Fluorescent Sensor Based on 1H-Pyrazolo[3,4-b]quinoline Derivative for Detecting Zn2+ Cations.

The photophysical and sensory properties of the donor-acceptor pyrazoloquinoline derivative (PQPc) were investigated using absorption, steady-state, and time-resolved fluorescence measurements. The compound synthesized from commercial, readily available substrates exhibited absorptions in the UV-Vis range, with a maximum of the longwave band around 390 nm. The maximum fluorescence was around 460-480 nm, depending on the solvent. The quantum yield was between 12.87% (for n-hexane) and 0.75% (for acetonitrile) and decreased with increasing solvent polarity. The PET mechanism was implicated as the cause of fluorescence quenching. Divalent ions such as Zn2+, Pb2+, Cd2+, Ca2+, Mg2+, Co2+, Ni2+, and Cu2+ were introduced to study the fluorescent response of PQPc. A 13-times increase in fluorescence quantum yield was observed after the addition of Zn2+ ions. Detailed research was carried out for the PQPc-Zn2+ system in order to check the possibility of analytical applications of PQPc as a fluorescent sensor. A detection limit of Zn2+ was set at the value level 1.93 × 10-7 M. PQPc-Zn2+ complexes had a stoichiometry of 1:1 with a binding constant of 859 M-1. Biological studies showed that the sensor was localized in cells near the membrane and cytoplasm and may be used to detect zinc ions in eukaryotic cells.

Multicomponent Synthesis of 4-Aryl-4,9-dihydro-1H-pyrazolo[3,4-b]quinolines Using L-Proline as a Catalyst-Does It Really Proceed?

Looking for effective synthetic methods for 1H-pyrazolo[3,4-b]quinolines preparation, we came across a procedure where, in a three-component reaction catalysed by L-proline, 4-aryl-4,9-dihydro-1H-pyrazolo[3,4-b]quinolines are formed. These compounds can be easily oxidised to a fully aromatic system, which gives hope for a synthetic method that could replace, e.g., Friedländer condensation, often used for this purpose, even though severely limited by the availability of suitable substrates. However, after careful repetition of the procedures described in the publication, it turned out that the compounds described therein do not form at all. The actual compounds turned out to be 4,4-(phenyl-methylene)-bis-(3-methyl-1-phenylpyrazol-5-oles). Therefore, 4-Aryl-4,9-dihydro-1H-pyrazolo[3,4-b]quinolines were prepared by another method and used as standards to compare the products formed in the original procedure.

Photoinduced charge transfer in push-pull pyrazoline-based chromophores - Relationship between molecular structure and photophysical, photovoltaic properties.

The manuscript describes the effect of molecular structure on the photophysical and photovoltaic properties of the pyrazoline-based donor-branched-π-system-acceptor compounds decorated with two end groups: phenyl or thiophene. Although the absorption to the first singlet excited state is strongly allowed, the emission quantum yield is low in all studied solvents. This behaviour was explained by the existence of two non-radiative deactivation channels: the back electron transfer process, especially operated in polar solvents, and internal conversion realized as the rotation of flexible rotors (cyano, keto phenyl or thiophene). The feasibility of the photoinduced electron transfer process was corroborated by electrochemical, spectroelectrochemical measurements as well as DFT calculations. DFT calculations also support the existence of multiple conformations in the ground state, which differ from one another in terms of charge distribution and the values of ground state dipole moment. Finally, the mechanism of the singlet excited state deactivation of the studied compounds was determined by ultrafast pump-probe measurements. Our studies revealed that charge/electron transfer process may undergo over carbonyl bridge, included in branched π-system. Moreover, the thiophene decorated pyrazoline is characterized by a better photovoltaic power conversion efficiency, while the phenyl-ended pyrazoline can be applied as a viscosity sensor.

Ladder-like Polymer Brushes Containing Conjugated Poly(Propylenedioxythiophene) Chains.

The high stability and conductivity of 3,4-disubstituted polythiophenes such as poly(3,4-ethylenedioxythiophene) (PEDOT) make them attractive candidates for commercial applications. However, next-generation nanoelectronic devices require novel macromolecular strategies for the precise synthesis of advanced polymer structures as well as their arrangement. In this report, we present a synthetic route to make ladder-like polymer brushes with poly(3,4-propylenedioxythiophene) (PProDOT)-conjugated chains. The brushes were prepared via a self-templating surface-initiated technique (ST-SIP) that combines the surface-initiated atom transfer radical polymerization (SI-ATRP) of bifunctional ProDOT-based monomers and subsequent oxidative polymerization of the pendant ProDOT groups in the parent brushes. The brushes prepared in this way were characterized by grazing-angle FTIR, XPS spectroscopy, and AFM. Steady-state and time-resolved photoluminescence measurements were used to extract the information about the structure and effective conjugation length of PProDOT-based chains. Stability tests performed in ambient conditions and under exposure to standardized solar light revealed the remarkable stability of the obtained materials.

