RESUMEN
The lead-free Ca(Sn x Ti1-x )O3, (0 ≤ x ≤ 0.8) sample has been successfully prepared through the ball milling process, sintered at 1200 °C for 3 h. The structural, morphological, vibrational, and microwave dielectric properties of synthesized samples were analyzed by X-ray diffraction (XRD), scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FT-IR), and impedance analysis. All the samples have an orthorhombic phase structure with a space group of Pbnm formation, and the crystalline size and strain changes with respect to Sn4+ doping were observed in the XRD analysis. From a morphological point of view, on increasing the content "x", the grain size reduces from 3.29 to 1.37 µm. The existence of vibrations and the bridging stretching mode of Ti-O-Ti and Ti-O-Sn both are associated with the broadband in the region below 800 cm-1 verified by FT-IR. The variation in electrons hopping off the host compound with respect to Sn4+ ions was analyzed in AC conductivity. The changes of dielectric properties such as complex permittivity, modulus spectroscopy, and dielectric loss at room temperature with a different frequency range of 1.00-2.00 GHz are discussed.
RESUMEN
For safety concerns, polymer-based Li-O2 batteries have received more attention than traditional non-aqueous Li-O2 batteries. However, poor cycling stability, low round trip efficiency, and over charge potential during cycling are the major shortcomings for their future applications. In this work, a soluble redox mediator integrated into a polymer electrolyte provides immediate access to the solid discharged product, lowering the energy barrier for reversible Li2O2 generation and disintegration. Moreover, introducing a redox mediator to the polymer electrolyte boosts the ORR during discharge and the OER during the recharge process. The synergistic redox mediator pBQ (1,4 benzoquinone) dramatically reduces the over-potential. A small proportion of pBQ in the polymer electrolyte allows Li2O2 to develop in a thin film-like morphology on the cathode surface, resulting in a high reversible capacity of â¼12 000 mA h g-1 and an extended cycling stability of 100 cycles at 200 mA g-1 with a cut-off capacity of 1000 mA h g-1. The remarkable cell performance is attributed to the fast kinetics of para benzoquinone for the ORR and OER in Li-O2 batteries. The use of a redox mediator in a polymer electrolyte opens a new avenue for practical Li-O2 battery applications in achieving low charge potential and excellent energy efficiency.
RESUMEN
The current research examines the impact of Ca2+ substitution on the phase and electrical properties of (Ba1-xCax)Ti4O9, (x = 0.0, 0.3, 0.6, and 0.9) sintered pellets synthesized by solid-state reaction method. The as-synthesized samples were analyzed using X-ray diffraction (XRD) and impedance spectroscopy. The emergence of orthorhombic phase fit into space group Pnmm was revealed by XRD, and the addition of Ca resulted in a considerable shift in grain size. Dielectric properties were determined using an impedance spectroscopy in a wide frequency range from 1MHz to 3 GHz. The dielectric properties i.e., dielectric constant (εr) and dielectric loss (tanσ), were measured at 3 GHz frequency. The frequency-dependent parameters such as conductivity, dielectric constant, and dielectric loss indicated that the relaxation process is a Maxwell-Wagner type of interfacial polarization. The improved dielectric properties and low energy loss have made (Ba1-xCax)Ti4O9 a prominent energy storage material. This study provides the possibility to improve its dielectric properties and reduce energy loss, making it an excellent energy storage material.
RESUMEN
Flexible PVC/BT (Polyvinyl chloride/Barium Titanate) composite thick films with (0-30%) volume fractions of BaTiO3 were fabricated via the solution casting method. The effects of BaTiO3 filler on the phase, microstructure and dielectric properties of composite films were investigated. The XRD results revealed that BT particles are embedded in the PVC matrix with no chemical reaction taking place between the two phases. It was observed that the glass transition temperature of PVC had increased with the addition of BT. The frequency dispersion in the dielectric constant versus temperature curves indicated the relaxor nature of the composites. The dielectric constant (εr) measured at 40 °C, increased from 7.6 for pure PVC to 16.1 for 30% of BaTiO3 content in PVC polymer matrix. It is suggested that BaTiO3 ceramic powder enhanced the dielectric properties of PVC and may be used as a flexible dielectric material.
RESUMEN
Sn-doped BaTi4O9 (BT4) dielectric ceramics were prepared by a mixed oxide route. Preliminary X-ray diffraction (XRD) structural study shows that the ceramic samples have orthorhombic symmetry with space group (Pnmm). Scanning electron microscopy (SEM) shows that the grain size of the samples decreases with an increase in Sn4+ content. The presence of the metal oxide efficient group was revealed by Fourier transform infrared (FTIR) spectroscopy. The photoluminescence spectra of the ceramic samples reported red color ~ 603, 604, 606.5 and 605 nm with excitation energy ~ 2.06, 2.05, 2.04 and 2.05 eV for Sn4+ content with x = 0.0, 0.3, 0.5, and 0.7, respectively. The microwave dielectric properties of these ceramic samples were investigated by an impedance analyzer. The excellent microwave dielectric properties i.e. high dielectric constant (εr = 57.29), high-quality factor (Qf = 11,852), or low-dielectric loss (3.007) has been observed.
RESUMEN
Thin films of Cd1-xMgxO (CdMgO) (0 ≤ x ≤ 1) were investigated by depositing the films on glass substrates using the co-evaporation technique. The structural, surface morphological, optical, and electrical characteristics of these films were studied as a function of Mg content after annealing at 350 °C. The XRD analysis showed that the deposited films had an amorphous nature. The grain size of the films reduced as the Mg concentration increased, as evidenced by the surface morphology, and EDAX supported the existence of Mg content. It was observed that as the films were annealed, the transmittance of the CdMgO films saw an increase of up to 85%. The blue shift of the absorption edge was observed by the increase of Mg content, which was useful for enhancing the efficiency of solar cells. The optical band gap increased from 2.45 to 6.02 eV as the Mg content increased. With increased Mg content, the refractive index reduced from 2.49 to 1.735, and electrical resistivity increased from 535 Ω cm to 1.57 × 106 Ω cm.
RESUMEN
In this study, we explored the thermoelectric properties of the host thermoelectric materials (TM), namely, binary skutterudites, using a combination of simulations based on density functional theory and post-DFT Boltzmann's semiclassical theory. The calculations were performed close to the Fermi surface for the Seebeck coefficient and other thermoelectric parameters. Our results demonstrated that CoSb3 exhibited the highest Seebeck value at room temperature among all the compounds (CoP3, CoAs3, CoSb3, IrP3, IrAs3, IrSb3, RhAs3, and RhSb3), which confirmed that this compound is an ideal host material for thermoelectric applications. Furthermore, the calculated electrical conductivity values show that RhAs3 has the largest value of 3.736 × 105 Ω-1 m-1. However, at high temperatures, the Seebeck values for all of these compounds are almost constant due to the activation of the minority charge carriers.
