Monitoring of cyanotoxins in water from hypersaline microalgae colonies by ultra high performance liquid chromatography with diode array and tandem mass spectrometry detection following salting-out liquid-liquid extraction.

In this study two different analytical approaches have been developed to determine the presence of several cyanotoxins in saline water samples from a continental salt marsh. A salting-out assisted liquid-liquid extraction (SALLE) has been used in combination with ultra-high performance liquid chromatography-tandem mass spectrometry and UV-diode array detection (UHPLC-MS/MS and UHPLC-DAD). The target analytes are eight microcystins named MC-RR, MC-YR, MC-LR, MC-WR, MC-LA, MC-LY, MC-LW, MC-LF and nodularin (NOD), covering a wide range of polarities. The separation was achieved using a Zorbax Eclipse Plus RRHD C18 column (50 × 2.1 mm, 1.8 µm) in less than 7.5 and 5.5 min for UV and MS/MS detection, respectively. The mobile phase used consisted of water (solvent A) and acetonitrile (MeCN) (solvent B), both containing 0.01% of formic acid for DAD and 0.4% of formic acid for MS/MS detection, at a flow rate of 0.4 mL min-1. The temperature of the column was set at 25 °C and 20 µL of sample were injected. The main parameters affecting the SALLE procedure were studied and the following optimum values were obtained: neutral pH, 2 mL of acetonitrile as extraction solvent and 1.2 g of ammonium sulfate as salting-out agent for 4 mL of water sample. The validation protocols for both methods were accomplished with real water samples obtaining LODs ranging from 1.0 to 3.4 µg L-1 and 0.02 to 0.11 µg L-1 for DAD and MS/MS respectively. Although the SALLE-UHPLC-DAD methodology is easier and cheaper than UHPLC-MS/MS significantly better detection limits were achieved with tandem mass spectrometry as well as allowing for unambiguous identification. Extraction recoveries were higher than 77.0% (except for MC-RR and NOD which were 53.2% and 54.3, respectively) with satisfactory inter-day and intra-day precisions (RSD below 13.3%).

Collision cross section (CCS) as a complementary parameter to characterize human and veterinary drugs.

In the context of human and veterinary drugs identification, ion mobility spectrometry (IMS) in combination with mass spectrometry (MS) may provide a relevant complementary piece of information to mass-to-charge ratio (m/z), the so-called collision-cross-section (CCS). Up to now, however, the application of CCS as identification parameter has not been fully investigated due to the reduced number of these drugs that have being characterized in terms of CCS. This work proposes a CCS database for 92 human and veterinary drugs, including eighteen benzimidazoles, eleven 5-nitroimidazoles, eleven aminoglycosides, nineteen quinolones, eighteen ß-lactams, ten sulfonamides and five tetracyclines. Among them, 37 drugs have been characterized in terms of CCS for the first time. The CCS values of the other 55 compounds have been compared with those from a recently published database in order to evaluate inter-laboratory reproducibility, which is crucial for the implementation of the CCS as identification parameter. CCS values were measured by traveling wave ion mobility spectrometry (TWIMS) under positive ionization conditions. Nitrogen was used as drift gas in the ion mobility cell. The proposed database covers 173 ions including [M+H]+ and [M+Na]+ species. High correlation between m/z and CCS has been observed for [M+H]+ (R2 = 0.9518, n = 91) and [M+Na]+ (R2 = 0.9135, n = 82) ions. As expected, CCS values for sodium adducts are generally greater than for protonated molecules because they exhibit higher molecular weight. However, sodium adducts of aminoglycosides, ß-lactams, and of several quinolones and benzimidazoles, were characterized as more compact ions than their related protonated molecule. In addition, this work describes the fragmentation pattern observed for the studied molecules. For the first time, the main fragment ions for most of the compounds have also been characterized in terms of CCS, involving a total of 238 ions. As proof of concept, for the application of this database to biological matrices, eleven veterinary drugs in bovine urine samples were characterized in terms of CCS, showing that this parameter was not influenced by the matrix.

Green and simple analytical method to determine benzimidazoles in milk samples by using salting-out assisted liquid-liquid extraction and capillary liquid chromatography.

