Development and validation of a direct, non-destructive quantitative method for medroxyprogesterone acetate in a pharmaceutical suspension using FT-Raman spectroscopy.

A simple linear regression method was developed and statistically validated for the direct and non-destructive quantitative analysis--without sample preparation--of the active pharmaceutical ingredient (API) medroxyprogesterone acetate (MPA) in an aqueous pharmaceutical suspension (150 mg in 1.0 ml) using FT-Raman spectroscopy. The linear regression was modelled by plotting the highest peak intensity of the vector normalized spectral band between 1630 and 1590 cm-1 against different MPA standard suspension concentrations. At this band, no spectral interferences from additives in the suspension are observed. The validated model was used for the quantification of a commercial suspension (150 mg in 1.0 ml) of the commercialized preparations. The same standards and samples were used, respectively, for the development and validation of a simple linear regression model and for the quantitative determination by means of HPLC-with sample preparation-as described for the related substances of MPA in the Ph. Eur. IV. The quantification results obtained by the FT-Raman method corresponded with the claimed label concentration (150.01+/-0.96 mg/ml (n=6)). Applying the HPLC method, however, a systematic error was observed (157.77+/-0.94 mg/ml (n=6)). The direct FT-Raman method hence appears the most reliable for the quantification of the MPA component in suspension, compared to the HPLC method that requires sample preparation. The latter method provides a systematic error because the exact volume or density of a suspension sample is unknown. A precise isolation of fixed volumes from a suspension is rather unfeasible because of the continuous sagging of the suspended particles and their sticking to the used materials in the isolation process.

The quality of essential antimicrobial and antimalarial drugs marketed in Rwanda and Tanzania: influence of tropical storage conditions on in vitro dissolution.

OBJECTIVE: The quality of 33 formulations of essential antimicrobial and antimalarial drugs (amoxicillin capsules, metronidazole tablets, sulfamethoxazole/trimethoprim tablets, quinine tablets and sulphadoxine/pyrimethamine tablets) marketed in Rwanda and Tanzania was assessed and the influence of tropical storage conditions on potency and in vitro dissolution investigated. METHODS: Drug content and in vitro dissolution were determined immediately after purchase and during 6-month storage under simulated tropical conditions (75% relative humidity, 40 degrees C) using the methods described in the USP 24 monographs on the drugs concerned. RESULTS AND DISCUSSION: At the time of purchase, the drug content of all the formulations was within the limits recommended by the USP 24, but after 6-month storage, the drug content of one sulfamethoxazole/trimethoprim and one quinine formulation were found to be substandard. Immediately after purchase, four formulations (three sulfamethoxazole/trimethoprim and one sulphadoxine/pyrimethamine combination) failed the USP 24 dissolution test. Except for three metronidazole and one quinine formulations, dissolution tests performed after 6 months of storage under simulated tropical conditions showed that drug release remained within the USP 24 recommended values. CONCLUSION: In both countries, essential drug formulations met pharmacopoeial potency requirements, but some had a poor in vitro drug release profiles. Some of the formulations tested were not stable upon storage under simulated tropical conditions.

In-line monitoring of a pharmaceutical blending process using FT-Raman spectroscopy.

FT-Raman spectroscopy (in combination with a fibre optic probe) was evaluated as an in-line tool to monitor a blending process of diltiazem hydrochloride pellets and paraffinic wax beads. The mean square of differences (MSD) between two consecutive spectra was used to identify the time required to obtain a homogeneous mixture. A traditional end-sampling thief probe was used to collect samples, followed by HPLC analysis to verify the Raman data. Large variations were seen in the FT-Raman spectra logged during the initial minutes of the blending process using a binary mixture (ratio: 50/50, w/w) of diltiazem pellets and paraffinic wax beads (particle size: 800-1200 microm). The MSD-profiles showed that a homogeneous mixture was obtained after about 15 min blending. HPLC analysis confirmed these observations. The Raman data showed that the mixing kinetics depended on the particle size of the material and on the mixing speed. The results of this study proved that FT-Raman spectroscopy can be successfully implemented as an in-line monitoring tool for blending processes.

Drug formulations intended for the global market should be tested for stability under tropical climatic conditions.

RATIONALE OBJECTIVE: The quality of drugs imported into developing countries having a tropical climate may be adversely affected if their formulations have not been optimized for stability under these conditions. The present study investigated the influence of tropical climate conditions (class IV: 40 degrees C, 75% relative humidity) on the drug content, in vitro dissolution and oral bioavailability of different formulations of two essential drugs marketed in Tanzania: diclofenac sodium and ciprofloxacin tablets. METHODS: Before and after 3 and 6 months storage under class IV conditions the drug content and in vitro dissolution were evaluated using United States Pharmacopoeia (USP) 24 methods. Following a randomized four-period cross-over study, the pharmacokinetic parameters of drug formulations stored for 3 months under class IV conditions were compared with those stored at ambient conditions. RESULTS: Drug content and drug release from all tested ciprofloxacin formulations were within USP-24 requirements and remained stable during storage at simulated tropical conditions. Oral bioavailability was also not influenced by tropical conditions. The dissolution rate of two diclofenac formulations (Diclo 50 manufactured by Camden and Dicloflame 50 manufactured by Intas) reduced significantly during storage under class IV conditions. After oral administration Camden tablets stored for 3 months under class IV conditions showed a reduction in C(max) (90% CI of C(max) ratio: 0.59 - 0.76). This reduction was smaller than expected based on the in vitro tests. CONCLUSIONS: Some drug formulations imported into Tanzania are not optimized for stability in a tropical climate. Manufacturers and regulatory authorities should pay more attention to the WHO recommendations for testing the stability of drugs under tropical climate conditions. Efforts should be made to improve the in vitro tests to better predict the bioavailability.

