RESUMEN
As the plasma beta (ß) increases in high-performance tokamaks, electromagnetic turbulence becomes more significant, potentially constraining their operational range. To investigate this turbulence, a cross-polarization scattering (CPS) diagnostic system is being developed on the HL-3 tokamak for simultaneous measurements of density and magnetic fluctuations. In this work, a quasi-optical system has been designed and analyzed for the Q-band CPS diagnostic. The system includes a lens group for beam waist size optimization, a rotatable wire-grid polarizer for polarization adjustment, and a reflector group for measurement range regulation and system response enhancement. Laboratory tests demonstrated a beam radius of order 4 cm at the target measurement location (near the plasma pedestal), cross-polarization isolation exceeding 30 dB, and poloidal and toroidal angle adjustment ranges of ±40° and ±15°, respectively. These results verify the system's feasibility through laboratory evaluations. The quasi-optical system has been installed on the HL-3 tokamak during the 2023 experimental campaign to support the development of CPS diagnostics.
RESUMEN
Plasma Position Reflectometry (PPR) is planned to provide plasma position and shape information for plasma operation in future fusion reactors. Its primary function is to calibrate the drift of the magnetic signals due to the integral nature of magnetic measurement. Here, we attempt to measure plasma position using ordinary mode (O-mode) and extraordinary mode (X-mode) reflectometry systems on two tokamaks. A new physical model based on the phase shift is proposed to deduce the relative movement of the cut-off layer without density inversion. We demonstrate the plasma position measurements by absolute measurement from density profile inversion and relative measurement from phase shift. The combination of X-mode and O-mode reflectometers can minimize the limitations of single polarization reflectometry and further increase the accuracy of plasma position measurement. These results could provide an important technical basis for the further development of a real-time control system based on PPR.
RESUMEN
A 105 GHz collective Thomson scattering (CTS) diagnostic has been successfully developed for fast-ion measurements on the HL-2A tokamak, and it has been deployed during an experimental campaign. Enhanced signals exhibiting synchronous modulation characteristics have been observed across all CTS channels upon the launch of a modulated probe wave. Results show that the intensity of the CTS signal increases with Neutral Beam Injection (NBI) power and is proportional to neutron count, indicating that the scattering signal contains a contribution from fast ions. Compared with the signal without NBI, the enhanced scattering spectrum due to NBI is slightly wider than the predicted fast ion range. Such broadening might be attributed to the heating effects of the gyrotron.
RESUMEN
A synthetic electron cyclotron emission (ECE) diagnostic is used to interpret ECE signals from preset plasma equilibrium profiles, including magnetic field, electron density, and electron temperature. According to the simulation results, the electron temperature (Te) profile covering the harmonic overlap region can be obtained by receiving ECE signals at the high field side (HFS) of the HL-2M plasma. The third harmonic ECE at the low field side (LFS) cannot pass through the second harmonic resonance layer at the HFS unless the optical thickness (τ) of the second harmonic becomes gray (τ ≤ 2). In addition, the impact of the relativistic frequency down-shift has been evaluated and corrected. The measurable range of the HFS ECE has been calculated by scanning different parameters (electron density, temperature, and magnetic field). Higher plasma parameters allow a wider radial range of electron temperature measurements. The minimum inner measurable position can reach R = 120 cm (r/a = -0.89) when the product of core temperature (Te0) and density (ne0) is greater than 35 × 1019 keV m-3, which is extended by more than 30 cm inward compared with that of the LFS measurement. The HFS ECE will greatly improve the diagnostic ability of ECE systems on the HL-2M tokamak.
RESUMEN
A solid state terahertz interferometer has been developed on the recent commissioned HL-2M tokamak. It can work in a wide frequency region of 220-325 GHz, and the terahertz wave is generated from a low frequency phase locked voltage controlled oscillator with the frequency multiplying technique. A phase processor based on field programmable gate array (FPGA) technology is designed for the heterodyne interferometer, and it contributes to real-time display of electron density. To extract phase information, a novel numerical algorithm related to fast Fourier transform is written on the FPGA chip and enables one to obtain phase shift without being affected by amplitude variation induced by plasma absorption or frequency modulation from the outer electromagnetic environment. The interferometer achieves minimum measurable electron density in the order of 1016 m-3. With the plasma diagnosis, electron density and low frequency tearing mode have been measured during the first experimental campaign.
RESUMEN
Remote control of the diagnostic systems is the basic requirement for the high performance plasma operation in a fusion device. This work presents the development of the remote control system for the multichannel Doppler backward scattering (DBS) reflectometers. It includes a remote controlled quasi-optical system and a remote intermediate frequency (IF) amplifier gain control system. The quasi-optical system contains a rotational polarizer, its polarization angle is tunable through a remote controlled motor, and it could combine the microwave beams with a wide frequency range into one focused beam. The remote IF gain control system utilizes the digital microcontroller (MCU) technique to regulate the signal amplitude for each signal channel. The gain parameters of amplifiers are adjustable, and the feedback of working status in the IF system will be sent to MCU in real time for safe operation. The gain parameters could be controlled either by the Ethernet remote way or directly through the local control interface on the system. Preliminary experimental results show the effectiveness of the remote controlled multichannel DBS system.
RESUMEN
Disruptions have the potential to cause severe damage to large tokamaks like ITER. The mitigation of disruption damage is one of the essential issues for the tokamak. Massive gas injection (MGI) is a technique in which large amounts of a noble gas are injected into the plasma in order to safely radiate the plasma energy evenly over the entire plasma-facing wall. However, the radiated energy during the disruption triggered by massive gas injection is found to be toroidally asymmetric. In order to investigate the spatial and temporal structures of the radiation asymmetry, the radiated power diagnostics for the J-TEXT tokamak have been upgraded. The multi-channel arrays of absolute extreme ultraviolet photodiodes have been upgraded at four different toroidal positions to investigate the radiation asymmetries during massive gas injection. It is found that the toroidal asymmetry is associated with plasma properties and MGI induced MHD activities.
