RESUMEN
An approach to the luminance increase of the europium-based OLED is proposed through the formation of the mixed-ligand complex. The introduction of two diverse anionic ligands around one europium ion forming a mixed-ligand complex is confirmed by powder X-ray diffraction, 1H and 19F NMR spectroscopy, MALDI MS spectroscopy, and luminescence spectroscopy. A decrease in the symmetry of the coordination environment leads to a 50% reduction of the lifetime of the excited state. The obtained OLEDs based on mixed ligand europium complexes are significantly superior in luminance to OLEDs based on individual complexes.
RESUMEN
An increase in the efficiency for a terbium-based OLED was achieved by introducing gold nanoparticles into the PEDOT:PSS hole injection layer and was mainly due to the improvement in carrier injection and the reduction of the excited-state lifetime. The introduction of plasmon-resonant gold nanoparticles resulted in a 50% increase in the Tb(czb)3TDZP luminance, which reached 480 cd m-2 and is the highest result for OLEDs based on aromatic carboxylates.
Asunto(s)
Oro , Nanopartículas del Metal , TerbioRESUMEN
New ytterbium complexes K(Solv)x[Yb(Ln)2] (Solv = ethanol and/or water) with 2-tosylaminobenzylidene-aryloylhydrazones (H2L1, aryloyl = benzoyl; H2L2, aryloyl = 2-naphthoyl) demonstrated high solubility and hole mobility (ca. 2.6 × 10-6 cm2 V-1 s-1), while their electron mobility and PLQY were different. The substitution of a benzoyl substituent with naphthoyl resulted in a significant increase of the electron mobility (6.9 × 10-7vs. 1.7 × 10-6 cm2 V-1 s-1) and a decrease of the quantum yield (1.2% vs. 0.6%). As a result, the optimized OLEDs based on the K[Yb(Ln)2] layer demonstrated efficiencies up to 385 µW W-1 and 441 µW W-1, indicating the superior importance of charge mobility over the quantum yield. These are the highest efficiencies of the Yb electroluminescence.
RESUMEN
OLEDs based on lanthanide complexes have decisive optical advantages but are hampered by low brightness. Despite the efforts to optimize several parameters such as quantum yield and charge carrier mobility, there seems to be another key parameter that hinders their performances. Experimental data are therefore collected for mixed-ligand europium complexes with bathophenanthroline and different classes of anionic ligands and screened to identify the key parameter responsible for this situation, which turns out to be the long lifetime of their excited states. A broad literature search supports this conclusion, showing that lanthanide complexes are inferior to other classes of OLED emitters often because of their long lifetimes; furthermore, among a series of lanthanide complexes, the best results are achieved for those with the shortest lifetimes, even though they suffer from low quantum yields.
RESUMEN
The effect of the emission layer deposition method on the characteristics of OLEDs was studied on the example of the europium mixed-ligand complex Eu(tta)3DPPZ (tta: 2-thenoyltrifluoroacetone, DPPZ: dipyrido[3,2-a:2'c,3'c-c]phenazine). The maximum brightnesses of both OLEDs almost coincided, though OLED based on the spin-coated layer operated at lower voltages. The reason for that was the higher density and smoothness of the solution-processed layer.
RESUMEN
New fluorescent D-A-D dyes containing 9-(p-tolyl)-2,3,4,4a,9,9a-hexahydro-1H-carbazole as a donor unit and 2,1,3-benzochalcogenadiazoles as an electron-withdrawing group were synthesized. The photoluminescent and electroluminescent properties of novel dyes for fluorescent OLED application were investigated. It was demonstrated that the replacement of lightweight heteroatoms by heavier ones enables the fine tuning of the maximum emission without significantly reducing the luminescence quantum yield. The maximum quantum yield value of 62.6% for derivatives based on 2,1,3-benzoxadiazole (1a) in cyclohexane was achieved. Two devices with the architecture of glass/ITO/PEDOT-PSS/poly-TPD/EML/TPBi/LiF/Al (EML = emitting layer) were fabricated to check the suitability of the synthesized compounds as a single active emission layer in OLED. These OLEDs exhibited clear red electroluminescence of the dyes with the maximum current efficiency of 0.85 Cd/A.
