Preliminary effect of projectile yaw on extremity gunshot wounding in a cadaveric animal model: a serendipitous study.

Gunshot wounding (GSW) is capable of causing devastating tissue injuries by delivering kinetic energy (KE) through the contact surface area of a projectile. The contact surface area can be increased by yaw, deformation and fragmentation, all of which may be caused by any intermediate layers struck by the projectile prior to entering its target. This study aims to describe whether projectile yaw occurring before penetration of a cadaveric animal limb model causes greater damage with or without clothing layers present using 5.45 × 39 mm projectiles. In total, 12 fallow deer hind limbs were shot, further divided into 4 with no clothing layers (Cnil), 4 with a single clothing layer (Cmin) and 4 with maximum clothing layers (Cmax) as worn on active duty by UK military personnel. Contrast computed tomography (CT) of limbs was used to measure permanent cavity size and the results were compared using analysis of variance (ANOVA). No significant differences were found among clothing states for each series of measurements taken, with greater cavity sizes noted in all clothing states. This is in contrast to previous work looking at symmetrically flying projectiles in the same model, where a larger permanent cavity was found only with Cmax present. Projectile yaw is therefore likely to be a key variable with regard to causation of damage within this extremity wound model.

Ballistic research techniques: visualizing gunshot wounding patterns.

There are difficulties associated with mapping gunshot wound (GSW) patterns within opaque models. Depending on the damage measurement parameters required, there are multiple techniques that can provide methods of "seeing" the GSW pattern within an opaque model. The aim of this paper was to test several of these techniques within a cadaveric animal limb model to determine the most effective. The techniques of interest were flash X-ray, ultrasound, physical dissection, and computed-tomography (CT). Fallow deer hind limbs were chosen for the model with four limbs used for each technique tested. Quarantined 7.62 × 39 mm ammunition was used for each shot, and each limb was only shot once, on an outdoor range with shots impacting at muzzle velocity. Flash X-ray provided evidence of yaw within the limb during the projectile's flight; ultrasound though able to visualise the GSW track, was too subjective and was abandoned; dissection proved too unreliable due to the tissue being cadaveric so also too subjective; and lastly, CT with contrast provided excellent imaging in multiple viewing planes and 3D image reconstruction; this allowed versatile measurement of the GSW pattern to collect dimensions of damage as required. Of the different techniques examined in this study, CT with contrast proved the most effective to allow precise GSW pattern analysis within a cadaveric animal limb model. These findings may be beneficial to others wishing to undertake further ballistic study both within clinical and forensic fields.

The effect of military clothing on gunshot wound patterns in a cadaveric animal limb model.

The majority of injuries in survivors of gunshot wounds (GSW) are typically to the extremities. Novel wound ballistic research is encouraged to try and capture corporate knowledge on the management of these injuries gained during recent conflicts and understand the wounding patterns seen. With recent work examining the effect of UK military clothing on extremity GSW patterns in a synthetic model, a model with greater biofidelity is needed for ballistic testing. The aim of this study was to assess the effect of UK military clothing on GSW patterns within a cadaveric animal limb model using two types of ammunition commonly used in recent conflicts-7.62 × 39 mm and 5.45 × 39 mm. In total, 24 fallow deer hind limbs were shot, 12 by 7.62 mm projectiles and the remaining 12 shot by 5.45 mm projectiles, further divided into four with no clothing layers (Cnil), four with a single clothing layer (Cmin) and four with maximum clothing layers (Cmax) as worn on active duty by UK military personnel. Limbs were analysed after ballistic impact using contrast CT scanning to obtain measurements of permanent cavity damage, and results were compared using analysis of variance (ANOVA). Results showed significantly different damage measurements within limbs with Cmax for both ammunition types compared with the other clothing states. This may result in GSWs that require more extensive surgical management, and invites further study.

The effect of military clothing on gunshot wounding patterns in gelatine.

With no two gunshot wounds (GSW) being the same, novel research into wound ballistics is challenging. It is evident that the majority of previous wound ballistic research has been conducted without the presence of clothing. Whilst the effect of clothing on wound contamination has been explored, there is a paucity of literature examining the effect of clothing on GSW patterns. The aim of this study was to test the effect of Multi-Terrain Pattern (MTP) UK military clothing on GSW patterns within calibrated blocks of 10% by mass gelatine, using two types of ammunition commonly used in recent conflicts-7.62 × 39 mm and 5.45 × 39 mm. In total, 36 blocks were shot, 18 by each projectile type, further divided into 6 with no clothing layers (Cnil), 6 with a single clothing layer (Cmin) and 6 with maximum clothing layers (Cmax) worn on active duty. Blocks were analysed with high-speed video and dissection to capture measurements of damage, and results compared using analysis of variance (ANOVA). Results showed significantly different damage measurements within blocks with Cmax for both ammunition types compared to the other clothing states. This may result in GSWs that require more extensive surgical management, inviting further study.

Marine cloud brightening.

