RESUMEN
Using a tailored high triplet energy hole transport layer (HTL) is a suitable way to improve the efficiency and extend the lifetime of organic light-emitting devices (OLEDs), which can use all molecular excitons of singlets and triplets. In this study, dibenzofuran (DBF)-end-capped and spirobifluorene (SBF) core-based HTLs referred as TDBFSBF1 and TDBFSBF2 were effectively developed. TDBFSBF1 exhibited a high glass transition temperature of 178 °C and triplet energy of 2.5â eV. Moreover, a high external quantum efficiency of 22.0 %, long operational lifetime at 50 % of the initial luminance of 89,000â h, and low driving voltage at 1000â cd m-2 of 2.95â V were achieved in green phosphorescent OLEDs using TDBFSBF1. Further, a high-hole mobility µh value of 1.9×10-3 â cm2 V-1 s-1 was recorded in TDBFSBF2. A multiscale simulation successfully reproduced the experimental µh values and indicated that the reorganization energy was the primary factor in determining the mobility differences among these SBF core based HTLs.
RESUMEN
The weak stability of a hole-transporter upon approaching the anion state is one of the major bottlenecks for developing long-life organic light-emitting devices (OLEDs). Therefore, in this study, we developed a series of thermally and electrically stable hole-transporters that are end-capped with four dibenzofuran units. These materials exhibit i)â high bond dissociation energy (BDE) toward the anion state, ii)â a high glass transition temperature (Tg >130 °C), and iii)â high triplet energy (ET >2.7â eV), thereby enabling approximately 20 % high external quantum efficiency (EQE) and significantly prolonging the stability of both thermally activated delayed fluorescent (TADF) and phosphorescent OLEDs with an operation lifetime at 50 % (LT50 ) of 20 000-30 000â h at 1000â cd m-2 . In addition, investigating their structure-property relationship revealed that ionization potential (IP ), BDE, and Tg are critical prerequisites for the hole-transporter to prolong lifetime in OLEDs.
RESUMEN
With the remarkable improvement in the electrical and optical properties of organic light-emitting diodes (OLEDs) in recent years, the details of the higher-order structure of vacuum-deposited amorphous organic films and its formation mechanism need to be understood. In particular, to clarify the effect of the higher-order structure on the film properties, it is necessary to analyze the molecular aggregation states in the vacuum-deposited amorphous films. Toward their deep understanding, the higher-order structure and film properties have often been discussed with relation to the surface diffusion and structural relaxation of the molecules immediately after deposition on the film surface. However, the effect of the variety of conformers, which is specific to amorphous organic materials, on the thermal and electrical properties of the films has not been deeply discussed. In this study, we focused on three structural isomers of OLED materials and discuss the effect of the conformer distribution on the molecular aggregation states and thermal and electrical properties of the vacuum-deposited films. From their comparison, we found that the properties of the film composed of a relatively small number of stable conformers are superior to those of the other two films composed of relatively large numbers of stable conformers. This superiority originates from formation of aggregates of the same conformer, which become the starting points for crystallization when the film is heated. Our detailed comparison and discussion focusing on the variety of conformers will lead to a deeper understanding of the molecular aggregation states and physical properties of amorphous organic films.