RESUMEN
Fungal proliferation can lead to adverse effects for human health, due to the production of pathogenic and allergenic toxins and also through the creation of fungal biofilms on sensitive surfaces (i.e., medical equipment). On top of that, food spoilage from fungal activity is a major issue, with food losses exceeding 30% annually. In this study, the effect of the surface micro- and nanotopography, material (aluminum, Al, and poly(methyl methacrylate), PMMA), and wettability against Aspergillus awamori is investigated. The fungal activity is monitored using dynamic conditions by immersing the surfaces inside fungal spore-containing suspensions and measuring the fungal biomass growth, while the surfaces with the optimum antifungal properties are also evaluated by placing them near spore suspensions of A. awamori on agar plates. Al- and PMMA-based superhydrophobic surfaces demonstrate a passive-like antifungal profile, and the fungal growth is significantly reduced (1.6-2.2 times lower biomass). On the other hand, superhydrophilic PMMA surfaces enhance fungal proliferation, resulting in a 2.6 times higher fungal total dry weight. In addition, superhydrophobic surfaces of both materials exhibit antifouling and antiadhesive properties, whereas both superhydrophobic surfaces also create an "inhibition" zone against the growth of A. awamori when tested on agar plates.
Asunto(s)
Aspergillus , Materiales Biocompatibles , Ensayo de Materiales , Tamaño de la Partícula , Propiedades de Superficie , Humectabilidad , Materiales Biocompatibles/química , Materiales Biocompatibles/farmacología , Antifúngicos/farmacología , Antifúngicos/química , Polimetil Metacrilato/química , Polimetil Metacrilato/farmacología , Proliferación Celular/efectos de los fármacosRESUMEN
The valorization of renewable feedstock to produce a plethora of value-added products could promote the transition towards a circular bioeconomy. This study presents the development of cascade processes to bioconvert spent coffee grounds (SCGs) into microbial oil and carotenoids employing sustainable practices. The stepwise recovery of crude phenolic extract and coffee oil was carried out using green or recyclable solvents, i.e., aqueous ethanol and hexane. Palmitic acid (43.3%) and linoleic acid (38.9%) were the major fatty acids in the oil fraction of SCGs. The LC-MS analysis of crude phenolic extracts revealed that chlorogenic acid dominated (45.7%), while neochlorogenic acid was also detected in substantial amounts (24.0%). SCGs free of coffee oil and phenolic compounds were subjected to microwave-assisted pretreatment under different irradiations and solvents to enhance subsequent enzymatic saccharification. Microwave/water pretreatment at 400 W, followed by enzymatic hydrolysis with proteases, hemicellulases, and cellulases, at 50 g/L initial SCGs, led to satisfying overall yields of cellulose (75.4%), hemicellulose (50.3%), and holocellulose (55.3%). Mannan was the most extractable polysaccharide followed by galactan and arabinan. SCGs hydrolysate was used in fed-batch bioreactor fermentations with Rhodosporidium toruloides to produce 24.0 g/L microbial oil and carotenoids of 432.9 µg/g biomass.
Asunto(s)
Carotenoides , Café , Fermentación , Café/químicaRESUMEN
BACKGROUND: The main challenge for large-scale production of bacterial cellulose (BC) includes high production costs interlinked with raw materials, and low production rates. The valorization of renewable nutrient sources could improve the economic effectiveness of BC fermentation while their direct bioconversion into sustainable biopolymers addresses environmental pollution and/or resource depletion challenges. Herein a green bioprocess was developed to produce BC in high amounts with the rather unexplored bacterial strain Komagataeibacter rhaeticus, using waste streams such as wine distillery effluents (WDE) and biodiesel-derived glycerol. Also, BC was evaluated as a bio-adsorbent for phenolics, dyes and metals removal to enlarge its market diversification. RESULTS: BC production was significantly affected by the WDE mixing ratio (0-100%), glycerol concentration (20-45 g/L), type of glycerol and media-sterilization method. A maximum BC concentration of 9.0 g/L, with a productivity of 0.90 g/L/day and a water holding capacity of 60.1 g water/g dry BC, was achieved at 100% WDE and ≈30 g/L crude glycerol. BC samples showed typical cellulose vibration bands and average fiber diameters between 37.2 and 89.6 nm. The BC capacity to dephenolize WDE and adsorb phenolics during fermentation reached respectively, up to 50.7% and 26.96 mg gallic acid equivalents/g dry BC (in-situ process). The produced BC was also investigated for dye and metal removal. The highest removal of dye acid yellow 17 (54.3%) was recorded when 5% of BC was applied as the bio-adsorbent. Experiments performed in a multi-metal synthetic wastewater showed that BC could remove up to 96% of Zn and 97% of Cd. CONCLUSIONS: This work demonstrated a low-carbon approach to produce low-cost, green and biodegradable BC-based bio-adsorbents, without any chemical modification. Their potential in wastewater-treatment-applications was highlighted, promoting closed-loop systems within the circular economy era. This study may serve as an orientation for future research towards competitive or targeted adsorption technologies for wastewater treatment or resources recovery.
