Probing Water and CO2 Interactions at the Surface of Collapsed Titania Nanotubes Using IR Spectroscopy.

Collapsed titania nanotubes (cTiNT) were synthesized by the calcination of titania nanotubes (TiNT) at 650 °C, which leads to a collapse of their tubular morphology, a substantial reduction in surface area, and a partial transformation of anatase to the rutile phase. There are no significant changes in the position of the XPS responses for Ti and O on oxidation or reduction of the cTiNTs, but the responses are more symmetric than those observed for TiNTs, indicating fewer surface defects and no change in the oxidation state of titanium on oxidative and/or reductive pretreatment. The interaction of H2O and CO2 with the cTiNT surface was studied. The region corresponding to OH stretching absorptions extends below 3000 cm(-1), and thus is broader than is typically observed for absorptions of the OH stretches of water. The exchange of protons for deuterons on exposure to D2O leads to a depletion of this extended absorption and the appearance of new absorptions, which are compatible with deuterium exchange. We discuss the source of this extended low frequency OH stretching region and conclude that it is likely due to the hydrogen-bonded OH stretches. Interaction of the reduced cTiNTs with CO2 leads to a similar but smaller set of adsorbed carbonates and bicarbonates as reported for reduced TiNTs before collapse. Implications of these observations and the presence of proton sources leading to hydrogen bonding are discussed relative to potential chemical and photochemical activity of the TiNTs. These results point to the critical influence of defect structure on CO2 photoconversion.

Effect of Dimensionality on the Photocatalytic Behavior of Carbon-Titania Nanosheet Composites: Charge Transfer at Nanomaterial Interfaces.

Due to their unique optoelectronic structure and large specific surface area, carbon nanomaterials have been integrated with titania to enhance photocatalysis. In particular, recent work has shown that nanocomposite photocatalytic performance can be improved by minimizing the covalent defect density of the carbon component. Herein, carbon nanotube-titania nanosheet and graphene-titania nanosheet composites with low carbon defect densities are compared to investigate the role of carbon nanomaterial dimensionality on photocatalytic response. The resulting 2D-2D graphene-titania nanosheet composites yield superior electronic coupling compared to 1D-2D carbon nanotube-titania nanosheet composites, leading to greater enhancement factors for CO2 photoreduction under ultraviolet irradiation. On the other hand, 1D carbon nanotubes are shown to be more effective titania photosensitizers, leading to greater photoactivity enhancement factors under visible illumination. Overall, this work suggests that carbon nanomaterial dimensionality is a key factor in determining the spectral response and reaction specificity of carbon-titania nanosheet composite photocatalysts.

Identification of binding sites for acetaldehyde adsorption on titania nanorod surfaces using CIMS.

The interaction of acetaldehyde with TiO(2) nanorods has been studied under low pressures (acetaldehyde partial pressure range 10(-4)-10(-8) Torr) using chemical ionization mass spectrometry (CIMS). We quantitatively separate irreversible adsorption, reversible adsorption, and an uptake of acetaldehyde assigned to a thermally activated surface reaction. We find that, at room temperature and 1.2 Torr total pressure, 2.1 ± 0.4 molecules/nm(2) adsorb irreversibly, but this value exhibits a sharp decrease as the analyte partial pressure is lowered below 4 × 10(-4) Torr, regardless of exposure time. The number of reversible binding sites at saturation amounts to 0.09 ± 0.02 molecules/nm(2) with a free energy of adsorption of 43.8 ± 0.2 kJ/mol. We complement our measurements with FTIR spectroscopy and identify the thermal dark reaction as a combination of an aldol condensation and an oxidative adsorption that converts acetaldehyde to acetate or formate and CO, at a measured combined initial rate of 7 ± 1 × 10(-4) molecules/nm(2) s. By characterizing binding to different types of sites under dark conditions in the absence of oxygen and gas phase water, we set the stage to analyze site-specific photoefficiencies involved in the light-assisted mineralization of acetaldehyde to CO(2).

Minimizing graphene defects enhances titania nanocomposite-based photocatalytic reduction of CO2 for improved solar fuel production.

With its unique electronic and optical properties, graphene is proposed to functionalize and tailor titania photocatalysts for improved reactivity. The two major solution-based pathways for producing graphene, oxidation-reduction and solvent exfoliation, result in nanoplatelets with different defect densities. Herein, we show that nanocomposites based on the less defective solvent-exfoliated graphene exhibit a significantly larger enhancement in CO(2) photoreduction, especially under visible light. This counterintuitive result is attributed to their superior electrical mobility, which facilitates the diffusion of photoexcited electrons to reactive sites.

Role of water and carbonates in photocatalytic transformation of CO2 to CH4 on titania.

Using the electron paramagnetic resonance technique, we have elucidated the multiple roles of water and carbonates in the overall photocatalytic reduction of carbon dioxide to methane over titania nanoparticles. The formation of H atoms (reduction product) and (•)OH radicals (oxidation product) from water, and CO(3)(-) radical anions (oxidation product) from carbonates, was detected in CO(2)-saturated titania aqueous dispersion under UV illumination. Additionally, methoxyl, (•)OCH(3), and methyl, (•)CH(3), radicals were identified as reaction intermediates. The two-electron, one-proton reaction proposed as an initial step in the reduction of CO(2) on the surface of TiO(2) is supported by the results of first-principles calculations.