The idea behind the marine cloud-brightening (MCB) geoengineering technique is that seeding marine stratocumulus clouds with copious quantities of roughly monodisperse sub-micrometre sea water particles might significantly enhance the cloud droplet number concentration, and thereby the cloud albedo and possibly longevity. This would produce a cooling, which general circulation model (GCM) computations suggest could-subject to satisfactory resolution of technical and scientific problems identified herein-have the capacity to balance global warming up to the carbon dioxide-doubling point. We describe herein an account of our recent research on a number of critical issues associated with MCB. This involves (i) GCM studies, which are our primary tools for evaluating globally the effectiveness of MCB, and assessing its climate impacts on rainfall amounts and distribution, and also polar sea-ice cover and thickness; (ii) high-resolution modelling of the effects of seeding on marine stratocumulus, which are required to understand the complex array of interacting processes involved in cloud brightening; (iii) microphysical modelling sensitivity studies, examining the influence of seeding amount, seed-particle salt-mass, air-mass characteristics, updraught speed and other parameters on cloud-albedo change; (iv) sea water spray-production techniques; (v) computational fluid dynamics studies of possible large-scale periodicities in Flettner rotors; and (vi) the planning of a three-stage limited-area field research experiment, with the primary objectives of technology testing and determining to what extent, if any, cloud albedo might be enhanced by seeding marine stratocumulus clouds on a spatial scale of around 100×100 km. We stress that there would be no justification for deployment of MCB unless it was clearly established that no significant adverse consequences would result. There would also need to be an international agreement firmly in favour of such action.

An in situ electrochemical cell for Q- and W-band EPR spectroscopy.

A simple design for an in situ, three-electrode spectroelectrochemical cell is reported that can be used in commercial Q- and W-band (ca. 34 and 94 GHz, respectively) electron paramagnetic resonance (EPR) spectrometers, using standard sample tubing (1.0 and 0.5 mm inner diameter, respectively) and within variable temperature cryostat systems. The use of the cell is demonstrated by the in situ generation of organic free radicals (quinones and diimines) in fluid and frozen media, transition metal ion radical anions, and on the enzyme nitric oxide synthase reductase domain (NOSrd), in which a pair of flavin radicals are generated.

In vitro galactosylation of human IgG at 1 kg scale using recombinant galactosyltransferase.

The Fc effector functions of immunoglobulin G (IgG) antibodies are in part determined by structural features of carbohydrates linked to each of the paired gamma heavy chains in the antibody constant domain (C(H)2). One glycoform that has been shown to be advantageous is G2, where both arms of complex bi-antennary N-glycans terminate in galactose. In vitro treatment with glycosyltransferases can remodel heterogeneous IgG glycoforms, enabling preparation of IgG molecules with homogeneous glycan chains. Here we describe optimization of conditions for use of a soluble recombinant galactosyltransferase in vitro to remodel glycans of human serum IgG, and we demonstrate a scaled-up reaction in which >98% of neutral glycans attached to 1 kg IgG are converted to the G2 glycoform. Removal of glycosylation reagents from the product is achieved in one step by affinity chromatography on immobilized Protein A.

Production of a complement inhibitor possessing sialyl Lewis X moieties by in vitro glycosylation technology.

Recombinant soluble human complement receptor type 1 (sCR1) is a highly glycosylated glycoprotein intended for use as a drug to treat ischemia-reperfusion injury and other complement-mediated diseases and injuries. sCR1-sLe(x) produced in the FT-VI-expressing mutant CHO cell line LEC11 exists as a heterogeneous mixture of glycoforms, a fraction of which include structures with one or more antennae terminated by the sialyl Lewis X (sLe(x)) [Neu5Acalpha2-3Galbeta1-4(Fucalpha1-3)GlcNAc]) epitope. Such multivalent presentation of sLe(x) was shown previously to effectively target sCR1 to activated endothelial cells expressing E-selectin. Here, we describe the use of the soluble, recombinant alpha2-3 sialyltransferase ST3Gal-III and the alpha1-3 fucosyltransferase FT-VI in vitro to introduce sLe(x) moieties onto the N-glycan chains of sCR1 overexpressed in standard CHO cell lines. The product (sCR1-S/F) of these in vitro enzymatic glycan remodeling reactions performed at the 10-g scale has approximately 14 N-glycan chains per sCR1 molecule, comprised of biantennary (90%), triantennary (8.5%), and tetraantennary (1.5%) structures, nearly all of whose antennae terminate with sLe(x) moieties. sCR1-S/F retained complement inhibitory activity and, in comparison with sCR1-sLe(x) produced in the LEC11 cell line, contained twice the number of sLe(x) moieties per mole glycoprotein, exhibited a twofold increase in area under the intravenous clearance curve in a rat pharmacokinetic model, and exhibited a 10-fold increase in affinity for E-selectin in an in vitro binding assay. These results demonstrate that in vitro glycosylation of the sCR1 drug product reduces heterogeneity of the glycan profile, improves pharmacokinetics, and enhances carbohydrate-mediated binding to E-selectin.