RESUMEN
The global market for citric acid (CA) is one of the biggest and fastest expanding markets in the food industry. The CA production employing microbial bioprocessing with efficient GRAS strains and renewable waste streams is in line with the European Union binding targets for resource efficiency, sustainable consumption-production, and low-carbon technologies. In this work, the potential of three novel wild-type Yarrowia lipolytica strains (namely LMBF Y-46, LMBF Y-47 and ACA-YC 5033) regarding the production of CA and other valuable metabolites was tested on glucose-based media, and the most promising amongst the screened strains (viz. the strain ACA-YC 5033) was cultured on glucose-based media, in which part of the fermentation water had been replaced by olive-mill wastewaters (OMWs) in a novel approach of simultaneous OMW valorization and bioremediation. In the first part of this study, the mentioned strains were cultured under nitrogen-limited conditions with commercial (low-cost) glucose employed as a sole carbon source in shake-flask cultures at an initial concentration (S0) ≈ of 50 g/L. Variable quantities of secreted citric acid (CA) and intra-cellular compounds (viz. polysaccharides and lipids) were produced. All strains did not accumulate significantly high lipid quantities (i.e., maximum lipid in dry cell weight [DCW] values ≈30% w/w were noted) but produced variable CA quantities. The most promising strain, namely ACA-YC 5033, produced CA up to c. 24 g/L, with a yield of CA produced on glucose consumed (YCA/S) ≈ 0.45 g/g. This strain in stirred tank bioreactor experiments, at remarkably higher S0 concentrations (≈110 g/L) and the same initial nitrogen quantity added into the medium, produced notably higher CA quantities, up to 57 g/L (YCA/S ≈ 0.52 g/g). The potential of the same strain (ACA-YC 5033) to bioremediate OMWs and to produce value-added compounds, i.e., yeast cells, CA, and intra-cellular metabolites, was also assessed; under nitrogen-limited conditions in which OMWs had partially replaced tap water and significant glucose concentrations had been added (S0 ≈ 100 g/L, simultaneous molar ratio C/N ≈ 285 g/g, initial phenolic compounds [Phen0] adjusted to ≈1.0 g/L; these media were similar to the OMWs generated from the traditional press extraction systems) the notable CA quantity of 60.2 g/L with simultaneous YCA/S = 0.66 g/g, was obtained in shake flasks, together with satisfactory phenolic compounds removal (up to 19.5% w/w) and waste decolorization (up to 47.0%). Carbon-limited conditions with Phen0 ≈ 1.0 g/L favored the production of yeast DCW (up to 25.3 g/L), with equally simultaneous interesting phenolic compounds and color removal. The fatty acid profile showed that cellular lipids were highly unsaturated with oleic, linoleic and palmitoleic acids, accounting for more than 80% w/w. This study proposed an interesting approach that could efficiently address the biotreatment of toxic effluents and further convert them into circular-oriented bioproducts.
RESUMEN
A novel Komagataeibacter rhaeticus UNIWA AAK2 strain was used to produce bacterial cellulose (BC), valorizing brewers' spent grain (BSG) and brewer's spent yeast (BSY). Under optimal conditions (controlled pH = 6 and 30 g/L sugars), a maximum BC of 4.0 g/L was achieved when BSG aqueous extract (BSGE) was used. The substitution of yeast extract and peptone with BSY autolyzates did not show significant differences on BC concentration and productivity. The FTIR, SEM, and TGA analyses showed that the use of brewing by-products had no effect on the structure and thermal stability of the produced BC, compared to highly-pure and commercial substrates. The LCA of the developed bioprocess revealed that BSGE- and BSY-based media can reduce the carbon footprint of 1 kg dry BC by 76% compared to commercial-based-media. Beer by-products could serve as cost-effective resources to produce value-added and sustainable biopolymers such as BC, while minimizing waste and restructuring the brewing-industry.
