Using In-Shoe Inertial Measurement Unit Sensors to Understand Daily-Life Gait Characteristics in Patients With Distal Radius Fractures During 6 Months of Recovery: Cross-Sectional Study.

BACKGROUND: A distal radius fracture (DRF) is a common initial fragility fracture among women in their early postmenopausal period, which is associated with an increased risk of subsequent fractures. Gait assessments are valuable for evaluating fracture risk; inertial measurement units (IMUs) have been widely used to assess gait under free-living conditions. However, little is known about long-term changes in patients with DRF, especially concerning daily-life gait. We hypothesized that, in the long term, the daily-life gait parameters in patients with DRF could enable us to reveal future risk factors for falls and fractures. OBJECTIVE: This study assessed the spatiotemporal characteristics of patients with DRF at 4 weeks and 6 months of recovery. METHODS: We recruited 16 women in their postmenopausal period with DRF as their first fragility fracture (mean age 62.3, SD 7.0 years) and 28 matched healthy controls (mean age 65.6, SD 8.0 years). Daily-life gait assessments and physical assessments, such as hand grip strength (HGS), were performed using an in-shoe IMU sensor. Participants' results were compared with those of the control group, and their recovery was assessed for 6 months after the fracture. RESULTS: In the fracture group, at 4 weeks after DRF, lower foot height in the swing phase (P=.049) and higher variability of stride length (P=.03) were observed, which improved gradually. However, the dorsiflexion angle in the fracture group tended to be lower consistently during 6 months (at 4 weeks: P=.06; during 6 months: P=.07). As for the physical assessments, the fracture group showed lower HGS at all time points (at 4 weeks: P<.001; during 6 months: P=.04), despite significant improvement at 6 months (P<.001). CONCLUSIONS: With an in-shoe IMU sensor, we discovered the recovery of spatiotemporal gait characteristics 6 months after DRF surgery without the participants' awareness. The consistently unchanged dorsiflexion angle in the swing phase and lower HGS could be associated with fracture risk, implying the high clinical importance of appropriate interventions for patients with DRF to prevent future fractures. These results could be applied to a screening tool for evaluating the risk of falls and fractures, which may contribute to constructing a new health care system using wearable devices in the near future.

Prevalence of amyloid deposition and cardiac amyloidosis in shoulder disease compared to carpal tunnel syndrome.

Background: Cardiac amyloidosis is a fatal disease of severe heart failure caused by the accumulation of amyloid in the myocardium. This disease is often advanced by the time cardiac symptoms appear; therefore, early detection and treatment are critical for a good prognosis. Recently, it has been suggested that cardiac amyloidosis is implicated in several orthopedic diseases, including carpal tunnel syndrome (CTS), which is often reported to precede cardiac dysfunction. Shoulder disease has also been suggested to be associated with cardiac amyloidosis; however, there have been no reports investigating the rate of amyloid deposition in shoulder specimens and the simultaneous prevalence of cardiac amyloidosis. Herein, we investigated the prevalence of intraoperative specimen amyloid deposition and cardiac amyloidosis in shoulder disease and CTS to determine the usefulness of shoulder specimen screening as a predictor of cardiac amyloidosis development. Methods: A total of 41 patients undergoing arthroscopic shoulder surgery and 33 patients undergoing CTS surgery were enrolled in this study. The shoulder group included rotator cuff tears, contracture of the shoulder, synovitis, and calcific tendonitis. In the shoulder group, a small sample of synovium and the long head of the biceps brachii tendon were harvested, while the transverse carpal ligament was harvested from the CTS group. The intraoperative specimens were pathologically examined for amyloid deposition, and patients with amyloid deposition were examined for the presence of cardiac amyloidosis by cardiac evaluation. Results: In the shoulder group, three cases (7.3%) of transthyretin amyloid deposition were found, all of which involved rotator cuff tears. None of these three cases with amyloid deposition were associated with cardiac amyloidosis. When examining the specimens, the amyloid deposition rate in the long head of the biceps brachii tendon was higher than that in the synovium. In the CTS group, 12 cases (36.4%) of transthyretin amyloid deposition were observed. Of these cases, seven underwent cardiac evaluation and two were identified with cardiac amyloidosis. Conclusion: While the prevalence of amyloid deposition and cardiac amyloidosis in the CTS group was consistent with previous reports, the shoulder group showed a lower deposition rate and no concomitant cardiac amyloidosis. Therefore, it remains debatable whether investigating amyloid deposition in samples obtained from shoulder surgery is beneficial for the early detection of cardiac amyloidosis.

Gait characteristics in patients with distal radius fracture using an in-shoe inertial measurement system at various gait speeds.