Novel scintillating material 2-(4-styrylphenyl)benzoxazole for the fully digital and MRI compatible J-PET tomograph based on plastic scintillators.

A novel plastic scintillator is developed for the application in the digital positron emission tomography (PET). The novelty of the concept lies in application of the 2-(4-styrylphenyl)benzoxazole as a wavelength shifter. The substance has not been used as scintillator dopant before. A dopant shifts the scintillation spectrum towards longer wavelengths making it more suitable for applications in scintillators of long strips geometry and light detection with digital silicon photomultipliers. These features open perspectives for the construction of the cost-effective and MRI-compatible PET scanner with the large field of view. In this article we present the synthesis method and characterize performance of the elaborated scintillator by determining its light emission spectrum, light emission efficiency, rising and decay time of the scintillation pulses and resulting timing resolution when applied in the positron emission tomography. The optimal concentration of the novel wavelength shifter was established by maximizing the light output and it was found to be 0.05 ‰ for cuboidal scintillator with dimensions of 14 mm x 14 mm x 20 mm.

Photoactive Surface-Grafted Polymer Brushes with Phthalocyanine Bridging Groups as an Advanced Architecture for Light-Harvesting.

Surface-grafted polymer brushes of novel ladder-like architecture were proposed for inducing ordering of chromophores embedded therein. The brushes with acetylene side groups were obtained by surface-initiated photoiniferter-mediated polymerization. The acetylene moieties reacted then through a "click" process with an axially azide-bifunctionalized silicon phthalocyanine bridging the neighboring chains that inherently adopt extended conformations in dense brushes. FTIR, quartz crystal microbalance, and atomic force microscopy were used to study formation and structure of the photoactive brushes varying in grafting densities. Importantly, photophysical properties of the chromophores were virtually unaffected upon embedding them into the brushes, as evidenced by UV/Vis absorption and emission spectroscopy. Owing to the unique ordering of the chromophores, the proposed method may open new opportunities for the fabrication of light-harvesting systems suitable for photovoltaic or sensing applications.

Applications of fluorescent sensor based on 1H-pyrazolo[3,4-b]quinoline in analytical chemistry.

Fluorescent dye 2-[(2-Hydroxyethyl)-(1,3-diphenyl-1H-pyrazolo[3,4-b]quinolin-6-ylmethyl)-amino]ethanol (LL1) was examined for its efficiency in the detection of small inorganic cations (lithium, sodium, barium, calcium, magnesium, cadmium, lead and zinc). The dye was synthesized in the laboratory and investigated by means of both, steady-state and time-resolved fluorescence techniques. This compound acts as a fluorescent sensor suitable for detection of small inorganic cations (lithium, sodium, barium, calcium, magnesium, cadmium, lead and zinc) in strongly polar solvent (acetonitrile). An electron transfer from the electro-donative part (receptor) of the molecule to the acceptor part (fluorophore) is thought to be the main mechanism that underlies functionality of the compound as a sensor. This process can be retarded upon complexation of the receptor moiety by inorganic cations. Relatively high sensitivity but poor selectivity of the amino alcohol that contains indicator towards the two-valued cations was observed. However, upon addition of some amounts of water the selectivity of this sensor has been enhanced (especially towards lead cation). The preliminary results in analytical application of the sensor are discussed.

A new fluorescent sensor based on 1H-pyrazolo[3,4-b]quinoline skeleton. Part 2.

A novel fluorescent dye bis-(pyridin-2-yl-methyl)-(1,3,4-triphenyl-1H-pyrazolo[3,4-b]quinolin-6-ylmethyl)-amine (P1) has been synthesized and investigated by means of steady state and time-resolved fluorescence techniques. This compound acts as sensor for fluorescence detection of small inorganic cations (lithium, sodium, barium, magnesium, calcium, and zinc) in highly polar solvents such as acetonitrile. The mechanism which allows application of this compound as sensor is an electron transfer from the electron-donative part of molecule (amine) to the acceptor part (pyrazoloquinoline derivative), which is retarded upon complexation of the electro-donative part by inorganic cations. The binding constants are strongly dependent on the charge density of the analyzed cations. The 2/1 complexes of P1 with Zn(++) and Mg(++) cations posses large binding constants. Moreover, in the presence of these cations a significant bathochromic shift of fluorescence is observed. The most probable explanation of such behaviour is the formation of intramolecular excimer. This is partially supported by the quantum chemical calculations.

