Preparation of Mn/Ti-modified zeolite and its performance for removing iron and manganese.

Excessive iron and manganese presented in groundwater sources may cause harm to human health that needs to be solved urgently. This research aims to develop high-performance Mn/Ti-modified zeolites using sol-gel method and hydrothermal synthesis method to remove Fe2+ and Mn2+ simultaneously. The preparation parameters were optimized by response surface methodology, and the results confirmed that the optimal preparation conditions were as follows: mass ratio of MnO2-TiO2/zeolite = 1, hydrothermal temperature = 200°C, and calcination temperature = 500°C. The results of batch adsorption experiments showed that the best removal rate of Fe2+ and Mn2+ by modified zeolite materials which was prepared under the optimum conditions reached 96.8% and 94.4%, respectively, at which the saturated adsorption capacity was 2.80 mg/g and 1.86 mg/g. Through the adsorption kinetics, thermodynamics, internal diffusion, and isothermal adsorption analyses, it is confirmed that the adsorption process of Fe2+ and Mn2+ by the modified zeolite is mainly chemical adsorption. The results of the Weber-Morris internal diffusion model prove that internal diffusion is not the only step that controls the adsorption process. In addition, combined with the characterization of the composite-modified zeolite and the adsorption experimental study, it shows that there is an autocatalytic reaction in the adsorption process.

In situ anodic induction of low-valence copper in electro-Fenton system for effective nitrobenzene degradation.

To achieve superior advanced oxidation processes (AOPs), transitional state activators are of great significance for the production of active radicals by H2O2, while instability limits their activation efficiency. In this study, density functional theory calculation (DFT) results showed that Cu+ exhibits excellent H2O2 activation performance, with Gibbs free energy change (ΔG) of 33.66 kcal/mol, two times less than that of Cu2+ (77.83 kcal/mol). Meanwhile, an electro-Fenton system using Cu plate as an anode was proposed for in situ generation of Cu+. The released Cu with low-valence state can be well-confined on the surface of the exciting electrode, which was confirmed by X-ray photoelectron spectroscopy (XPS), Raman, and UV-vis spectroscopy. The hydroxyl radicals in this Cu-based electro-Fenton system were determined by the electron spin resonance (ESR). The nitrobenzene degradation ratio was greatly increased by 43.90% with the introduction of the proposed in situ electrochemical Cu+ generation process. Various characterization results indicated that the production of Cu+ was the key factor in the highly efficient Cu-based electro-Fenton reaction.

Municipal wastewater treatment plants coupled with electrochemical, biological and bio-electrochemical technologies: Opportunities and challenge toward energy self-sufficiency.

Municipal wastewater treatment plants (WWTPs) will face challenges in the coming decades including reducing energy consumption and decreasing carbon emissions. These challenges can be addressed by combining electrochemical, biological, and bio-electrochemical technologies within existing WWTPs. The results from this review indicate that electrochemical technology is an effective advanced treatment method for WWTPs. However, electrochemical technology is not yet economically suitable as a stand-alone unit for treating wastewater because it consumes energy in the operation process. Electricity generation from biological and bio-electrochemical technologies can provide the power supply needed for WWTP electrochemical processes while reducing greenhouse gas emissions. WWTPs coupled with electrochemical, biological, and bio-electrochemical technologies can increase electricity recovery in WWTPs, impart energy self-sufficiency to the WWTPs, and decrease greenhouse gas emissions.