Exploration of environmental contaminants in honeybees using GC-TOF-MS and GC-Orbitrap-MS.

This study reports an analytical approach by gas chromatography and high-resolution mass spectrometry (HRMS) intended to be used for investigation of non-targeted environmental contaminants in honeybees. The approach involves a generic extraction and analysis with two GC-HRMS systems: time-of-flight and Orbitrap analyzers, GC-TOF-MS, and GC-Orbitrap-MS operated in electron-impact ionization (EI) mode. The workflow for screening of non-targeted contaminants consisted of initial peak detection by deconvolution and matching the first-stage mass spectra EI-MS with a nominal mass spectral library. To gain further confidence in the structural characterization of the contaminants under investigation, molecular formula of representative ions (molecular and fragment ions) was provided for those with an accurate mass scoring (error < 5 ppm). This methology was applied for screening environmental contaminants in 75 samples of adult honeybee. This approach has provided the tentative identification of environmental contaminants belonging to different chemical groups, among them, PAHs, phthalates and synthetic musks. Residues of veterinary treatments used in apiculture were also detected in the honeybee samples.

Identification and measurement of veterinary drug residues in beehive products.

There is an increasing concern about the negative impacts of veterinary drugs in beehive compartments. This study evaluates the presence and distribution of chemical residues in beeswax, bee bread and honey and determinates in what extension honeybees are exposed to them. Samples were analyzed by LC-MS/MS and GC-MS/MS with a wide scope of 322 chemical residues. Samples were collected from apiaries located in rural and forest areas, showing no difference in contamination of phytosanitary applications. Residues of acaricides used for sanitary treatments, coumaphos and two transformation products of amitraz (DMF and DMPF), were quantified at higher levels in wax and bee bread than in honey in most cases. Coumaphos, DMF and DMPF were detected in honey in the range 6-36 µg.kg-1; 45-541 µg.kg-1; 15-107 µg.kg-1, respectively. All, except one sample, were below the EU MRLs, 396/2005 Regulation. Other pesticide residues were detected in beeswax and bee bread at various levels.

High-throughput gas chromatography-mass spectrometry analysis of pesticide residues in spices by using the enhanced matrix removal-lipid and the sample dilution approach.

Spices are known as difficult matrices that contain variable amounts of fats, piperine or many other matrix constituents. The increasing sensitivity of new GC-MS/MS platforms opens new approaches to analyze pesticide residue in complex matrices such as spices, by sample dilution. The aim of this work is to develop and validate an effective multiresidue method for the analysis of pesticide residues in spices by GC-MS/MS. In this paper, we highlight the importance of reducing matrix interferences generated from co-extractive components of spices. Moreover, we emphasize the concern of obtaining clean extracts requiring less instrument maintenance. By evaluating the total ion chromatograms (TIC) on GC-Orbitrap-MS of different extracts using various sorbents, QuEChERS citrate using EMR-Lipid sorbent resulted in the cleanest extract among Z-Sep, Primary secondary amine (PSA), Oasis® Prime HLB, and Supelclean™ Ultra cartridges that consist of a top bed of PSA, C18 and Grashsphere™ 2031 and a bottom bed of Z-Sep. Later, the analyses were performed on a GC-QQQ-MS/MS, applying a 15 min runtime method covering 205 compounds. The samples were diluted 25 times before the injection bearing in mind that the instrumental LOQs reached (iLOQ) were 2 ng g-1 and the method LOQs (mLOQ) were 50 ng g-1. Good recoveries between 70 and 120% with RSDs lower than 20% were observed for 90% of the compounds in black pepper and for 83% of the compounds in cayenne pepper. To demonstrate the applicability of the proposed method, 50 real dried and non-dried spice samples were analyzed. The most detected pesticides were metalaxyl, chlorpyrifos, tebuconazole, ethion, and chinomethionate.

Matrix interference evaluation employing GC and LC coupled to triple quadrupole tandem mass spectrometry.

