RESUMEN
Generating energetic, few-cycle laser pulses with stabilized carrier-envelope phase at a high-repetition rate constitutes a first step to access the ultra-fast dynamics underlying the interaction of matter with intense, ultrashort pulses in attosecond science or high-field physics. We present here a Ti:Sa-based 1 kHz TW-class laser delivering 17.8 fs pulses with 350 mrad shot-to-shot CEP noise based on an original 10 kHz front-end design. In parallel to this short pulse duration operation mode, it is possible to tune the output wavelength of the front end within a 90 nm range around 800 nm.
RESUMEN
We present a compact 10 kHz Ti:Sa front end relying on an original double-crystal regenerative amplifier design. This new configuration optimizes the thermal heat load management, allowing the production of a 110 nm large spectrum and maintaining a good beam profile quality. The front end delivers up to 5 W after compression, 17 fs pulses with a 170 mrad shot-to-shot residual carrier-envelope phase noise.
RESUMEN
The interaction of laser pulses with thin grating targets, having a periodic groove at the irradiated surface, is experimentally investigated. Ultrahigh contrast (~10(12)) pulses allow us to demonstrate an enhanced laser-target coupling for the first time in the relativistic regime of ultrahigh intensity >10(19) W/cm(2). A maximum increase by a factor of 2.5 of the cutoff energy of protons produced by target normal sheath acceleration is observed with respect to plane targets, around the incidence angle expected for the resonant excitation of surface waves. A significant enhancement is also observed for small angles of incidence, out of resonance.
RESUMEN
In this work we demonstrate the development of a complete analog feedback loop for the control of the carrier-envelope phase (CEP) of a high-average power (20 W) laser operating at 10 kHz repetition rate. The proposed method combines a detection scheme working on a single-shot basis at the full-repetition-rate of the laser system with a fast actuator based either on an acousto-optic or on an electro-optic crystal. The feedback loop is used to correct the CEP fluctuations introduced by the amplification process demonstrating a CEP residual noise of 320 mrad measured on a single-shot basis. The comparison with a feedback loop operating at a lower sampling rate indicates an improvement up to 45% in the residual noise. The measurement of the CEP drift for different integration times clearly evidences the importance of the single-shot characterization of the residual CEP drift. The demonstrated scheme could be efficiently applied for systems approaching the 100 kHz repetition rate regime.
RESUMEN
Using an original CEP stabilization technique based on the linear electro-optical effect in a specific crystal, we achieved long term CEP stabilization of a 20 W, 1 kHz laser with residual noise as low as 440 mrad (rms). At 3 W, the CEP shot to shot noise is kept as low as 320 mrad (rms) over half an hour.
RESUMEN
We present a new method to control the Carrier-Envelope Phase of ultra-short laser pulses by using the linear Electro-Optic Effect. Experimental demonstration is carried out on a Chirped Pulse Amplification based laser. Phase shifts greater than π radian can be obtained by applying moderate voltage on a LiNbO3 crystal with practically no changes to all other parameters of the pulse with the exception of its group delay. Time response of the Electro-Optic effect makes possible shaping at a high repetition rate or stabilization of the CEP of ultra short CPA laser systems.
