in ambient conditions (50% relative humidity).

Effect of Passivating Molecules and Antisolvents on Lifetime of Green Dion-Jacobson Perovskite Light-Emitting Diodes.

We investigated the influence of two passivating molecules containing a P═O group on the performance of quasi-2D Dion-Jacobson halide perovskite light-emitting diodes, namely, triphenylphosphine oxide (TPPO) and diphenyl-4-triphenylsilylphenyl phosphine oxide (TSPO1). We found that both passivating molecules lead to increased efficiency compared to control devices, while they had opposite effects on device lifetime, with a decrease observed for TPPO and an increase observed for TSPO1. The two passivating molecules resulted in differences in energy-level alignment, electron injection, film morphology and crystallinity, and ion migration during operation. While TPPO resulted in improved photoluminescence decay times, overall higher maximum external quantum efficiency (EQE) and device lifetime were obtained for TSPO1 compared to TPPO (14.4% vs 12.4% EQE, 341 min vs 42 min T50).

Carbon Dot Emission Enhancement in Covalent Complexes with Plasmonic Metal Nanoparticles.

Carbon dots can be used for the fabrication of colloidal multi-purpose complexes for sensing and bio-visualization due to their easy and scalable synthesis, control of their spectral responses over a wide spectral range, and possibility of surface functionalization to meet the application task. Here, we developed a chemical protocol of colloidal complex formation via covalent bonding between carbon dots and plasmonic metal nanoparticles in order to influence and improve their fluorescence. We demonstrate how interactions between carbon dots and metal nanoparticles in the formed complexes, and thus their optical responses, depend on the type of bonds between particles, the architecture of the complexes, and the degree of overlapping of absorption and emission of carbon dots with the plasmon resonance of metals. For the most optimized architecture, emission enhancement reaching up to 5.4- and 4.9-fold for complexes with silver and gold nanoparticles has been achieved, respectively. Our study expands the toolkit of functional materials based on carbon dots for applications in photonics and biomedicine to photonics.

Black Au-Decorated TiO2 Produced via Laser Ablation in Liquid.

The rational combination of plasmonic and all-dielectric concepts within hybrid nanomaterials provides a promising route toward devices with ultimate performance and extended modalities. Spectral matching of plasmonic and Mie-type resonances for such nanostructures can only be achieved for their dissimilar characteristic sizes, thus making the resulting hybrid nanostructure geometry complex for practical realization and large-scale replication. Here, we produced amorphous TiO2 nanospheres decorated and doped with Au nanoclusters via single-step nanosecond-laser irradiation of commercially available TiO2 nanopowders dispersed in aqueous HAuCl4. Fabricated hybrids demonstrate remarkable light-absorbing properties (averaged value ≈96%) in the visible and near-IR spectral range mediated by bandgap reduction of the laser-processed amorphous TiO2 as well as plasmon resonances of the decorating Au nanoclusters. The findings are supported by optical spectroscopy, electron energy loss spectroscopy, transmission electron microscopy, and electromagnetic modeling. Light-absorbing and plasmonic properties of the produced hybrids were implemented to demonstrate catalytically passive SERS biosensor for identification of analytes at trace concentrations and solar steam generator that permitted to increase water evaporation rate by 2.5 times compared with that of pure water under identical 1 sun irradiation conditions.

Ultratrace Nitroaromatic Vapor Detection via Surface-Enhanced Fluorescence on Carbazole-Terminated Black Silicon.

Detection of nitroaromatic compounds (NACs) is an important applied task for environmental monitoring, medical diagnostics, and forensic analysis. However, detection of NAC vapors is challenging owing to their low vapor pressure and relatively weak sensitivity of the existing detection techniques. Here, we propose a novel concept to design fluorescence (FL) detection platforms based on chemical functionalization of nanotextured dielectric surfaces exhibiting resonant light absorption, trapping, and localization effects. We demonstrate highly-efficient NAC vapor sensor with selective FL-quenching response from monolayers of carbazole moieties covalently bonded to a spiky silicon surface, "black" silicon, produced over the centimeter-scale area using simple reactive ion etching. The sensor is shown to provide unprecedented ppt (10-12) range limits of detection for several NAC vapors. Easy-to-implement scalable fabrication procedure combined with simple and versatile functionalization techniques applicable to all-dielectric surfaces make the suggested concept promising for realization of various gas sensing systems for social and environmental safety applications.

Serum Levels of Mitochondrial and Microbial Metabolites Reflect Mitochondrial Dysfunction in Different Stages of Sepsis.

Mechanisms of mitochondrial dysfunction in sepsis are being extensively studied in recent years. During our study, concentrations of microbial phenolic acids and mitochondrial metabolites (succinic, α-ketoglutaric, fumaric, itaconic acids) as indicators of sepsis and mitochondrial dysfunction, respectively, are measured by gas chromatography-mass spectrometry (GC-MS) in the blood of critically ill patients at the early and late stages of documented sepsis. The increase in levels of some phenylcarboxylic (phenyllactic (PhLA), p-hydroxyphenylacetic (p-HPhAA), p-hydroxyphenyllactic (p-HPhAA)) acids (PhCAs), simultaneously with a rise in levels of mitochondrial dicarboxylic acids, are mainly detected during the late stage of sepsis, especially succinic acid (up to 100-1000 µM). Itaconic acid is found in low concentrations (0.5-2.3 µM) only at early-stage sepsis. PhCAs in vitro inhibits succinate dehydrogenase (SDH) in isolated mitochondria but, unlike itaconic acid which acts as a competitive inhibitor of SDH, microbial metabolites most likely act on the ubiquinone binding site of the respiratory chain. A close correlation of the level of succinic acid in serum and sepsis-induced organ dysfunction is revealed, moreover the most significant correlation is observed at high concentrations of phenolic microbial metabolites (PhCAs) in late-stage sepsis. These data indicate the promise of such an approach for early detection, monitoring the progression of organ dysfunction and predicting the risk of non-survival in sepsis.