Gas and liquid chromatography coupled to triple quadrupole tandem mass spectrometry are currently the most powerful tools employed for the routine analysis of pesticide residues in food control laboratories. However, whatever the multiresidue extraction method, there will be a residual matrix effect making it difficult to identify/quantify some specific compounds in certain cases. Two main effects stand out: (i) co-elution with isobaric matrix interferents, which can be a major drawback for unequivocal identification, and therefore false negative detections, and (ii) signal suppression/enhancement, commonly called the "matrix effect", which may cause serious problems including inaccurate quantitation, low analyte detectability and increased method uncertainty. The aim of this analytical study is to provide a framework for evaluating the maximum expected errors associated with the matrix effects. The worst-case study contrived to give an estimation of the extreme errors caused by matrix effects when extraction/determination protocols are applied in routine multiresidue analysis. Twenty-five different blank matrices extracted with the four most common extraction methods used in routine analysis (citrate QuEChERS with/without PSA clean-up, ethyl acetate and the Dutch mini-Luke "NL" methods) were evaluated by both GC-QqQ-MS/MS and LC-QqQ-MS/MS. The results showed that the presence of matrix compounds with isobaric transitions to target pesticides was higher in GC than under LC in the experimental conditions tested. In a second study, the number of "potential" false negatives was evaluated. For that, ten matrices with higher percentages of natural interfering components were checked. Additionally, the results showed that for more than 90% of the cases, pesticide quantification was not affected by matrix-matched standard calibration when an interferent was kept constant along the calibration curve. The error in quantification depended on the concentration level. In a third study, the "matrix effect" was evaluated for each commodity/extraction method. Results showed 44% of cases with suppression/enhancement for LC and 93% of cases with enhancement for GC.

Identification of non-intentionally added substances in food packaging nano films by gas and liquid chromatography coupled to orbitrap mass spectrometry.

The control of chemical migration from new functionalized food contact materials (FCMs) is a challenge for meeting food safety requirements. The non-intentionally added substances (NIAS) constitute a group of chemicals that are not applied, but may be introduced or formed during the production process of FCMs. This study describes a multi-analytical approach for the evaluation of unknown substances that migrate from FCMs. A case study is presented using a developed polymer consisting of a monolayer film with polylactic acid (PLA), polylimonene (PL) and zinc oxide nanoparticles (ZnO NPs). This approach incorporates the platforms of ICP-MS (inductively coupled plasma mass spectrometry), to determine whether there is transference of ZnO NPs used as antimicrobial agent and, the systems GC-MS and LC-MS (gas / liquid chromatography coupled to a quadrupole orbitrap mass spectrometer) for the characterization of the chemical structure of NIAS using the molecular mass and specific features of mass fragmentation. The screening of unknown compounds comprised retrospective analysis and data processing using both, a mass spectral library and databases, for GC and LC data, respectively. This approach has provided the tentative identification and quantification of seven NIAS, 3 by GC (Tripropylene glycol diacrylate, 10-Heneicosene and α-Tocopherol acetate) and 4 by LC (N,N-Diethyldodecanamide, N-[(9Z)-9-Octadecen-1-yl]acetamide, 1-Palmitoylglycerol and Glycerol stearate). This migration study was carried out according to the standard protocols established by EU regulation for FCMs.

Shifting the paradigm in gas chromatography mass spectrometry pesticide analysis using high resolution accurate mass spectrometry.

In the last 10 years, the majority of the pesticide food control laboratories moved from GC-MS to GC-MS/MS as the preferred analytical technique to address GC amenable compounds. The main reason for this change was the negative impact on the single stage GC-MS analysis caused by the interference from coeluting matrix compounds. The new development of gas chromatography coupled to high resolution accurate mass spectrometry (GC-HRAMS) provides opportunities to overcome such matrix interferences as a result of its much higher selectivity; allowing laboratories to carry out full-scan analysis covering the most exigent analytical performance criteria. The aim of this work is the evaluation of the main analytical performance parameters for the multiresidue screening of pesticide residues by a gas chromatography-Orbitrap™ mass spectrometer in fruits and vegetables. Electron ionization and full-scan high resolution mass spectrometry was selected for this evaluation. Mass resolving power, selectivity, sensitivity, analyte identification and database generation are discussed in light of the analysis of various commodities and a large scope of pesticides. The selected operational conditions provided optimal mass accuracy, within ±1mDa and achieved LOQs of 10µg/kg or lower for practically all the selected pesticides and commodities. Applicability for quantitative residue analysis was verified by the validation of the 210 pesticides in four matrices (tomato, apple, leek and orange). The performance of the GC-EI-full scan Orbitrap HRAMS developed method was confirmed with the analysis of 102 real samples providing good results.

Large multiresidue analysis of pesticides in edible vegetable oils by using efficient solid-phase extraction sorbents based on quick, easy, cheap, effective, rugged and safe methodology followed by gas chromatography-tandem mass spectrometry.

