RESUMEN
This study presents research results concerning the vacuum carburizing of four steel grades, specifically conforming to European standards 1.7243, 1.6587, 1.5920, and 1.3532. The experimental specimens exhibited variations primarily in nickel content, ranging from 0 to approximately 3.8 wt. %. As a comparative reference, gas carburizing was also conducted on the 1.3532 grade, which had the highest nickel content. Comprehensive structural analysis was carried out on the resultant carburized layers using a variety of techniques, such as optical and electron scanning, transmission microscopy, and X-ray diffraction. Additionally, mechanical properties such as hardness and fatigue strength were assessed. Fatigue strength evaluation was performed on un-notched samples having a circular cross-section with a diameter of 12 mm. Testing was executed via a three-point bending setup subjected to sinusoidally varying stresses ranging from 0 to maximum stress levels. The carburized layers produced had effective thicknesses from approximately 0.8 to 1.4 mm, surface hardness levels in the range of 600 to 700 HV, and estimated retained austenite contents from 10 to 20 vol%. The observed fatigue strength values for the layers varied within the range from 1000 to 1350 MPa. It was found that changing the processing method from gas carburizing, which induced internal oxidation phenomena, to vacuum carburizing improved the fatigue properties to a greater extent than increasing the nickel content of the steel.
RESUMEN
Low-energy nuclear reactions are known to be extremely dependent on the local crystal structure and crystal defects of the deuterated samples. This has a strong influence on both hydrogen diffusion and the effective electron mass. The latter determines the strength of the local electron-screening effect and can change the deuteron-deuteron reaction rates at very low energies by many orders of magnitude. In the present study, zirconium samples were exposed to various conditions and energies of deuteron beams using the unique accelerator system with ultra-high vacuum, installed in the eLBRUS laboratory at the University of Szczecin. Irradiated and virgin samples were investigated by means of the X-ray diffraction (XRD) and positron annihilation spectroscopy (PAS). While the first method delivers information about changes of crystal lattice parameters and possible production of hydrides accompanying the formation of dislocations that are produced during irradiation of the samples, the second one can determine the depth distribution of crystal defects, being especially sensitive to vacancies. The studied Zr samples were also implanted by carbon and oxygen ions in order to simulate the real situation taking place in nuclear reaction experiments and to investigate their influence on the kinetic of produced vacancies. The observed enhancement of the electron-screening effect in the deuteron fusion reaction at very low energies could be explained by formation of a high number of vacancies during the deuteron irradiation of samples. Possible carbon and oxygen impurities can affect this process in various ways by changing the depth distribution of vacancies and their diffusion, but they play only a minor role in the strength of the electron-screening effect.