A green and simple multiresidue method using capillary liquid chromatography (CLC) with UV-diode array detection (DAD) has been developed for the determination of sixteen benzimidazoles (BZs) and its metabolites in milk samples. The separation was achieved in <32 min, using a Zorbax XDB-C18 column (150 mm × 0.5 mm I.D, 5 µm), with a mobile phase consisting of 50 mM ammonium acetate (solvent A) and a mixture of acetonitrile/methanol (1:1 v/v) (solvent B), at a flow rate of 9 µL min-1. The temperature of the column was 20 °C and 6 µL of sample were injected. In spite of the complexity of milk samples, an effective, simple and fast sample preparation method called salting out-assisted liquid-liquid extraction (SALLE) was developed for the analysis of these compounds in cow milk samples. To obtain satisfactory extraction efficiencies for the studied analytes, several parameters affecting the SALLE procedure were optimized including the amount of sample, type and volume of the extraction solvent, and the nature and amount of the salt. Good linearity was obtained (R2 > 0.9985 for all BZs) with limits of detection (LOD) between 1.0 and 2.8 µg kg-1. Relative standard deviations of repeatability and intermediate precision were below 1.6 and 14.2%, respectively. Satisfactory recoveries between 79.1 and 99.6% were also obtained for three types of milk samples (cow, sheep and goat). The advantages of a miniaturized technique such as CLC in terms of better efficiencies and reduced solvent consumption, combined with the simplicity of the SALLE procedure, make this method a useful alternative for the monitoring of these residues at trace level.

Ultra-high performance liquid chromatography with fluorescence detection following salting-out assisted liquid-liquid extraction for the analysis of benzimidazole residues in farm fish samples.

Ultra-high performance liquid chromatography (UHPLC) coupled with fluorescence detection (FL) has been proposed for the first time to determine thirteen benzimidazoles (BZs) in farmed fish samples. In order to optimize the chromatographic separation, parameters such as mobile phase composition and flow rate were carefully studied, establishing a gradient mode with a mobile phase consisted of water (solvent A) and acetonitrile (solvent B) at a flow rate of 0.4 mL/min. The separation was performed on a Zorbax Eclipse Plus RRHD C18 column (50 × 2.1 mm, 1.8 µm), involving a total analysis time lower than 12 min. Salting-out assisted liquid-liquid extraction (SALLE) was applied as sample treatment to different types of farmed fish (trout, sea bream and sea bass). To obtain satisfactory extraction efficiencies for the studied analytes, several parameters affecting the SALLE procedure were optimized including the amount of sample, type and volume of the extraction solvent, and the nature and amount of the salt used. Characterization of the method in terms of performance characteristics was carried out, obtaining satisfactory results for the linearity (R2 ≥ 0.997), repeatability (RSD ≤ 6.1%), reproducibility (RSD ≤ 10.8%) and recoveries (R ≥ 79%; RSD ≤ 7.8%). Detection limits between 0.04-29.9 µg kg-1 were obtained, demonstrating the applicability of this fast, simple and environmentally friendly method.

Coupling sweeping-micellar electrokinetic chromatography with tandem mass spectrometry for the therapeutic monitoring of benzimidazoles in animal urine by dilute and shoot.

A new method based on micellar electrokinetic chromatography-tandem mass spectrometry (MEKC-MS/MS) has been developed for the identification and simultaneous quantification of thirteen benzimidazoles in animal urine. In order to obtain an appropriate separation with the highest sensitivity, different electrophoretic parameters were evaluated. Under optimum conditions, the separation was performed using ammonium perfluorooctanoate as volatile surfactant and electrophoretic buffer (50mM, pH 9). To increase the sensitivity, a stacking mode named sweeping was applied, using water as injection solvent at 50mbar for 75s, obtaining sensitivity enhancement factors from 50 to 181. The method was applied to different animal urine samples, including sheep, cow and goat. The sample treatment consisted of a 1:10 (v/v) dilution with water. Calibration using sheep urine samples can be used for both goat and cow urine samples with a relative bias below 25% and relative standard deviations lower than 8%. The limits of detection were below 70µgL-1. As a result, the applicability of this rapid, simple, sensitive, and environmentally friendly method for therapeutic drug monitoring of benzimidazoles based on the analysis of animal urine has been demonstrated.

Determination of benzimidazoles in meat samples by capillary zone electrophoresis tandem mass spectrometry following dispersive liquid-liquid microextraction.

