On-Chip Ultralow-Threshold Tunable CdSSe Nanobelt Lasers Excited by the Emission of Linked ZnO Nanowire.

The integration of optical waveguide and on-chip nanolasers source has been one of the trends in photonic devices. For on-chip nanolasers, the integration of nanowires and high antidamage ability are imperative. Herein, we realized the on-chip ultralow-threshold and wavelength-tunable lasing from alloyed CdSSe nanobelt chip that is excited by the emission from linked ZnO nanowires. ZnO nanowire arrays are integrated into CdSSe nanobelt chips by the dry transfer method. A one-dimensional (1D) ZnO nanowire forms high-quality optical resonators and serves as an indirect pumping light to stimulate CdSSe nanobelt chips, and then wavelength-tunable lasing is generated with the ultralow threshold of 3.88 µW. The lasing mechanism is quite different than direct excitation by nanosecond laser pulse and indirect pumping by ZnO emission. The ZnO-CdSSe blocks provide a new solution to realize nanowire lasing from linked nanowires rather than direct laser pumping and thus avoid the light direct damage under general nanosecond laser excitation.

Determination of detonation characteristics by laser-induced plasma spectra and micro-explosion dynamics.

Determination of macroscale detonation parameters of energetic materials (EMs) in a safe and rapid way is highly desirable. However, traditional experimental methods suffer from tedious operation, safety hazards and high cost. Herein, we present a micro-scale approach for high-precision diagnosis of explosion parameters based on radiation spectra and dynamic analysis during the interaction between laser and EMs. The intrinsic natures of micro-explosion dynamics covering nanosecond to millisecond and chemical reactions in laser-induced plasma are revealed, which reveal a tight correlation between micro-detonation and macroscopic detonation based on laser-induced plasma spectra and dynamics combined with statistic ways. As hundreds to thousands of laser pulses ablate on seven typical tetrazole-based high-nitrogen compounds and ten single-compound explosives, macroscale detonation performance can be well estimated with a high-speed and high-accuracy way. Thereby, the detonation pressure and enthalpies of formation can be quantitatively determined by the laser ablation processes for the first time to our knowledge. These results enable us to diagnose the performance of EMs in macroscale domain from microscale domain with small-dose, low-cost and multiple parameters.

Toward High-Performance Self-Driven Photodetectors via Multistacking Van der Waals Heterostructures.

The unique optoelectronic properties of layered van der Waals (vdW) heterostructures open up exciting opportunities for high-performance photodetectors. Self-driven photodetectors are desirable for reducing power consumption and minimizing the device size. Here, a semiconductor-insulator-semiconductor-type multistacking WSe2/graphene/h-BN/MoS2 vdW heterostructure is demonstrated to realize an enhanced self-powered photodetector with a high on-off current ratio of about 1.2 × 105 and a high photoresponsivity of 3.6 A/W without applying bias, which is the highest photoresponsivity ever reported for self-powered photodetectors. Because of the difference in the Fermi level, a built-in electrical field is formed at the WSe2/graphene junction, where the photoexcited electrons and holes can be efficiently separated and the carriers can easily tunnel through the MoS2/h-BN junction driven by the enhanced potential. Therefore, the enhanced self-powered photodetection is attributable to highly efficient carrier tunneling through large h-BN electron barriers. By comparison, when the stacking sequence is changed to make WSe2/MoS2 p-n heterojunctions lay on graphene/h-BN, the self-powered photocurrent is still generated because of the type-II band alignment, which exhibits lower but still relevant values with a light on/off ratio of ∼8 × 103 and a photoresponsivity of ∼2.39 A/W. The efficient enhancement demonstrates that multistacking heterostructures significantly elevate the performance of self-powered photodetectors, providing a feasible route to develop high-performance self-powered optoelectronic devices and extend their applications in integrated optoelectronic systems.

On-chip programmable optical switch based on CdS multibranched nanowire arrays.

Micro/nano optoelectronic devices are widely studied as basic building blocks for on-chip integrated microsystem and multichannel logic units with excellent optoelectronic properties that are especially important part for interconnection route construction. Here, based on anisotropic waveguides, an optical switch with an on/off ratio of 2.14 is built up in a 2D CdS branched nanowire array. Because the branches are obliquely distributed at the same side of the trunk in a highly ordered form, the guided photoluminescence (PL) intensity from the trunk into the branch tightly relates to its angle. Based on the different intensity of the guided PL emitted from the end of each branch, the position of the incident spot in the backbone area can be identified accurately, making a feasible construction of an on-chip position-sensitive detector to realize an all-optical information process.

Comparative Studies on Two-Dimensional (2D) Rectangular and Hexagonal Molybdenum Dioxide Nanosheets with Different Thickness.