BACKGROUND: Distal radius fractures (DRF) commonly occur in early postmenopausal females as the first fragility fracture. Although the incidence of DRF in this set of patients may be related to a lower ability to control their balance and gait, the detailed gait characteristics of DRF patients have not been examined. RESEARCH QUESTION: Is it possible to identify the physical and gait features of DRF patients using in-shoe inertial measurement unit (IMU) sensors at various gait speeds and to develop a machine learning (ML) algorithm to estimate patients with DRF using gait? METHODS: In this cross-sectional case control study, we recruited 28 postmenopausal females with DRF as their first fragility fracture and 32 age-matched females without a history of fragility fractures. The participants underwent several physical and gait tests. In the gait performance test, the participants walked 16 m with the in-shoe IMU sensor at slower, preferred, and faster speeds. The gait parameters were calculated by the IMU, and we applied the ML technique using the extreme gradient boosting (XGBoost) algorithm to predict the presence of DRF. RESULTS: The fracture group showed lower hand grip strength and lower ability to change gait speed. The difference in gait parameters was mainly observed at faster speeds. The amplitude of the change in the parameters was small in the fracture group. The XGBoost model demonstrated reasonable accuracy in predicting DRFs (area under the curve: 0.740), and the most relevant variable was the stance time at a faster speed. SIGNIFICANCE: Gait analysis using in-shoe IMU sensors at different speeds is useful for evaluating the characteristics of DRFs. The obtained gait parameters allow the prediction of fractures using the XGBoost algorithm.

Diagnosis of carpal tunnel syndrome using a 10-s grip-and-release test with video and machine learning analysis.

We developed a finger motion-based diagnostic system for carpal tunnel syndrome by analysing 10 second grip-and-release test videos. Using machine learning, it estimated presence of carpal tunnel syndrome (89% sensitivity and 83% specificity) and correlated with severity on nerve conduction studies (coefficient 0.68). LEVEL OF EVIDENCE: III.

Foot characteristics of the daily-life gait in postmenopausal females with distal radius fractures: a cross-sectional study.

BACKGROUND: Gait decline in older adults is related to falling risk, some of which contribute to injurious falls requiring medical attention or restriction of activity of daily living. Among injurious falls, distal radius fracture (DRF) is a common initial fragility fracture associated with the subsequent fracture risk in postmenopausal females. The recent invention of an inertial measurement unit (IMU) facilitates the assessment of free-living gait; however, little is known about the daily gait characteristics related to the risk of subsequent fractures. We hypothesized that females with DRF might have early changes in foot kinematics in daily gait. The aim of this study was to evaluate the daily-life gait characteristics related to the risk of falls and fracture. METHODS: In this cross-sectional study, we recruited 27 postmenopausal females with DRF as their first fragility fracture and 28 age-matched females without a history of fragility fractures. The participants underwent daily gait assessments for several weeks using in-shoe IMU sensors. Eight gait parameters and each coefficient of variance were calculated. Some physical tests, such as hand grip strength and Timed Up and Go tests, were performed to check the baseline functional ability. RESULTS: The fracture group showed lower foot angles of dorsiflexion and plantarflexion in the swing phase. The receiver operating characteristic curve analyses revealed that a total foot movement angle (TFMA) < 99.0 degrees was the risk of subsequent fracture. CONCLUSIONS: We extracted the daily-life gait characteristics of patients with DRF using in-shoe IMU sensors. A lower foot angle in the swing phase, TFMA, may be associated with the risk of subsequent fractures, which may be effective in evaluating future fracture risk. Further studies to predict and prevent subsequent fractures from daily-life gait are warranted.

The Potential of ChatGPT as a Self-Diagnostic Tool in Common Orthopedic Diseases: Exploratory Study.

