Assessing the dry impinger method for condensable particulate matter from ultra-low emission coal-fired power plant measurement.

The dry impinger method is commonly used for the determination of condensable particulate matter (CPM) emissions. The coil and chamber condenser is used to build different dry impinger methods for CPM sampling. The comparative analysis of coil and chamber condenser is performed in a laboratory experiment to evaluate the deviation caused by SO2. Results showed that the positive deviation caused by SO2 in the chamber condenser is lower than that in the coil condenser under the same sampling conditions, especially under high humidity flue gas. The CPM emission characteristics from Hanchuan coal-fired power plant (CFPP) determined by both dry impinger methods are also investigated as well. The CPM and its most water-soluble ions (e.g., F-, Cl-, NO3-, SO42-, Na+, Ca2+ and NH4+) measured by method #2 (chamber condenser) are higher than that of method #1 (coil condenser). In addition, the esters in the CPM also increased with the CPM concentrations. Based on above evidences, it can be inferred that the dry impinger method with chamber condenser, will be recommended as the appropriate method for measuring CPM emitted from stationary sources, especially under the high humidity flue gas conditions.

[Effect of WESP on Emission Characteristics of Condensable Particulate Matter from Ultra-low Emission Coal-fired Power Plants].

In order to study the effect of wet electrostatic precipitators(WESP) on emission characteristics of condensable particulate matter (CPM) from ultra-low emission coal-fired power plants that are under different capacity conditions, a set of CPM sampling devices was built based on US EPA Method 202, and an ultra-low emission coal-fired power plant was detected. This study evaluated the emission level of the CPM from the flue gas of coal-fired power plants, the effects of different unit capacity conditions on the CPM emission concentrations, and the removal efficiency of WESP for different components of the CPM. The results suggested that the emission concentrations of the CPM from ultra-low emission power plants were 27.27 mg·m-3 and 28.71 mg·m-3under the conditions of 75% and 100% capacity, respectively. The removal efficiencies of WESP for the CPM were 35.59% and 27.59%, respectively. SO42- was the main component of water-soluble ions of the CPM. The proportion of SO42- in inorganic components of the CPM reached more than 65% under different capacity conditions. In addition, the removal efficiency of WESP for Cl-, K+, Ca2+, Mg2+, Na+, and other inorganic ions reached 30%-50%, but the mass concentrations of SO42- and NO3- increased.