[Effects of low level laser irradiation on the osteogenic capacity of sodium alginate/gelatin/human adipose-derived stem cells 3D bio-printing construct].

OBJECTIVE: To explore the effects of low level laser irradiation (LLLI) on the osteogenic capacity of three-dimensional (3D) structure by 3D bio-printing construct used human adipose-derived stem cells (hASCs) as seed cells. METHODS: Using hASCs as seed cells, we prepared sodium alginate/gelatin/hASCs 3D bio-printing construct, and divided them into four groups: PM (proliferative medium), PM+LLLI, OM (osteogenic medium) and OM+LLLI, and the total doses of LLLI was 4 J/cm². Immunofluorescence microscopy was used to observe the viability of the cells, and analyze the expression of the osteogenesis-related protein Runt-related transcription factor 2 (Runx2) and osteocalcin (OCN). RESULTS: The 3D constructs obtained by printing were examined by microscope. The sizes of these 3D constructs were 10 mm×10 mm×1.5 mm. The wall thickness of the printed gelatin mold was approximately 1 mm, and the pores were round and had a diameter of about 700 µm. The cell viability of sodium alginate/gelatin/hASCs 3D bio-printing construct was high, and the difference among the four groups was not significant. On day 7, the expression of OCN from high to low was group OM+LLLI, PM+LLLI, OM and PM. There were significant differences among these groups (P<0.01), but there was no significant difference between group PM+LLLI and OM. On day 14, the expression of OCN in each group was higher than that on day 7, and there was no significant difference between group OM+LLLI and OM. The expression of Runx2 in group OM+LLLI was more than 90%, significantly higher than that in group OM (P<0.01). But the expression of Runx2 in group PM+LLLI and OM+LLLI were significantly lower than that in the non-irradiated groups. The expression of osteogenesis-related protein Runx2 and OCN were higher in OM groups than in PM groups. Furthermore, the irradiated groups were significantly higher than the non-irradiated groups. CONCLUSION: LLLI does not affect the cell viability of sodium alginate/gelatin/hASCs 3D bio-printing construct, and may promote the osteogenic differentiation of hASCs.

[Effect of low-level laser irradiation on proliferation and osteogenic differentiation of human adipose-derived stromal cells].

OBJECTIVE: To examine the in vitro effects of low-level laser irradiation (LLLI) on proliferation and differentiation of human adipose-derived stromal cells (hASCs). METHODS: Cultured cells were exposed to different doses of LLLI with a semiconductor diode laser (980 nm; 100 mW-12 W power output). The effects of laser on proliferation were assessed daily up to seven days of culture in cells irradiated for four consecutive days with laser doses of 2, 4, 6 or 8 J/cm2, the cells without irradiation were used as controls. Half of the cells were changed to osteogenic medium (OM) when they had grown to 70% confluence. The hASCs both with and without osteogenic supplements were divided into three groups, and each group was irradiated at doses of 0, 2 and 4 J/cm2. In order to examine the in vitro effects of LLLI on osteogenic differentiation of hASCs, the alkaline phosphatase activity was assessed on day 7, and alizarin red staining (AR-S) and quantitative detection were assessed on days 14 and 21. The expression of osteoblast master genes (ALP and Runx2) were tested on days 7 and 14. RESULTS: The proliferation medium(PM)+LLLI4 J/cm2 group had the highest multiplication rate. In the groups with osteogenic supplements, LLLI increased alkaline phosphatase activity and mineralized nodule formation, and stimulated the expression of ALP and Runx2. Furthermore, the effect became more obvious at high dose. CONCLUSION: Our data demonstrated that hASCs proliferation and osteogenic differentiation were enhanced by LLLI. With the increase of laser dose, the effect of LLLI would be enhanced at first, and then be decreased after reaching a peak.

Two-dimensional crystallization and projection structure of KcsA potassium channel.

Potassium channels are integral membrane proteins that play a crucial role in regulating diverse cell functions in both electrically excitable and non-excitable cells. Molecular cloning has revealed a diverse family of genes that encode these proteins, and a variety of experimental strategies have defined functional domains. We have cloned, over-expressed and purified the KcsA potassium channel to homogeneity and reconstituted this channel protein with phospholipids to form two-dimensional crystals. The crystals belong to plane group p4 and have unit cell dimensions of a=b=48 A. A projection map at 6 A resolution has been obtained by electron crystallography. The map shows that the protein is a homotetramer, having a low-density region on the 4-fold axis that is the site of the ion conduction pathway. Each monomer contains density features that are consistent with the molecular model of a truncated form of KcsA recently determined by X-ray crystallography.