Asunto(s)
Acetobacteraceae , Celulosa , Celulosa/análisis , Grano Comestible/química , AmbienteRESUMEN
The exponential increase in the use and careless discard of synthetic plastics has created an alarming concern over the environmental health due to the detrimental effects of petroleum based synthetic polymeric compounds. Piling up of these plastic commodities on various ecological niches and entry of their fragmented parts into soil and water has clearly affected the quality of these ecosystems in the past few decades. Among the many constructive strategies developed to tackle this global issue, use of biopolymers like polyhydroxyalkanoates as sustainable alternatives for synthetic plastics has gained momentum. Despite their excellent material properties and significant biodegradability, polyhydroxyalkanoates still fails to compete with their synthetic counterparts majorly due to the high cost associated with their production and purification thereby limiting their commercialization. Usage of renewable feedstocks as substrates for polyhydroxyalkanoates production has been the thrust area of research to attain the sustainability tag. This review work attempts to provide insights about the recent developments in the production of polyhydroxyalkanoates using renewable feedstock along with various pretreatment methods used for substrate preparation for polyhydroxyalkanoates production. Further, the application of blends based on polyhydroxyalkanoates, and the challenges associated with the waste valorization based polyhydroxyalkanoates production strategy is elaborated in this review work.
Asunto(s)
Petróleo , Polihidroxialcanoatos , Ecosistema , Biopolímeros/química , PlásticosRESUMEN
Sustainable food systems that employ renewable resources without competition with the food chain are drivers for the bioeconomy era. This study reports the valorization of microwave-pretreated spent coffee grounds (SCGs) to produce oleogels rich in bioactive compounds. Microbial oil rich in carotenoids (MOC) was produced under batch fermentation of Rhodosporidium toruloides using SCG enzymatic hydrolysates. Candelilla wax (CLW) could structure MOC and sunflower oil at a 3.3-fold lower concentration than that of carnauba wax (CBW). MOC-based oleogels with 10% CBW and 3% CLW showed an elastic-dominant and gel-like structure (tan δ ⪠1), providing gelation and oil binding capacity (>95%). Dendritic structures of CBW-based oleogels and evenly distributed rod-like crystals of CLW-based ones were observed via polarized light microscopy. MOC-based oleogels exhibited similar Fourier-transform infrared spectroscopy spectra. X-ray diffractograms of oleogels were distinguished by the oil type that presented ß'-type polymorphism. MOC-based oleogels could be applied in confectionary products and spreads as substitutes for trans fatty acids, reformulating fat-containing food products.
Asunto(s)
Carotenoides , Café , Compuestos Orgánicos/química , ReologíaRESUMEN
This study presents the valorization of side streams from the sunflower-based biodiesel industry for the production of bio-based and biodegradable food packaging following circular economy principles. Bacterial cellulose (BC) was produced via fermentation in 6 L static tray bioreactors using nutrient-rich supplements derived from the enzymatic hydrolysis of sunflower meal (SFM) combined with crude glycerol as carbon source. Novel biofilms were produced using either matrices of protein isolates extracted from sunflower meal (SFMPI) alone or SFMPI matrices reinforced with nanocellulose biofillers of commercial or bacterial origin. Acid hydrolysis was employed for ex-situ modification of BC to nanostructures (56 nm). The biofilms reinforced with bacterial nanocellulose structures (SFMPI-BNC) showed 64.5% higher tensile strength, 75.5% higher Young's modulus, 131.5% higher elongation at break, 32.5% lower water solubility and 14.1% lower water vapor permeability than the biofilms produced only with SFMPI. The biofilms were evaluated on fresh strawberries packaging showing that the SFMPI-BNC-based films lead to effective preservation at 10 °C considering microbial growth and physicochemical profile (weight loss, chemical characterization, color, firmness and respiration activity). The SFMPI-BNC-based films could be applied in fresh fruit packaging applications.