RESUMEN
The well-known system of dinuclear Cu(I) complexes bridged by 2-(diphenylphosphino)pyridine (PyrPhos) derivatives Cu2X2L3 and Cu2X2LP2 (L = bridging ligand, P = ancillary ligand) goes along with endless variation options for tunability. In this work, the influence of substituents and modifications on the phosphine moiety of the NP-bridging ligand was investigated. In previous studies, the location of the lowest unoccupied molecular orbital (LUMO) of the copper complexes of the PyrPhos family was found to be located on the NP-bridging ligand and enabled color tuning in the whole visible spectrum. A multitude of dinuclear Cu(I) complexes based on the triple methylated 2-(bis(4-methylphenyl)phosphino)-4-methylpyridine (Cu-1b-H, Cu-1b-MeO, and Cu-1b-F) up to complexes bearing 2-(bis(4-fluorophenyl)phosphino)pyridine (Cu-6a-H) with electron-withdrawing fluorine atoms over many other variations on the NP-bridging ligands were synthesized. Almost all copper complexes were confirmed via single crystal X-ray diffraction analysis. Besides theoretical TDDFT-studies of the electronic properties and photophysical measurements, the majority of the phosphino-modified Cu(I) complexes was tested in solution-processed organic light-emitting diodes (OLEDs) with different heterostructure variations. The best results of the OLED devices were obtained with copper emitter Cu-1b-H in a stack architecture of ITO/PEDOT-PSS (50 nm)/poly-TPD (15 nm)/20 wt % Cu(I) emitter:CBP:TcTA(7:3) (45 nm)/TPBi (30 nm)/LiF(1 nm)/Al (>100 nm) with a high brightness of 5900 Cd/m2 and a good current efficiency of 3.79 Cd/A.
RESUMEN
The targeted design of lanthanide-based emitters for solution-processed organic light-emitting diodes (OLEDs) resulted in obtaining an NIR OLED with one of the highest efficiencies among ytterbium-based solution-processed OLEDs (30 µW W-1). The design was aimed at the combination of high luminescence efficiency with solubility and charge carrier mobility. The latter was achieved thanks to the introduction of the purposefully selected neutral ligands, which combine electron mobility and the ability to sensitize lanthanide luminescence. Besides, the HOMO and LUMO energies and charge carrier mobility of solution-processed thin films of coordination compounds were measured experimentally for the first time, and novel highly luminescent europium-based materials with PLQYs of up to 80% and purely NIR luminescent ytterbium complexes were obtained.
RESUMEN
To develop the recently proposed approach toward host selection for lanthanide-based emitters, four phosphine oxides PO = PO1-PO4 were investigated which are able to both increase the electron mobility and to sensitize terbium luminescence. New highly soluble and brightly luminescent terbium complexes TbCl3(PO)·H2O and Tb(pobz)3(PO)·(CH3)2CO (pobz- = phenoxybenzoate) with a quantum yield of up to 100% were synthesized and thoroughly characterized. To study the electroluminescence properties of these materials, a series of solution-processed OLED devices were fabricated and their heterostructures were selected based on the HOMO and LUMO energies of PO1-PO4, which were carefully assessed by the combination of DFT and TDDFT methods. Thus, the effectiveness of the proposed approach was proved, and the influence of the anionic ligand was shown. The maximum OLED luminance reached 75 Cd m-2, which is a high value for solution-processed OLEDs based on terbium complexes.
RESUMEN
We have synthesized Eu(iii) ternary complexes possessing record photoluminescence yields up to 90%. This high luminescence performance resulted from the absence of quenching moieties in the Eu coordination environment and an efficient energy transfer between ligands, combined with a particular symmetry of the coordination environment.