The aim of this research was to adapt the QuEChERS method for routine pesticide multiresidue analysis in edible vegetable oil samples using gas chromatography coupled to tandem mass spectrometry (GC-MS/MS). Several clean-up approaches were tested: (a) D-SPE with Enhanced Matrix Removal-Lipid (EMR-Lipid™); (b) D-SPE with PSA; (c) D-SPE with Z-Sep; (d) SPE with Z-Sep. Clean-up methods were evaluated in terms of fat removal from the extracts, recoveries and extraction precision for 213 pesticides in different matrices (soybean, sunflower and extra-virgin olive oil). The QuEChERS protocol with EMR-Lipid d-SPE provided the best reduction of co-extracted matrix compounds with the highest number of pesticides exhibiting mean recoveries in the 70-120% range, and the lowest relative standard deviations values (4% on average). A simple and rapid (only 5min) freeze-out step with dry ice (CO2 at -76°C) prior to d-SPE clean-up ensured much better removal of co-extracted matrix compounds in compliance of the necessity in routine analysis. Procedural Standard Calibration was established in order to compensate for recovery losses of certain pesticides and possible matrix effects. Limits of quantification were 10µgkg(-1) for the majority of the pesticides. The modified methodology was applied for the analysis of different 17 oil samples. Fourteen pesticides were detected with values lower than MRLs and their concentration ranged between 10.2 and 156.0µgkg(-1).

A sensitive and efficient method for routine pesticide multiresidue analysis in bee pollen samples using gas and liquid chromatography coupled to tandem mass spectrometry.

Several clean-up methods were evaluated for 253 pesticides in pollen samples concentrating on efficient clean-up and the highest number of pesticides satisfying the recovery and precision criteria. These were: (a) modified QuEChERS using dSPE with PSA+C18; (b) freeze-out prior to QuEChERS using dSPE with PSA+C18; (c) freeze-out prior to QuEChERS using dSPE with PSA+C18+Z-Sep; and (d) freeze-out followed by QuEChERS using dSPE with PSA+C18 and SPE with Z-Sep. Determinations were made using LC-MS/MS and GC-MS/MS. The modified QuEChERS protocol applying a freeze-out followed by dSPE with PSA+C18 and SPE clean-up with Z-Sep was selected because it provided the highest number of pesticides with mean recoveries in the 70-120% range, as well as relative standard deviations (RSDs) typically below 20% (12.2% on average) and ensured much better removal of co-extracted matrix compounds of paramount importance in routine analysis. Limits of quantification at levels as low as 5µgkg(-1) were obtained for the majority of the pesticides. The proposed methodology was applied to the analysis of 41 pollen bee samples from different areas in Spain. Pesticides considered potentially toxic to bees (DL50<2µg/bee) were detected in some samples with concentrations up to 72.7µgkg(-1), which could negatively affect honeybee health.

Development of a solvent-free method for the simultaneous identification/quantification of drugs of abuse and their metabolites in environmental water by LC-MS/MS.

This work details a rapid analytical method using direct sample injection for the simultaneous identification/quantification of 22 drugs of abuse, including some of their major metabolites, in environmental samples. This has been developed using a hybrid triple quadrupole-linear ion trap-mass spectrometer (QqLIT). With the increasing sensitivity of today's tandem mass spectrometers, direct injection analysis of water samples has become an attractive alternative to traditional analytical protocols, which often include a preliminary pre-concentration step. What's more, this kind of analysis is in accordance with many of the main objectives of so-called green analytical chemistry, or environmentally friendly practice. The analytical performance of the LC-MS/MS method was evaluated in three different water matrices (surface water, influent and effluent wastewater). Data acquisition was carried out in selected reaction monitoring (SRM) mode under time-scheduled conditions, monitoring two SRM transitions for simultaneous identification/quantification of all target compounds in the samples. Additionally, an experiment was performed using the information-dependent acquisition (IDA) scan to carry out the identification of those analytes for which the second transition was present at a low intensity. Finally, the two methodologies developed were applied to real samples for evaluation.

Evaluation of selected ubiquitous contaminants in the aquatic environment and their transformation products. A pilot study of their removal from a sewage treatment plant.

A simple method using direct sample injection combined with liquid chromatography tandem mass spectrometry has been developed for the simultaneous analysis of six alkaloid compounds in environmental samples. The target list includes two psychostimulants (nicotine and caffeine), three metabolites (cotinine, nicotinic acid and paraxanthine) and a coffee chemical (trigonelline). The analytical method was evaluated in three different matrices (surface water, influent and effluent wastewater). The method developed showed an adequate sensitivity, below 0.6 µg L(-1) for wastewater and 0.1 µg L(-1) for river matrices, without any prior treatment of the samples. Finally, the methodology was applied to real samples for evaluation of their removal from a sewage treatment plant and their persistence/fate in the aquatic environment. All compounds studied in this work were detected at all sampling points collected along the Henares River. However, nicotinic acid was only detected three times in treated sewage samples at levels above its detection limit.