RESUMEN
Polyarylates have shown promise as fully degradable polymers for drug delivery as well as for structural implant applications due to their range of physicomechanical properties. Processing history, however, could have a significant impact on their overall performance in biologically relevant environments. More specifically, structural changes at the molecular level can occur that will affect a polymer's physical properties and subsequent, cell attachment and growth. The present study was aimed at comparing cell growth on tyrosine-derived polyarylates with that of polylactic acid (PLLA) in their original state and after processing (i.e. undrawn and drawn forms). Two polyarylates having distinct molecular structures were chosen. Strictly, amorphous poly(DTE adipate), denoted as poly(DT 2,4), and poly(DTD) dodecandioate, denoted as poly(DT 12,10), having a more complex, non-crystalline organization, were compared with semi-crystalline PLLA. The degree of shrinkage, thermal characterization, air-water contact angle and surface morphology were determined for each polymer in its undrawn and drawn states. Poly(DT 2,4) and PLLA after processing resulted in greater shrinkage and a slight decrease in hydrophilicity whereas poly(DT 12,10) had minimal shrinkage and became slightly more hydrophilic in its drawn state. Surface morphology or roughness was also altered by processing. In turn, the rate of cell growth and overall cell numbers were reduced significantly on drawn forms of poly(DT 2,4) and PLLA, whereas more favorable growth rates were supported on drawn poly(DT 12,10). These findings indicate that processing effects in amorphous as well as oriented polymeric structures can significantly alter their biological performance.