Investigation of the photoisomerisation process in four p-benzoxazoyl-substituted stilbenes.

Fluorescence properties and trans-cis photoisomerisation of the benzoxazole derivatives 2-[4-(E)-(styryl)phenyl]benzoxazole (I), 2-{4-[(E)-2-(4-methoxyphenyl)vinyl]phenyl}benzoxazole (II), {4-[(E)-2-(4-benzoxazol-2-yl-phenyl)vinyl]phenyl}dimethylamine (III) and {4-[(E)-2-(4-benzoxazol-2-yl-phenyl)vinyl]phenyl}diphenylamine (IV) have been investigated in solvents of different polarities. It was found that these compounds exhibit efficient fluorescence with quantum yields and lifetimes strongly dependent on solvent polarity, although only compounds III and IV possess a significant charge transfer character in solvents of medium and high polarities. In addition, the photoisomerisation quantum efficiency depends strongly on the substitution of the phenyl ring in the electron donor moiety. A strong dependence of the quantum efficiency of the photoisomerisation on solvent was established. That quantity depends linearly on the non-radiative quantum yield of the deactivation of the excited singlet state for all investigated compounds. These results are consistent with a singlet state mechanism of the photoprocess. For compounds III and IV, with strong electron donors (N,N-dimethylaniline and triphenylamine), the molecule in the excited state trans configuration is more stabilized by solvent polarity than in the perpendicular form which causes more efficient isomerisation in nonpolar solvents. For compounds I and II the energy of the perpendicular configuration decreases more rapidly than that of the trans configuration when solvent polarity increases. In this case the energy barrier decreases with increasing solvent polarity. This makes the photoisomerisation process easier in polar solvents.

New fluorescent sensors based on 1H-pyrazolo[3,4-b] quinoline skeleton.

Novel fluorescing dyes 1,3,4-triphenyl-6-(1,4,7,10-tetraoxa-13-aza-cyclopentadec-13-ylmethyl)-1H-pyrazolo [3,4-b]quinoline (K1) and 2-[(2-hydroxyethyl)-(1,3,4-triphenyl-1H-pyrazolo[3,4-b]quinolin-6-ylmethyl)-amino] ethanol (L1) have been synthesized and investigated by the means of steady state and time-resolved fluorescence techniques. These compounds act as sensors for the fluorescence detection of small inorganic cations (lithium, sodium, barium, magnesium and calcium) in solvents of different polarities (THF and acetonitrile). The mechanism, which allows application of these compounds as sensors, is an electron transfer from the electro-donative part of molecule to the acceptor part (fluorophore), which is retarded upon complexation of the electro-donative part by inorganic cations. We found that crown ether-containing compound is very sensitive to the addition of any investigated ions but amino alcohol-containing one exhibits better selectivity to the addition of two-valued cations. Two kinds of the complexes (LM(+) and L(2)M(+)) were found in the investigated systems. In addition, the dyes may be used as fluorescence indicators in solvents of lower polarity like tetrahydrofuran.

Intramolecular exciplexes based on benzoxazole: photophysics and applications as fluorescent cation sensors.

Exciplex behaviour of three benzoxazole derivatives has been detected and intensively investigated by means of steady-state and time-resolved fluorescence techniques and transient absorption spectroscopy. The fluorescence of these compounds shows the properties which are typical for the excited state charge transfer complexes (exciplexes). Besides of the short wavelength fluorescence, which is similar in spectral distribution to the fluorescence of the electron acceptor (2-p-tolyl-benzoxazole), the red shifted, broad and structureless emission band is observed in solvents of low and medium polarity. The detailed analysis of the fluorescence data shows that the ratio of the CT and LE fluorescence initially increases with increasing solvent polarity, achieves a maximum, and drops for more polar solvents (epsilon(s) = 7). Similar behaviour is observed for the exciplex fluorescence lifetimes. The overall fluorescence and the relative intersystem crossing quantum yields show the decrease of these values with increasing solvent polarity. These observations have been explained on the basis of Marcus-type theory for nonradiative charge transfer rate constants. Increasing solvent polarity strongly accelerates the back electron transfer process which recovers the whole molecule in the ground state. The probability of the compact exciplex formation (i.e. sandwich-type structures) depends on solvent viscosity and degree of freedom of the bending of the saturated linker. The compound containing crown ether as a donor subunit may be used as a fluorescent indicator of inorganic cations (barium and lithium). We found an effective complexation of the compound in the ground state with barium and lithium cations. The complex is also stable in the excited state which manifests itself in strong increase of the fluorescence intensity.