RESUMEN
Zambia's Kabwe mine wastes (KMWs) are responsible for contaminating the surrounding soil and dust in the Kabwe district. Unfortunately, these wastes arise from the historical mining activities of lead (Pb) and Zinc (Zn), which lacked adequate waste management strategies. As a result, potentially toxic elements (PTEs) (Pb and Zn) spread across the Kabwe district. To assess the soil pollution derived from previous mining activities, we studied topsoil samples (n = 8) from the school playground soils (SPs). In this study, the degree of contamination, geochemical partitioning, and leachability, coupled with the release and retention of Pb and Zn, were studied. The SPs were classified as extremely enriched (EF > 40) and contaminated with Pb (Igeo > 5). On average, Pb (up to 89%) and Zn (up to 69%) were bound with exchangeable, weak acid-soluble, reducible and oxidizable phases, which are considered as 'geochemically mobile' phases in the environment. The leachates from the soils (n = 5) exceeded the Zambian standard (ZS: 190:2010) for Pb in potable drinking water (Pb < 0.01 mg/L). Furthermore, the spatial distribution of Pb and Zn showed a significant reduction in contents of Pb and Zn with the distance from the mine area.
RESUMEN
This study evaluated the assumption that back-filled excavated areas of old mine workings can be modeled as porous media, where groundwater flow is governed by Darcy's law. The Yatani mine, located in Yamagata Prefecture, Japan, was selected for this study because several mining methods were used during its operation and detailed drawings of the excavated areas of the mine are available. The model was calibrated using combinations of hydraulic conductivities (k), with the best-matched case being selected by comparing calculated and measured AMD fluxes. Modeled AMD fluxes along the drainage tunnel (-2 L level) were consistent with measured data when the excavated areas were considered to be porous media with a specific hydraulic conductivity, and the presence of faults and permeability were taken into account. The model also successfully predicted the increasing trend of AMD flux from the shaft to adit mouth. In the numerical model, the back-filled excavated areas were assumed to behave as porous media, which was shown to be a valid assumption in this mine. The model demonstrated that back-filling the excavated areas and drainage tunnel with low permeability materials could reduce the flux of Zn in AMD by up to 61%.
Asunto(s)
Agua Subterránea , Contaminantes Químicos del Agua/análisis , MineríaRESUMEN
This paper describes the geochemistry of groundwater and its flow system in the closed Yatani mine in southern Yamagata Prefecture, Japan. The mine is located in a sulfide deposit containing pyrite and has been generating acid mine drainage (AMD). The study was intended to elucidate the formation of AMD and its flow patterns using geological, hydrological, geochemical, and isotopic techniques. The results indicate that AMD is formed by the interaction of groundwater with sulfide minerals, sand slime, and tailings back-filled into excavated mine areas. Groundwater recharge areas were identified on the mountain slope at an elevation of ~900â¯m. The formation of AMD in the drifts and shaft was more extensive than that in the deeper drainage levels. Principal component analysis was applied to the hydrogeochemical data to identify the causes of AMD formation. The first, second, and third principal components reveal that the increased ion concentrations in mine drainage are a result of water-mineral reactions in excavated mine areas, the contribution of groundwater in deep reductive environments, and isotopic fractionation during precipitation, respectively. A promising method of reducing AMD formation is to prevent contact between dissolved oxygen and sulfide minerals by increasing the drainage level or by filling the shallow underground excavated area with cementitious materials.