Soybean sorting based on protein content using X-ray fluorescence spectrometry.

The purpose of this research was to evaluate performance of an energy-dispersive X-ray fluorescence (XRF) sensor to classify soybean based on protein content. The hypothesis was that sulfur signals and other XRF spectral features can be used as proxies to infer soybean protein content. Sample preparation and equipment settings to optimize detection of S and other specific emission lines were tested for this application. A logistic regression model for classifying soybean as high- or low-protein was developed based on XRF spectra and protein contents. Additionally, the model was validated with an independent set of samples. Global accuracies of the method were 0.83 (training set) and 0.81 (test set) and the corresponding kappa indices were 0.66 and 0.61, respectively. These numbers indicated satisfactory performance of the sensor, suggesting that XRF spectral features can be applied for screening protein content in soybean.

Spectral data of tropical soils using dry-chemistry techniques (VNIR, XRF, and LIBS): A dataset for soil fertility prediction.

Proximal soil sensing technologies, such as visible and near infrared diffuse reflectance spectroscopy (VNIR), X-ray fluorescence spectroscopy (XRF), and laser-induced breakdown spectroscopy (LIBS), are dry-chemistry techniques that enable rapid and environmentally friendly soil fertility analyses. The application of XRF and LIBS sensors in an individual or combined manner for soil fertility prediction is quite recent, especially in tropical soils. The shared dataset presents spectral data of VNIR, XRF, and LIBS sensors, even as the characterization of key soil fertility attributes (clay, organic matter, cation exchange capacity, pH, base saturation, and exchangeable P, K, Ca, and Mg) of 102 soil samples. The samples were obtained from two Brazilian agricultural areas and have a wide variation of chemical and textural attributes. This is a pioneer dataset of tropical soils, with potential to be reused for comparative studies with other datasets, e.g., comparing the performance of sensors, instrumental conditions, and/or predictive models on different soil types, soil origin, concentration range, and agricultural practices. Moreover, it can also be applied to compose soil spectral libraries that use spectral data collected under similar instrumental conditions.

Combined Use of Vis-NIR and XRF Sensors for Tropical Soil Fertility Analysis: Assessing Different Data Fusion Approaches.

Visible and near infrared (vis-NIR) diffuse reflectance and X-ray fluorescence (XRF) sensors are promising proximal soil sensing (PSS) tools for predicting soil key fertility attributes. This work aimed at assessing the performance of the individual and combined use of vis-NIR and XRF sensors to predict clay, organic matter (OM), cation exchange capacity (CEC), pH, base saturation (V), and extractable (ex-) nutrients (ex-P, ex-K, ex-Ca, and ex-Mg) in Brazilian tropical soils. Individual models using the data of each sensor alone were calibrated using multiple linear regressions (MLR) for the XRF data, and partial least squares (PLS) regressions for the vis-NIR data. Six data fusion approaches were evaluated and compared against individual models using relative improvement (RI). The data fusion approaches included (i) two spectra fusion approaches, which simply combined the data of both sensors in a merged dataset, followed by support vector machine (SF-SVM) and PLS (SF-PLS) regression analysis; (ii) two model averaging approaches using the Granger and Ramanathan (GR) method; and (iii) two data fusion methods based on least squares (LS) modeling. For the GR and LS approaches, two different combinations of inputs were used for MLR. The GR2 and LS2 used the prediction of individual sensors, whereas the GR3 and LS3 used the individual sensors prediction plus the SF-PLS prediction. The individual vis-NIR models showed the best results for clay and OM prediction (RPD ≥ 2.61), while the individual XRF models exhibited the best predictive models for CEC, V, ex-K, ex-Ca, and ex-Mg (RPD ≥ 2.57). For eight out of nine soil attributes studied (clay, CEC, pH, V, ex-P, ex-K, ex-Ca, and ex-Mg), the combined use of vis-NIR and XRF sensors using at least one of the six data fusion approaches improved the accuracy of the predictions (with RI ranging from 1 to 21%). In general, the LS3 model averaging approach stood out as the data fusion method with the greatest number of attributes with positive RI (six attributes; namely, clay, CEC, pH, ex-P, ex-K, and ex-Mg). Meanwhile, no single approach was capable of exploiting the synergism between sensors for all attributes of interest, suggesting that the selection of the best data fusion approach should be attribute-specific. The results presented in this work evidenced the complementarity of XRF and vis-NIR sensors to predict fertility attributes in tropical soils, and encourage further research to find a generalized method of data fusion of both sensors data.