Molybdenum dioxide (MoO2) a kind of semi-metal material shows many unique properties, such as high melting point, good thermal stability, large surface area-to-volume ratio, high-density surface unsaturated atoms, and excellent conductivity. There is a strong connection between structural type and optoelectronic properties of 2D nanosheet. Herein, the rectangular and hexagonal types of thin and thick MoO2 2D nanosheets were successfully prepared from MoO3 powder using two-zone chemical vapor deposition (CVD) with changing the experimental parameters, and these fabricated nanosheets displayed different colors under bright-field microscope, possess margins and smooth surface. The thickness of the blue hexagonal and rectangular MoO2 nanosheets are ~ 25 nm and ~ 30 nm, respectively, while typical thickness of orange-colored nanosheet is around ~ 100 nm. Comparative analysis and investigations were carried out, and mix-crystal phases were indentified in thick MoO2 as main matrix through Raman spectroscopy. For the first time, the emission bands obtained in thick MoO2 nanosheets via a Cathodoluminescence (CL) system exhibiting special properties of semi-metallic and semi-conductors; however, no CL emission detected in case of thin nanosheets. The electrical properties of thin MoO2 nanosheets with different morphologies were compared, and both of them demonstrated varying metallic properties. The resistance of thin rectangular nanosheet was ~ 25 Ω at ± 0.05 V while 64 Ω at ± 0.05 V was reported for hexagonal nanosheet, and observed lesser resistance by rectangular nanosheet than hexagonal nanosheet.

CdSSe nanowire-chip based wearable sweat sensor.

BACKGROUND: Sweat, as an easily accessible bodily fluid, is enriched with a lot of physiological and health information. A portable and wearable sweat sensor is an important device for an on-body health monitoring. However, there are only few such devices to monitor sweat. Based on the fact that sweat is mainly composed of moisture and salt which is much more abundant than other trace ions in sweat, a new route is proposed to realize wearable sweat sensors using CdSSe nanowire-chips coated with a polyimide (PI) membrane. RESULTS: Firstly, the composition-graded CdS1-xSex (x = 0-1) nanowire-chip based sensor shows good photo-sensitivity and stress sensitivity which induces linear humidity dependent conductivity. This indicates good moisture response with a maximum responsivity (dI/I) 244% at 80% relative humidity (RH) even in the dark. Furthermore, the linear current decrease with salt increase illustrates the chip sensor has a good salt-sensing ability with the best salt dependent responsivity of 80%, which guarantees the high prediction accuracy in sweat sensing. The sensor current is further proven to nonlinearly correlate to the amount of sweat with excellent stability, reproducibility and recoverability. The wearable sweat sensor is finally applied on-body real-time sweat analysis, showing good consistence with the body status during indoor exercise. CONCLUSIONS: These results suggest that this CdSSe nanowire-chip based PI-coated integrated sensor, combined with inorganic and organic functional layers, provides a simple and reliable method to build up diverse portable and wearable devices for the applications on healthcare and athletic status.

Lithium ion detection in liquid with low detection limit by laser-induced breakdown spectroscopy.

Lithium (Li), as the lightest metal and the most important powerful material in battery fabrication, is widely used in many fields. The fast detection of Li is necessary for industrial application. The slow-speed detection methods, including atomic absorption spectroscopy and inductively coupled plasma mass spectroscopy with high accuracy and low limit of detection, are hard to utilize in in situ industrial control due to complex prepreparation of samples. Here, through the analysis of the typical spectrum line at Li I 670.79 nm, Li ions in water were detected quantitatively in 1 min, including sample preparation by laser-induced breakdown spectroscopy (LIBS) with filter paper as the adsorption substrate. The calibration curve by polynomial function fitting is used to predict the Li+ concentration. The limit of detection (LOD) as low as 18.4 ppb is obtained, which is much lower than the results ever reported by using filter paper. The related factor R2 reaches 99%, and the prediction error is lower than 2%, proving the fast and online monitor for Li+ by LIBS is feasible. Furthermore, by comparison with the results with filter paper enrichment, the Li+ detection from water directly shows higher LOD to 10.5 ppm. Moreover, the plasma images, by gate-controlled intensified charge-coupled device, illustrate a different morphology and evolution between that on water surface and filter paper surface through visual observation. This study provides experimental and theoretical experience in a fast way for the quantitative detection of the lightest metal ion (Li+) in liquid.

Accuracy enhancement of laser induced breakdown spectroscopy by safely low-power discharge.

Improvement in detection accuracy is an important and hot topic for laser induced breakdown spectroscopy (LIBS). Discharged-pulse assisted (DPA) plasma has been investigated as an effective way to enhance analytical capabilities and accuracy of LIBS. Most of reported DPA experiments have been performed using high voltage and power to comprehend spectrum enhancement. For safety concerns and maneuverability of LIBS equipment; low power and small current discharge are viable for industrial application. In this paper, the enhanced spectra with many extra peaks and higher line intensities were also detected, realized by a low-power discharge assisted LIBS (Max. 2.8 kV and ~1 mA), which are much lower than reported in literature ~MW discharge. The number of atomic peaks of the sample increases, on the other hand, and gradual peaks become stronger with the increase of discharged HV from 1 kV to 1.5 kV, 1.75 kV, 2 kV, 2.5 kV and 2.8 kV. The discharge current increases from 0.2 mA to 1.5 mA, which is almost threshold discharge voltage. After processing, the original spectra, including the peak shift and peak correction by statistics and physics, resulted in achievement of better line stability in terms of relative standard deviation (RSD) of ash, carbon, and volatile coal samples with root mean square error prediction (RMSEP) of 0.4864, 0.3682, 0.3374 and the linear regression coefficient R2 = 0.99, 0.99,0.98, respectively. The result proposes a promising method to improve detection accuracy of LIBS with simple setup, high safety and low-cost.