RESUMEN
Fast electron bremsstrahlung (FEB) emission during Ohmic discharge experiments on the Joint Texas Experimental Tokamak (J-TEXT) has been measured by a recently developed vertical multi-channel FEB diagnostic based on CdZnTe detectors. There are 5 sight lines to observe the vertical emission of fast electrons at the high-field side with a spatial resolution of 5 cm. The FEB emission in the energy range of 30-300 keV can be measured. The generation of fast electrons accelerated by loop voltage has been confirmed during the early phase of discharge by analyzing the signals of FEB emission. The runaway electron beam instabilities have been observed with the FEB diagnostic on J-TEXT.
RESUMEN
Disruptions have the possibility of causing severe wall damage to large tokamaks like ITER. The mitigation of disruption damage is essential to the safe operation of a large-scale tokamak. The shattered pellet injection (SPI) technique, which is regarded as the primary injection method for ITER, presents several advantages relative to massive gas injection, including more rapid particle delivery, higher total particle assimilation, and more centrally peaked particle deposition. A dedicated argon SPI system that focuses on disruption mitigation and runaway current dissipation has been designed for the Joint Texas Experimental Tokamak (J-TEXT). A refrigerator is used to form a single argon pellet at around 64 K. The pellet will be shaped with a 5 mm diameter and a 1.5-10 mm length. Helium gas at room temperature will be used as a propellant gas for pellet acceleration. The pellet can be injected with a speed of 150-300 m/s. The time interval between injection cycles is about 8 min. The pellet will be shattered at the edge of the plasma and then injected into the core of plasma. The first experiments of SPI fast shutdown and runaway current dissipation have been performed.
RESUMEN
An x-ray imaging crystal spectrometer has been developed on joint Texas experimental tokamak for the measurement of electron and ion temperatures from the Kα spectra of helium-like argon and its satellite lines. A two-dimensional multi-wire proportional counter has been applied to detect the spectra. The electron and ion temperatures have been obtained from the Voigt fitting with the spectra of helium-like argon ions. The profiles of electron and ion temperatures show the dependence on electron density in ohmic plasmas.
RESUMEN
The measurement of internal magnetic fluctuation is important for the study of transport in tokamak plasmas. The runaway electron transport induced by the sawtooth crash can be used to obtain the internal magnetic fluctuation. Inversed sawtooth-like activities on hard x-ray (HXR) fluxes following sawtooth activities were observed after the application of electrode biasing on J-TEXT tokamak. The runaway diffusion coefficient Dr is deduced to be about 30 m2/s according to the time delay of HXR flux peaks to the sawtooth crashes. The averaged value of normalized magnetic fluctuation in the discharges with electrode biasing was increased to the order of 1 × 10-4.
RESUMEN
When the energy of confined runaway electrons approaches several tens of MeV, the runaway electrons can emit synchrotron radiation in the range of infrared wavelength. An infrared camera working in the wavelength of 3-5 µm has been developed to study the runaway electrons in the Joint Texas Experimental Tokamak (J-TEXT). The camera is located in the equatorial plane looking tangentially into the direction of electron approach. The runaway electron beam inside the plasma has been observed at the flattop phase. With a fast acquisition of the camera, the behavior of runaway electron beam has been observed directly during the runaway current plateau following the massive gas injection triggered disruptions.
RESUMEN
A spatially distributed hard X-ray detection array has been developed to diagnose the loss of runaway electron with toroidal and poloidal resolution. The hard X-ray radiation in the energy ranges of 0.3-1 MeV resulted from runaway electrons can be measured. The detection array consists of 12 CdTe detectors which are arranged surrounding the tokamak. It is found that most runaway electrons which transport to plasma boundary tend to loss on limiters. The application of electrode biasing probe resulted in enhancement of local runaway loss. Resonant magnetic perturbations enhanced the runaway electrons diffusion and showed an asymmetric poloidal loss rate.
RESUMEN
In order to mitigate the negative effects of the plasma disruption a massive gas injection (MGI) valve is designed for the joint Texas experimental tokamak. The MGI valve is based on the eddy-current repulsion mechanism. It has a fueling volume of 30 ml. The piston of the MGI valve is made by non-ferromagnetic material, so it can be installed close to the vacuum vessel which has a strong toroidal magnetic field. A diode is use to prevent current oscillation in the discharge circuit. The drive coil of the valve is installed outside the gas chamber. The opening characteristics and the gas flow of the MGI valve have been tested by a 60 l vacuum chamber. Owing to the large electromagnetic force the reaction time of the valve is shorter than 0.3 ms. Duration for the opening of the MGI valve is in the order of 10 ms.
RESUMEN
This paper presents the upgraded x-ray imaging crystal spectrometer (XICS) system on Joint Texas Experimental Tokamak (J-TEXT) tokamak and the latest experimental results obtained in last campaign. With 500 Hz frame rate of the new Pilatus detector and 5 cm × 10 cm spherically bent crystal, the XICS system can provide core electron temperature (Te), core ion temperature (Ti), and plasma toroidal rotation (VΦ) with a maximum temporal resolution of 2 ms for J-TEXT pure ohmic plasmas. These parameters with high temporal resolution are very useful in tokamak plasma research, especially for rapidly changed physical processes. The experimental results from the upgraded XICS system are presented.