Effects of storage on vis-NIR-SWIR reflectance spectra of Mombasa grass leaf samples / Efeitos do armazenamento no espectro de reflectância vis-NIR-SWIR de amostras foliares de capim Mombaça

ABSTRACT: Vis-NIR-SWIR reflectance spectra of leaf samples, collected in the laboratory, allow the calibration of predictive models to quantify their physicochemical attributes in a practical manner and without producing chemical residues. This technique should enable the development of management strategies for intensification of pasture use. However, spectral analysis performed in the laboratory may be affected by the deterioration of plant material during transport from the field to the lab, so storage methods are necessary. This research aimed to evaluate the effects of different storage methods on the spectral response of Mombasa grass leaves. Three methods were evaluated: (i) artificially refrigerated environment, (ii) humid environment, and (iii) without microenvironment control. These methods were tested in five different storage times: 2 hours, 4 hours, 8 hours, 24 hours and 48 hours. The spectral behavior of the leaves still inserted in the plant was used as a quality reference. Results showed notable changes at the earliest storage time for the treatment without microenvironment control. Both methods with microenvironment control stabilized the occurrence of spectral changes over 48 hours of the samples storage, thus both were suggested for this species.

RESUMO: Espectros de reflectância vis-NIR-SWIR de amostras foliares, coletados em laboratório, permitem a calibração de modelos preditivos para quantificação de seus atributos físico-químicos de maneira prática e sem produção de resíduos químicos. Esta técnica permite o desenvolvimento de estratégias de manejo para a intensificação do uso de pastagens. Contudo, análises espectrais realizadas em laboratório podem ser afetadas pela deterioração do material vegetal durante o transporte do campo ao laboratório, fazendo-se necessário a utilização de métodos de armazenamento. O presente trabalho objetivou avaliar o efeito de diferentes métodos de armazenamento na resposta espectral de folhas de capim Mombaça. Avaliou-se três métodos: (i) ambiente refrigerado artificialmente; (ii) ambiente úmido; e (iii) ao ar livre, sem controle do microambiente; assim como, cinco diferentes tempos de armazenamento: 2 horas, 4 horas, 8 horas, 24 horas e 48 horas. O comportamento espectral das folhas ainda inseridas na planta foi utilizado como referência de qualidade. Os resultados mostraram alterações pronunciadas para o armazenamento ao ar livre já nos primeiros intervalos de tempo. Ambos métodos com controle de microambiente permitiram estabilizar a ocorrência de alterações espectrais ao longo das 48h de armazenamento das amostras, sendo ambos sugeridos para esta espécie.

Simplifying Sample Preparation for Soil Fertility Analysis by X-ray Fluorescence Spectrometry.

Portable X-ray fluorescence (pXRF) sensors allow one to collect digital data in a practical and environmentally friendly way, as a complementary method to traditional laboratory analyses. This work aimed to assess the performance of a pXRF sensor to predict exchangeable nutrients in soil samples by using two contrasting strategies of sample preparation: pressed pellets and loose powder (<2 mm). Pellets were prepared using soil and a cellulose binder at 10% w w-1 followed by grinding for 20 min. Sample homogeneity was probed by X-ray fluorescence microanalysis. Exchangeable nutrients were assessed by pXRF furnished with a Rh X-ray tube and silicon drift detector. The calibration models were obtained using 58 soil samples and leave-one-out cross-validation. The predictive capabilities of the models were appropriate for both exchangeable K (ex-K) and Ca (ex-Ca) determinations with R2 ≥ 0.76 and RPIQ > 2.5. Although XRF analysis of pressed pellets allowed a slight gain in performance over loose powder samples for the prediction of ex-K and ex-Ca, satisfactory performances were also obtained with loose powders, which require minimal sample preparation. The prediction models with local samples showed promising results and encourage more detailed investigations for the application of pXRF in tropical soils.