Measuring the Electrical Resistivity of Liquid Iron to 1.4 Mbar.

We determined the electrical resistivity of liquid Fe to 135 GPa and 6680 K using a four-probe method in a diamond-anvil cell combined with two novel techniques: (i) enclosing a molten Fe in a sapphire capsule, and (ii) millisecond time-resolved simultaneous measurements of the resistance, x-ray diffraction, and temperature of instantaneously melted Fe. Our results show the minimal temperature dependence of the resistivity of liquid Fe and its anomalous resistivity decrease around 50 GPa, likely associated with a gradual magnetic transition, both in agreement with previous ab initio calculations.

Low-spin ferric iron in primordial bridgmanite crystallized from a deep magma ocean.

The crystallization of the magma ocean resulted in the present layered structure of the Earth's mantle. An open question is the electronic spin state of iron in bridgmanite (the most abundant mineral on Earth) crystallized from a deep magma ocean, which has been neglected in the crystallization history of the entire magma ocean. Here, we performed energy-domain synchrotron Mössbauer spectroscopy measurements on two bridgmanite samples synthesized at different pressures using the same starting material (Mg0.78Fe0.13Al0.11Si0.94O3). The obtained Mössbauer spectra showed no evidence of low-spin ferric iron (Fe3+) from the bridgmanite sample synthesized at relatively low pressure of 25 gigapascals, while that directly synthesized at a higher pressure of 80 gigapascals contained a relatively large amount. This difference ought to derive from the large kinetic barrier of Fe3+ rearranging from pseudo-dodecahedral to octahedral sites with the high-spin to low-spin transition in experiments. Our results indicate a certain amount of low-spin Fe3+ in the lower mantle bridgmanite crystallized from an ancient magma ocean. We therefore conclude that primordial bridgmanite with low-spin Fe3+ dominated the deeper part of an ancient lower mantle, which would contribute to lower mantle heterogeneity preservation and call for modification of the terrestrial mantle thermal evolution scenarios.

A cylindrical SiC heater for an externally heated diamond anvil cell to 1500 K.

Semiconductor-based heaters for diamond anvil cells (DACs) have advantages over metal wire heaters in terms of repeated use and the ability to reach higher temperatures. We introduce a cylindrical SiC heater for an externally heated DAC (EHDAC) that works satisfactorily at temperatures up to 1500 K and pressures around 90 GPa. The heater is reusable and inexpensive, and only slight modifications to the DAC are required to fit the heater. Experiments on melting of NaCl and gold are conducted at ambient pressure to test the temperature accuracy of the EHDAC system, and resistance measurements on iodine at high pressures and temperatures are performed to assess the heater assembly. These test runs show that a uniform and accurate temperature can be maintained by the EHDAC assembly, which has potential applications to a variety of transport property measurements.

Laboratory-based x-ray computed tomography for 3D imaging of samples in a diamond anvil cell in situ at high pressures.

Three-dimensional (3D) visualization of a material under pressure can provide a great deal of information about its physical and chemical properties. We developed a technique combining in-house x-ray computed tomography (XCT) and a diamond anvil cell to observe the 3D geometry of a sample in situ at high pressure with a spatial resolution of about 610 nm. We realized observations of the 3D morphology and its evolution in minerals up to a pressure of 55.6 GPa, which is comparable to the pressure conditions reported in a previous synchrotron XCT study. The new technique developed here can be applied to a variety of materials under high pressures and has the potential to provide new insights for high-pressure science and technology.