Dynamic Models of Within-Herd Transmission and Recommendation for Vaccination Coverage Requirement in the Case of African Swine Fever in Vietnam.

African swine fever (ASF) is a highly contagious disease that is caused by the ASF virus (ASFV) with a high fatality rate in domestic pigs resulting in a high socio-economic impact. The pig business in Vietnam was recently affected by ASF for the first time. This study thus aimed to develop a disease dynamic model to explain how ASFV spreads in Vietnamese pig populations and suggest a protective vaccine coverage level required to prevent future outbreaks. The outbreak data were collected from ten private small-scale farms within the first wave of ASF outbreaks in Vietnam. Three methods were used to estimate the basic reproduction number (R0), including the exponential growth method, maximum likelihood method, and attack rate method. The average R0 values were estimated at 1.49 (95%CI: 1.05-2.21), 1.58 (95%CI: 0.92-2.56), and 1.46 (95%CI: 1.38-1.57), respectively. Based on the worst-case scenario, all pigs in a herd would be infected and removed within 50 days. We suggest vaccinating at least 80% of pigs on each farm once a commercially approved ASF vaccine is available. However, an improvement in biosecurity levels in small-scale farms is still greatly encouraged to prevent the introduction of the virus.

Estimation of the herd-level basic reproduction number for African swine fever in Vietnam, 2019.

Background and Aim: African swine fever (ASF) is a notifiable viral disease of pigs and wild boars that causes severe economic losses to the swine industry. The pig industry in Vietnam was recently attacked by the ASF virus (ASFV) for the first time in history. However, we lack information regarding the transmissibility of ASF within indoor production systems communities, such as those in Vietnam. Therefore, we aimed to estimate the basic reproduction number (R0) for ASF during the early stages of transmission between farms in indoor production system communities from local and national data in Vietnam. Materials and Methods: The linear regression model approach for the susceptible infectious method was used in this study to estimate the transmission rate and, consequently, the R0 value. Results: The R0 values between-farm of ASF ranged from 1.41 to 10.8 in different scenarios of infectious period duration, from 15 to 30 days at the national and local levels. Conclusion: These results help to understand the scale and speed of ASF infection in Vietnam and to provide a scientific basis to implement control measures to restrict the spread of ASFV in other locations.

Steatite Powder Additives in Wood-Cement Drywall Particleboards.

The objective of this study was to develop a new drywall wood-based particleboard as an alternative to gypsum board. Various development iterations have led to the use of wood particles, steatite powder and Portland cement. The resulting outcome shows that screw withdrawal resistance was improved by 37% and bending properties by 69% compared to gypsum board of a similar density (0.68-0.70). The raw surface of the boards is of good quality and comparable to the paper-faced surface of gypsum board. Furthermore, the reaction to fire was evaluated through bench-scale test with a cone calorimeter. The investigated particleboard did not reveal visual signs of combustion after 20 min when exposed to a radiant heat of 50 kW/m2, while burning of the overlay paper of gypsum board occurred at about 57 s, suggesting that wood-cement-steatite powder particleboard could be classified as a quasi non-combustible material.

The Effect of Wood Ash as a Partial Cement Replacement Material for Making Wood-Cement Panels.

The aim of this study was to consider the use of biomass wood ash as a partial replacement for cement material in wood-cement particleboards. Wood-cement-ash particleboards (WCAP) were made with 10%, 20%, 30%, 40%, and 50% of wood ash as a partial replacement for cement with wood particles and tested for bending strength, stiffness, water absorption, and thermal properties. Test results indicate that water demand increases as the ash content increases, and the mechanical properties decrease slightly with an increase of the ash content until 30% of replacement. On the other hand, the heat capacity increases with the wood ash content. The WCAP can contribute to reducing the heat loss rate of building walls given their relatively low thermal conductivity compared to gypsum boards. The replacement of cement to the extent of approximately 30% by weight was found to give the optimum results.

Preparation of functionalized alkylmagnesium derivatives using an I/Mg-exchange.

Functionalized alkylmagnesium reagents bearing an acetal, a ketal, an ester, or a pyridine ring were prepared by an I/Mg-exchange using iPr2Mg.LiCl or ClMg(CH2)5MgCl.2LiCl starting from functionalized primary alkyl iodides.

Grignard reagents: alkoxide-directed iodine-magnesium exchange at sp3 centers.

Sequential addition of i-PrMgCl and BuLi to sp3 hybridized iodoalcohols triggers a facile iodine-metal exchange. Intercepting the resulting cyclic Grignard reagents with a slight excess of an electrophile leads to a diverse range of substituted alcohols. The iodine-magnesium exchange strategy is effective with 3-carbon iodoalcohols bearing alkyl substitutents on the carbinol or adjacent carbons and with the chain-extended homolog 4-iodobutan-1-ol.

Metalated nitriles: chelation-controlled cyclizations to cis and trans hydrindanes and decalins.

Chelation provides a powerful means of stereocontrol in alkylations of metalated nitriles. Doubly deprotonating a series of cyclic beta-hydroxynitriles triggers cyclizations that implicate metalated nitrile intermediates having configurations imposed by chelation with an adjacent, chiral lithium alkoxide. Identifying chelation as a general stereocontrol element explains several previously anomalous alkylations of metalated nitriles and provides a potential solution to the long-standing difficulty of synthesizing trans-hydrindanes. Employing chelation to control the metalated nitrile geometry permits selective cyclizations to cis and trans hydrindanes and decalins and provides key insight into the geometrical requirements of these demanding cyclizations.

Highly functionalized organomagnesium reagents prepared through halogen-metal exchange.

Organomagnesium reagents occupy a central position in synthetic organic and organometallic chemistry. Recently, the halogen-magnesium exchange has considerably extended the range of functionalized Grignard reagents available for synthetic purposes. Functional groups such as esters, nitriles, iodides, imines, or even nitro groups can be present in a wide range of aromatic and heterocyclic organomagnesium reagents. Also various highly functionalized alkenyl magnesium species can be prepared. These recent developments as well as new applications of organomagnesium reagents in cross-coupling reactions and amination reactions will be covered in this Review.