RESUMEN
In this report, we present a prototype design of a quadrupole mass filter (QMF) with hyperbolic electrodes, fabricated at the University of Liverpool using digital light processing (DLP), a low-cost and lightweight 3D rapid prototyping (RP) technique. Experimental mass spectra are shown for H(2)(+), D(2)(+), and He(+) ions to provide proof of principle that the DLP mass filter is working as a mass analyzer in the low-mass range (1 to 10 amu). The performance of the DLP QMF has also been investigated for individual spectral peaks. Numerical simulations of the instrument were performed by coupling CPO and Liverpool QMS-2 programs to model both the ion source and mass filter, respectively, and the instrument is shown to perform as predicted by theory. DLP thus allows miniaturization of mass spectrometers at low cost, using hyperbolic (or other) geometries of mass analyzer electrodes that provide optimal ion manipulation and resolution for a given application. The potential of using RP fabrication techniques for developing miniature and microscale mass analyzers is also discussed.
RESUMEN
Improved fixation and increased longevity are still important performance criteria in the development of orthopaedic prostheses. The osseointegration of a series of implant designs made of conventional cobalt-chromium alloy was investigated, the shape of each implant being the critical variable. The shape was defined by computer-aided design with a view to maximising interdigitation of new bone with the implant. Two different process routes, conventional casting and selective laser sintering were employed, each process yielded implants that had identical surface topology but different microstructures. Hydroxyapatite (HA) was used to coat some samples by plasma spraying. Bone formation associated with each implant design was delineated through the administration of fluorescent vital dyes at three time points following their implantation into New Zealand white rabbits. After one month, specimens were harvested, resin embedded, serial sectioned and examined under fluorescent light microscopy. The amount of bone growth was quantified using image analysis. Plasma spray HA-coated samples promoted better osteogenesis and integration than uncoated samples. The extent of bone growth associated with identically shaped specimens fabricated by the SLS route was markedly greater, attributed to the microstructure of these implants.