A novel method based on capillary zone electrophoresis-tandem mass spectrometry has been proposed and validated for the identification and simultaneous quantification of twelve benzimidazoles in meat samples. Electrophoretic separation was carried out using 500mM formic acid (pH 2.2) as background electrolyte and applying a voltage of 25kV at 25°C. In order to improve the sensitivity, stacking mode injection was applied, using as injection solvent a mixture of 30:70 acetonitrile/water at 50mbar for 75s. Sensitivity enhancement factors from 74 to 317 were obtained under these conditions. Detection using an ion trap as analyzer, operating in multiple reactions monitoring mode was employed. The main MS/MS parameters as well as the composition of the sheath liquid and other electrospray variables were optimized in order to obtain the highest sensitivity and precision in conjunction with an unequivocal identification. The method was applied to poultry and pork muscle samples. The deproteinization of samples and extraction of benzimidazoles was carried out with acetonitrile. MgSO4 and NaCl were added as salting-out agents. Subsequently, dispersive liquid-liquid microextraction was applied as clean up procedure. The organic layer (acetonitrile, used as dispersant) containing the benzimidazoles was mixed with the extractant (chloroform) and both were injected in water, producing a cloudy solution. Recoveries for fortified samples were higher than 70%, with relative standard deviations lower than 16% were obtained in all cases. The limits of detection were below 3µgkg-1, demonstrating the applicability of this fast, simple, and environmentally friendly method.

Capillary electrochromatography coupled with dispersive liquid-liquid microextraction for the analysis of benzimidazole residues in water samples.

A novel method for the analysis of benzimidazole residues in water samples by capillary electrochromatography-UV detection (290nm), using laboratory-made packed columns is presented. Capillaries (25cm packed length×75µm inner diameter, 34cm total length, 25.5cm effective capillary length) were packed with C18 particles (5µm, non-encapped) following a high pressure packing procedure and using a compact steel unit designed for packing capillary columns. Acetone was employed as solvent to carry the particles through the capillary and pack it under a pressure of 42MPa. Outlet and inlet frits were made by sintering the particles of the stationary phase by heating the packed material with a nichrome ribbon connected to a 7V AC power supply. With the aim of achieving a good analytical performance, the variables that affected the separation were studied, using a mobile phase composition of 60:40 (v/v) acetonitrile/water containing ammonium acetate (1mM, pH 6.5), a separation voltage of 25kV and a temperature of 25°C. In addition, a combined hydrodynamic-electrokinetic injection mode was considered and samples were injected for 75s under a voltage of 12.5kV and a pressure of 11.5bar. Finally, the determination of benzimidazoles in water samples was accomplished by capillary electrochromatography using dispersive liquid-liquid microextraction as sample treatment. Variables affecting the extraction efficiency were optimized, using chloroform and ethanol as extraction and disperser solvents, respectively. This method was applied to different water samples, obtaining satisfactory results in terms of linearity (R2≥0.990), repeatability (RSD≤1.2%), reproducibility (RSD≤2.2%) and trueness (R≥87.7%). Detection and quantification limits were lower than 2.8µgL-1 and 9.3µgL-1, respectively.

Use of an ionic liquid-based surfactant as pseudostationary phase in the analysis of carbamates by micellar electrokinetic chromatography.

The applicability of an ionic liquid-based cationic surfactant 1-dodecyl-3-methyl-imidazolium tetrafluoroborate (C12 MImBF4 ) as pseudostationary phase in MEKC has been evaluated for the analysis of 11 carbamate pesticides (promecarb, carbofuran, metolcarb, fenobucarb, aldicarb, propoxur, asulam, benomyl, carbendazim, ethiofencarb, isoprocarb) in juice samples. Under optimum conditions (separation buffer, 35 mM NaHCO3 and 20 mM C12 MImBF4 , pH 9.0; capillary temperature 25°C; voltage -22 kV) the analysis was carried out in less than 12 min, using hydrodynamic injection (50 mbar for 7.5 s) and detection at 200 nm. For the extraction of these CRBs from juice samples, a dispersive liquid-liquid microextraction (DLLME) procedure has been proposed, by optimization of variables affecting the efficiency of the extraction. Following this treatment, sample throughput was approximately 12 samples per hour, obtaining a preconcentration factor of 20. Matrix-matched calibration curves were established using tomato juice as representative matrix (from 5 to 250 µg/L for CBZ, BY, PX, CF, FEN, ETH, ISP, and 25-250 µg/L for ASL, ALD, PRC, MTL), obtaining quantification limits ranging from 1 to 18 µg/L and recoveries from 70 to 96%, with RSDs lower than 9%.