BACKGROUND: Artificial intelligence (AI) has gained tremendous popularity recently, especially the use of natural language processing (NLP). ChatGPT is a state-of-the-art chatbot capable of creating natural conversations using NLP. The use of AI in medicine can have a tremendous impact on health care delivery. Although some studies have evaluated ChatGPT's accuracy in self-diagnosis, there is no research regarding its precision and the degree to which it recommends medical consultations. OBJECTIVE: The aim of this study was to evaluate ChatGPT's ability to accurately and precisely self-diagnose common orthopedic diseases, as well as the degree of recommendation it provides for medical consultations. METHODS: Over a 5-day course, each of the study authors submitted the same questions to ChatGPT. The conditions evaluated were carpal tunnel syndrome (CTS), cervical myelopathy (CM), lumbar spinal stenosis (LSS), knee osteoarthritis (KOA), and hip osteoarthritis (HOA). Answers were categorized as either correct, partially correct, incorrect, or a differential diagnosis. The percentage of correct answers and reproducibility were calculated. The reproducibility between days and raters were calculated using the Fleiss κ coefficient. Answers that recommended that the patient seek medical attention were recategorized according to the strength of the recommendation as defined by the study. RESULTS: The ratios of correct answers were 25/25, 1/25, 24/25, 16/25, and 17/25 for CTS, CM, LSS, KOA, and HOA, respectively. The ratios of incorrect answers were 23/25 for CM and 0/25 for all other conditions. The reproducibility between days was 1.0, 0.15, 0.7, 0.6, and 0.6 for CTS, CM, LSS, KOA, and HOA, respectively. The reproducibility between raters was 1.0, 0.1, 0.64, -0.12, and 0.04 for CTS, CM, LSS, KOA, and HOA, respectively. Among the answers recommending medical attention, the phrases "essential," "recommended," "best," and "important" were used. Specifically, "essential" occurred in 4 out of 125, "recommended" in 12 out of 125, "best" in 6 out of 125, and "important" in 94 out of 125 answers. Additionally, 7 out of the 125 answers did not include a recommendation to seek medical attention. CONCLUSIONS: The accuracy and reproducibility of ChatGPT to self-diagnose five common orthopedic conditions were inconsistent. The accuracy could potentially be improved by adding symptoms that could easily identify a specific location. Only a few answers were accompanied by a strong recommendation to seek medical attention according to our study standards. Although ChatGPT could serve as a potential first step in accessing care, we found variability in accurate self-diagnosis. Given the risk of harm with self-diagnosis without medical follow-up, it would be prudent for an NLP to include clear language alerting patients to seek expert medical opinions. We hope to shed further light on the use of AI in a future clinical study.

Screening for degenerative cervical myelopathy with the 10-second grip-and-release test using a smartphone and machine learning: A pilot study.

Objective: Early detection and intervention are essential for the mitigation of degenerative cervical myelopathy (DCM). However, although several screening methods exist, they are difficult to understand for community-dwelling people, and the equipment required to set up the test environment is expensive. This study investigated the viability of a DCM-screening method based on the 10-second grip-and-release test using a machine learning algorithm and a smartphone equipped with a camera to facilitate a simple screening system. Methods: Twenty-two participants comprising a group of DCM patients and 17 comprising a control group participated in this study. A spine surgeon diagnosed the presence of DCM. Patients performing the 10-second grip-and-release test were filmed, and the videos were analyzed. The probability of the presence of DCM was estimated using a support vector machine algorithm, and sensitivity, specificity, and area under the curve (AUC) were calculated. Two assessments of the correlation between estimated scores were conducted. The first used a random forest regression model and the Japanese Orthopaedic Association scores for cervical myelopathy (C-JOA). The second assessment used a different model, random forest regression, and the Disabilities of the Arm, Shoulder, and Hand (DASH) questionnaire. Results: The final classification model had a sensitivity of 90.9%, specificity of 88.2%, and AUC of 0.93. The correlations between each estimated score and the C-JOA and DASH scores were 0.79 and 0.67, respectively. Conclusions: The proposed model could be a helpful screening tool for DCM as it showed excellent performance and high usability for community-dwelling people and non-spine surgeons.

A screening method for cervical myelopathy using machine learning to analyze a drawing behavior.

Early detection of cervical myelopathy (CM) is important for a favorable outcome, as its prognosis is poor when left untreated. We developed a screening method for CM using machine learning-based analysis of the drawing behavior of 38 patients with CM and 66 healthy volunteers. Using a stylus pen, the participants traced three different shapes displayed on a tablet device. During the tasks, writing behaviors, such as the coordinates, velocity, and pressure of the stylus tip, along with the drawing time, were recorded. From these data, features related to the drawing pressure, and time to trace each shape and combination of shapes were used as training data for the support vector machine, a machine learning algorithm. To evaluate the accuracy, a receiver operating characteristic curve was generated, and the area under the curve (AUC) was calculated. Models with triangular waveforms tended to be the most accurate. The best triangular wave model identified patients with and without CM with 76% sensitivity and 76% specificity, yielding an AUC of 0.80. Our model was able to classify CM with high accuracy and could be applied to the development of disease screening systems useful outside the hospital setting.

Deployment design of wireless sensor network for simple multi-point surveillance of a moving target.

In this paper, we focus on the problem of tracking a moving target in a wireless sensor network (WSN), in which the capability of each sensor is relatively limited, to construct large-scale WSNs at a reasonable cost. We first propose two simple multi-point surveillance schemes for a moving target in a WSN and demonstrate that one of the schemes can achieve high tracking probability with low power consumption. In addition, we examine the relationship between tracking probability and sensor density through simulations, and then derive an approximate expression representing the relationship. As the results, we present guidelines for sensor density, tracking probability, and the number of monitoring sensors that satisfy a variety of application demands.