Correction to: Photoelectrochemical sensing of tannic acid based on the use of TiO2 sensitized with 5-methylphenazinium methosulfate and carboxy-functionalized CdTe quantum dots.

The published version of this article, unfortunately, contains an error in that Fig. 2 shows the same study as Fig. 3. The correct Fig. 2 is shown below.

Photoelectrochemical sensing of tannic acid based on the use of TiO2 sensitized with 5-methylphenazinium methosulfate and carboxy-functionalized CdTe quantum dots.

The article describes a method for determination of tannic acid in extracts of medicinal plants. Tannic acid (TA) is an antioxidant and has anticancer and antimicrobial properties. Titanium dioxide nanoparticles (TiO2) were co-sensitized with 5-methylphenazinium methosulfate (PMS) and carboxy-functionalized cadmium telluride quantum dots (CdTe QDs), and immobilized on a fluorine-doped tin oxide electrode. The surface morphology and electrochemical properties of the modified electrode were investigated by scanning electron microscopy and amperometry, respectively. A composite consisting of TiO2, PMS and CdTe QDs in a nafion film has a response to TA under LED light higher than that observed for each separate component. Under optimized experimental conditions and at an applied voltage of +0.4 V vs Ag/AgCl, the photoelectrochemical sensor has a linear response in the 0.2 to 200 µmol L-1 TA concentration range and a detection limit of 60 nmol L-1. The sensor was successfully applied to the determination of TA in spiked extracts from three medicinal plants, with recovery values between 98.3 and 103.9 %. Graphical abstract Schematic diagram for photoelectrochemical detection of tannic acid based on a fluorine doped tin oxide electrode modified with titanium oxide, 5-methylphenazinium methosulfate and carboxy-functionalized cadmium telluride quantum dots.

Layer-by-layer assembled films of multi-walled carbon nanotubes with chitosan and cellulose nanocrystals.

Chitosan solutions and cellulose nanocrystal suspensions were used to produce highly stable aqueous dispersions of multi-walled carbon nanotubes (MWCNTs). The different MWCNT dispersions, presenting positive and negative charges, were used to prepare multilayered hybrid thin films through electrostatic layer-by-layer (LBL) self-assembly. The MWCNTs are well dispersed and homogeneously distributed on each layer of chitosan and cellulose nanocrystals of the films. The nanotubes are densely packed in each multilayer, forming a random network. The surface of the LBL film exhibited a uniform and relatively smooth surface with a mean roughness value of ∼5.8±0.4nm. Electrochemical characterization revealed a decrease in two orders of magnitude in the film resistance as the number of bilayers increased from 5 to 20, which is a consequence of an increase in the amount of conductive material (MWCNT). The thin films with up to 20 bilayers exhibited transmittance higher than 90% in the visible range. The results presented in this work demonstrate the viability of the LBL technique for the deposition of active materials using the biopolymer pair chitosan/cellulose nanocrystals. The obtained films can be employed for the design of transparent and biocompatible carbon nanostructured based electrodes.