RESUMEN
Given the rising popularity of robotics, student-driven robot development projects are playing a key role in attracting more people towards engineering and science studies. This article presents the early development process of an open-source mobile robot platform-named PlatypOUs-which can be remotely controlled via an electromyography (EMG) appliance using the MindRove brain-computer interface (BCI) headset as a sensor for the purpose of signal acquisition. The gathered bio-signals are classified by a Support Vector Machine (SVM) whose results are translated into motion commands for the mobile platform. Along with the physical mobile robot platform, a virtual environment was implemented using Gazebo (an open-source 3D robotic simulator) inside the Robot Operating System (ROS) framework, which has the same capabilities as the real-world device. This can be used for development and test purposes. The main goal of the PlatypOUs project is to create a tool for STEM education and extracurricular activities, particularly laboratory practices and demonstrations. With the physical robot, the aim is to improve awareness of STEM outside and beyond the scope of regular education programmes. It implies several disciplines, including system design, control engineering, mobile robotics and machine learning with several application aspects in each. Using the PlatypOUs platform and the simulator provides students and self-learners with a firsthand exercise, and teaches them to deal with complex engineering problems in a professional, yet intriguing way.
Asunto(s)
Interfaces Cerebro-Computador , Robótica , Electromiografía , Humanos , Robótica/métodos , Programas Informáticos , Máquina de Vectores de SoporteRESUMEN
An interlaboratory comparison for European radon calibration facilities was conducted to evaluate the establishment of a harmonized quality level for the activity concentration of radon in air and to demonstrate the performance of the facilities when calibrating measurement instruments for radon. Fifteen calibration facilities from 13 different European countries participated. They represented different levels in the metrological hierarchy: national metrology institutes and designated institutes, national authorities for radiation protection and participants from universities. The interlaboratory comparison was conducted by the German Federal Office for Radiation Protection (BfS) and took place from 2018 to 2020. Participants were requested to measure radon in atmospheres of their own facilities according to their own procedures and requirements for metrological traceability. A measurement device with suitable properties was used to determine the comparison values. The results of the comparison showed that the radon activity concentrations that were determined by European calibration facilities complying with metrological traceability requirements were consistent with each other and had common mean values. The deviations from these values were normally distributed. The range of variation of the common mean value was a measure of the degree of agreement between the participants. For exposures above 1000 Bq/m3, the variation was about 4% for a level of confidence of approximately 95% (k=2). For lower exposure levels, the variation increased to about 6%.
Asunto(s)
Contaminantes Radiactivos del Aire , Monitoreo de Radiación , Protección Radiológica , Radón , Contaminantes Radiactivos del Aire/análisis , Calibración , Humanos , Radón/análisisRESUMEN
Alterations of heart rate variability (HRV) are associated with various (patho)physiological conditions; therefore, HRV analysis has the potential to become a useful diagnostic module of wearable/telemedical devices to support remote cardiovascular/autonomic monitoring. Continuous pulse recordings obtained by photoplethysmography (PPG) can yield pulse rate variability (PRV) indices similar to HRV parameters; however, it is debated whether PRV/HRV parameters are interchangeable. In this study, we assessed the PRV analysis module of a digital arterial PPG-based telemedical system (SCN4ALL). We used Bland-Altman analysis to validate the SCN4ALL PRV algorithm to Kubios Premium software and to determine the agreements between PRV/HRV results calculated from 2-min long PPG and ECG captures recorded simultaneously in healthy individuals (n = 33) at rest and during the cold pressor test, and in diabetic patients (n = 12) at rest. We found an ideal agreement between SCN4ALL and Kubios outputs (bias < 2%). PRV and HRV parameters showed good agreements for interbeat intervals, SDNN, and RMSSD time-domain variables, for total spectral and low-frequency power (LF) frequency-domain variables, and for non-linear parameters in healthy subjects at rest and during cold pressor challenge. In diabetics, good agreements were observed for SDNN, LF, and SD2; and moderate agreement was observed for total power. In conclusion, the SCN4ALL PRV analysis module is a good alternative for HRV analysis for numerous conventional HRV parameters.
Asunto(s)
Fotopletismografía , Telemedicina , Sistema Nervioso Autónomo , Electrocardiografía , Frecuencia Cardíaca , HumanosRESUMEN
The results of the three years European Metrology Research Programme's (EMRP) joint research project 'Metrology for processing materials with high natural radioactivity' (MetroNORM) are presented. In this project, metrologically sound novel instruments and procedures for laboratory and in-situ NORM activity measurements have been developed. Additionally, standard reference materials and sources for traceable calibration and improved decay data of natural radionuclides have been established.
RESUMEN
From an anthropological point of view, artificial deformation of the cranial shape in newborns is one of the most interesting human customs, which has been recorded in all continents and in different cultures. However, the main goals of this procedure were basically the same everywhere; that is, to distinguish certain groups of people from others and to indicate the social status of individuals. In the Carpathian Basin all artificially deformed skulls are dated to the late Iron Age, especially to the early Migration Period. The authors examined 9 artificially deformed skulls from the Hun-Germanic Period (5th-6th century ad) excavated from two cemeteries in the northeastern part of the Great Hungarian Plain (Hungary). The extent and the type of the deformation as well as the technique were determined in each case. The authors also attempt to shed light on the probable origin and the historical context of the custom practiced in the Carpathian Basin (Hungary), relying on the anthropological and historical literature on the Hun-Germanic and preceding periods. It seems possible that this custom, which is associated with the finds in the Carpathian Basin, first appeared in the Kalmykia steppe, later in the Crimea, from where it spread to Central and Western Europe by way of the Hun migration. Neither the cranial find described presently nor the special literature on the subject furnish convincing evidence that the cranial deformation resulted in any chronic neurological disorder.