Wax beads as cushioning agents during the compression of coated diltiazem pellets.

Placebo particles were mixed with film-coated diltiazem pellets to evaluate them as cushioning agents during tabletting in order to protect the film coat from damage. The cushioning properties of alpha-lactose monohydrate granules, microcrystalline cellulose pellets and wax/starch beads were evaluated by comparing the dissolution profile of the coated pellets before and after compression (compression force 10 kN). Only the tablet formulations containing wax/starch beads provided protection to the film coat. However, the dissolution rate of tablets formulated with waxy maltodextrin/paraffinic wax placebo beads was too slow as the tablets did not disintegrate. Adding 50% (w/w) drum-dried corn starch/Explotab/paraffinic wax beads to the formulation was the optimal amount of cushioning beads to provide sufficient protection for the film coat and yield disintegrating tablets. Using a compression simulator, the effect of precompression force and compression time on the dissolution rate was found to be insignificant. The diametral crushing strength of tablets containing 50% (w/w) drum-dried corn starch/Explotab/paraffinic wax beads was about 25.0 N (+/-0.3 N), with a friability of 0.4% (+/-0.04%). This study demonstrates that adding deformable wax pellets minimizes the damage to film-coated pellets during compression.

In vivo evaluation of matrix pellets containing nanocrystalline ketoprofen.

The aim of this study was to evaluate the in-vivo behaviour of matrix pellets formulated with nanocrystalline ketoprofen after oral administration to dogs. No significant differences in AUC-values were seen between pellet formulations containing nanocrystalline or microcrystalline ketoprofen and a commercial ketoprofen formulation (reference: Rofenid 200 Long Acting). C(max) of the formulations containing nano- or microcrystalline ketoprofen was significantly higher compared to reference, whereas t(max) was significantly lower. The in-vivo burst release observed for the spray dried nanocrystalline ketoprofen matrix pellets was reduced following compression of the pellets in combination with placebo wax/starch pellets. These matrix tablets sustained the ketoprofen plasma concentrations during 5.6 and 5.4 h for formulations containing nano- and microcrystalline ketoprofen, respectively.

An oral controlled release matrix pellet formulation containing nanocrystalline ketoprofen.

A controlled release pellet formulation using a NanoCrystal colloidal dispersion of ketoprofen was developed. In order to be able to process the aqueous NanoCrystal colloidal dispersion into a hydrophobic solid dosage form a spray drying procedure was used. The in vitro dissolution profiles of wax based pellets loaded with nanocrystalline ketoprofen are compared with the profiles of wax based pellets loaded with microcrystalline ketoprofen and of a commercial sustained release ketoprofen formulation. Pellets were produced using a melt pelletisation technique. All pellet formulations were composed of a mixture of microcrystalline wax and starch derivatives. The starch derivatives used were waxy maltodextrin and drum dried corn starch. Varying the concentration of drum dried corn starch increased the release rate of ketoprofen but the ketoprofen recovery remained problematic. To increase the dissolution yield surfactants were utilised. The surfactants were either added during the production process of the NanoCrystal colloidal dispersion (sodium laurylsulphate) or during the pellet manufacturing process (Cremophor RH 40). Both methods resulted in a sustained but complete release of nanocrystalline ketoprofen from the matrix pellet formulations.

Esophageal metastasis from breast carcinoma.

A case of esophageal metastasis from a breast carcinoma is presented. Location was, as usual, midesophageal. The interval of time between breast carcinoma and the onset of esophageal symptoms was rather long. Barium swallow examination enabled correct diagnosis, whereas several series of superficial endoscopical biopsies were negative. Diagnosis was confirmed by deep endoscopical biopsy.

The reversal sign.

We report a 36-year-old woman with a bacterial meningitis. CT after resuscitation showed a striking "reversal sign." Opinions on the pathogenesis of this sign are discussed; it indicates serious brain damage and carries a poor prognosis.

Forensic determination of pregnancy hormones in human bloodstains.

When different bloodstains are encountered at the scene of crime, it is possible to discriminate those from a pregnant woman from others. Human chorionic gonadotrophin, human placental lactogen, total oestriol and progesterone in the stains may be determined with radioimmunoassay techniques using commercial kits. Only 1 cm2 of bloodstain is needed for the determination of all four parameters, which gives information about the state of pregnancy. More than 100 stains of blood from women in all stages of pregnancy, normal menstruating women, menopausal and post-menopausal women and male subjects, and of menstrual blood were analysed. Bloodstains from pregnant women were easy to evaluate with the four determinations, only very early pregnancies being undetected. Stains from non-pregnant women were negative or below the cut-off level. Two case examples are also described.