RESUMEN
In this paper, a nucleic acid dye-enhanced electrochemical biosensor based on a screen-printed carbon electrode (SPCE) modified with Au nanoparticles (AuNPs) was designed for the detection of Hg2+ in water. AuNPs were modified on the surface of the disposable SPCE through the electrodeposition of HAuCl4. Subsequently, thiolated DNA probes were immobilized on the AuNP-modified electrode surface by Au-S reaction. After Hg2+ was bound with a DNA probe by thymine (T)-Hg2+-thymine (T) mismatch, the DNA probe was folded into a hairpin structure where positively charged GelRed molecules were embedded into the double-stranded part of the hairpin. Thus, the current of [Fe(CN)6]3-/4- increased significantly on account of the decreased electrostatic repulsion at the electrode surface. Under the optimized experimental conditions, the peak current of [Fe(CN)6]3-/4- exhibited a good linear relationship with lgCHg2+ in the concentration of Hg2+ linear range of 0.1 nM to 500 nM, and the limit of detection (S/N = 3) was calculated as 0.04 nM. The electrochemical sensor also exhibited excellent selectivity for Hg2+ in the presence of nine interfering ions, including Na+, Fe3+, Ni2+, Mg2+, Co2+, Pb2+, K+, Al3+ and Cu2+. Meanwhile, the developed electrochemical sensor was tested in the analysis of Hg2+ in tap water and river water samples, and the recoveries ranged from 81.0 to 114%. Therefore, this nucleic acid dye-enhanced electrochemical biosensor provided the advantages of simplicity, sensitivity, and specificity and is expected to be an alternative for Hg2+ detection in actual environmental samples.
Asunto(s)
Técnicas Biosensibles , Mercurio , Nanopartículas del Metal , Ácidos Nucleicos , Carbono , Sondas de ADN/análisis , Sondas de ADN/química , Técnicas Electroquímicas , Electrodos , Oro/química , Iones , Plomo , Mercurio/análisis , Mercurio/química , Nanopartículas del Metal/química , Timina/química , Agua/análisisRESUMEN
An ultrasensitive 1O2-based electrochemical aptasensor by on-line assembly of photosensitizers using graphene oxide (GO) as a cartridge is reported. In the presence of target protein lysozyme, the interaction of lysozyme with aptamer led to the dissociation of dsDNA and release of the aptamer-lysozyme complex to solution, with DNA-c retaining on the electrode; then, the photosensitizer phloxine B (PB) was assembled on the electrode since GO can simultaneously adsorb DNA-c and PB molecules. Upon irradiation by a green LED, 1O2 was generated by photocatalysis of PB molecules and then cleaved the DNA-c, leading to remarkably decreased impedance signals that linearly respond with the logarithm of lysozyme concentration. Benefitting from the efficient photosensitization ability of PB and the high PB-loading capacity of GO, the developed sensor allowed determination of 0.001 to 100 nM lysozyme with a limit of detection of about 0.14 pM. The relative standard deviation (RSD) for five independent electrodes with 1 nM lysozyme was 3.1%, indicating satisfactory reproducibility. The sensor also showed excellent selectivity toward lysozyme in the presence of interfering substances and was applied to the determination of lysozyme in urine samples with recoveries ranging from 91 to 101%. The on-line assembly of photosensitizer technique opens a new way for amplified electrosensing of biomolecules. Graphical abstract An on-line assembly of photosensitizers and DNA on electrode was developed using graphene oxide a cartridge and the photocatalytic electrosensor can be used for label-free detection of lysozyme as low as 1 pM.
RESUMEN
The quantification of proteins is essential in fundamental research or clinical applications. Here, we developed a facile electrochemical aptasensor based on target-induced turn-off of photosensitization for label-free and ultrasensitive detection of protein (exemplified by lysozyme). EB (ethidium bromide) molecules that were embedded in dsDNA between lysozyme binding aptamer and complementary DNA immobilized on the electrode, could photo-cleave the dsDNA via singlet oxygen (O21) during photosensitization, resulting in a high voltammetry current of the [Fe(CN)6]3-/4-. Upon recognition of the lysozyme by aptamer, the EB molecules were released from dsDNA, and its photosensitization activity was turned off. As a result, more amount of complementary DNA was retained on the Au nanoparticles modified carbon nanotube paste electrode (AuNPs-CNPE), leading to a declined voltammetry current. Such a sensing strategy allowed detection of 10â¯pM-1⯵M lysozyme with a low detection limit (about 2â¯pM). Besides, the sensor was free of labeling procedure as well as extra signal amplification step, and the CNPE modification was quite simple, only with AuNPs. The sensor also showed excellent selectivity toward lysozyme in the presence of interfering proteins, such as thrombin, bovine serum albumin, myoglobin, etc. The proposed sensor was applied to the determination of lysozyme in urine samples with the recoveries ranging from 96.6% to 101%. The proposed biosensor holds a great promise in developing other electrochemical sensors based on photosensitization.