RESUMEN
We demonstrate a few-mode erbium-doped fiber amplifier employing a mode-selective photonic lantern for controlling the modal content of the pump light. Amplification of six spatial modes in a 5 m long erbium-doped fiber to â¼6.2 dBm average power is obtained while maintaining high modal fidelity. Through mode-selective forward pumping of the two degenerate LP21 modes operating at 976 nm, differential modal gains of <1 dB between all modes and signal gains of â¼16 dB at 1550 nm are achieved. In addition, low differential modal gain for near-full C-band operation is demonstrated.
RESUMEN
We demonstrate the first few-mode-fiber based passive optical network, effectively utilizing mode multiplexing to eliminate combining loss for upstream traffic. Error-free performance has been achieved for 20-km low-crosstalk 3-mode transmission in a commercial GPON system carrying live Ethernet traffic. The alternative approach of low modal group delay is also analyzed with simulation results over 10 modes.
RESUMEN
Low-loss all-fiber photonic lantern (PL) mode multiplexers (MUXs) capable of selectively exciting the first six fiber modes of a multimode fiber (LP01, LP11a, LP11b, LP21a, LP21b, and LP02) are demonstrated. Fabrication of the spatial mode multiplexers was successfully achieved employing a combination of either six step or six graded index fibers of four different core sizes. Insertion losses of 0.2-0.3 dB and mode purities above 9 dB are achieved. Moreover, it is demonstrated that the use of graded index fibers in a PL eases the length requirements of the adiabatic tapered transition and could enable scaling to large numbers.
RESUMEN
Thermocapillary flow has proven to be a good alternative to induce and control the motion of drops and bubbles in microchannels. Temperature gradients are usually established by implanting metallic heaters adjacent to the channel or by including a layer of photosensitive material capable of absorbing radiative energy. In this work we show that single drops can be pumped through capillaries coated with a photoresponsive composite (PDMS + carbon nanopowder) and irradiated with a light source via an optical fiber. Maximum droplet speeds achieved with this approach were found to be ~300 µm/s, and maximum displacements, around 120% of the droplet length. The heat generation capacity of the coatings was proven having either a complete coating over the capillary surface or a periodic array of pearls of the photoresponsive material along the capillary produced by the so-called Rayleigh-Plateau instability. The effect of the photoresponsive layer thickness and contact angle hysteresis of the solid-liquid interface were found to be important parameters in the photoinduced thermocapillary effect. Furthermore, a linear relationship between the optical intensity I(o) and droplet velocity v was found for a wide range of the former, allowing us to analyze the results and estimate response times for heat transfer using heat conduction theory.