RESUMEN
Crystalline carriers such as dextrose, sucrose, galactose, mannitol, sorbitol, and isomalt have been reported to increase the solubility, and dissolution rates of poorly soluble drugs when employed as carriers in solid dispersions (SDs). However, synthetic polymers dominate the preparation of drugs: excipient SDs have been created in recent years, but these polymer-based SDs exhibit the major drawback of recrystallisation upon storage. Also, the use of high-molecular-weight polymers with increased chain lengths brings forth problems such as increased viscosity and unnecessary bulkiness in the resulting dosage form. An ideal SD carrier should be hydrophilic, non-hygroscopic, have high hydrogen-bonding propensity, have a high glass transition temperature (Tg), and be safe to use. This review discusses sugars and polyols as suitable carriers for SDs, as they possess several ideal characteristics. Recently, the use of low-molecular-weight excipients has gained much interest in developing SDs. However, there are limited options available for safe, low molecular excipients, which opens the door again for sugars and polyols. The major points of this review focus on the successes and failures of employing sugars and polyols in the preparation of SDs in the past, recent advances, and potential future applications for the solubility enhancement of poorly water-soluble drugs.
RESUMEN
The WHO Biopharmaceutical Classification System (BCS) is a practical tool to identify active pharmaceutical ingredients (APIs) that scientifically qualify for a waiver of in vivo bioequivalence studies. The focus of this study was to engage a global network of laboratories to experimentally quantify the pH-dependent solubility of the highest therapeutic dose of 16 APIs using a harmonized protocol. Intra-laboratory variability was ≤5 %, and no apparent association of inter-laboratory variability with API solubility was discovered. Final classification "low solubility" vs "high solubility" was consistent among laboratories. In comparison to the literature-based provisional 2006 WHO BCS classification, three compounds were re-classified from "high" to "low-solubility". To estimate the consequences of these experimental solubility results on BCS classification, dose-adjusted in silico predictions of the fraction absorbed in humans were performed using GastroPlus®. Further expansion of these experimental efforts to qualified APIs from the WHO Essential Medicines List is anticipated to empower regulatory authorities across the globe to issue scientifically-supported guidance regarding the necessity of performing in vivo bioequivalence studies. Ultimately, this will improve access to affordable generic products, which is a critical prerequisite to reach Universal Health Coverage.
RESUMEN
AIM: Early intervention programs for first-episode psychosis have led to the awareness that the period before onset of a first episode is important in light of early intervention. This has induced a focus on the so-called 'at risk mental state' (ARMS). Individuals with ARMS are at increased risk for later psychotic disorder, but also for other psychiatric disorders as well as poor psychosocial functioning. Thus, adequate detection and treatment of ARMS is essential. METHODS: Since 2018, screening for and treatment of ARMS is recommended standard care in the Netherlands. Implementation is still ongoing. We initiated a naturalistic long-term cohort study of ARMS individuals, the onset and transition of and recovery from adverse development (OnTheROAD) study, with the aim to monitor course and outcome of symptoms and psychosocial functioning over time, as well as patterns of comorbidity and associations with factors of risk and resilience. To this end, participants complete a broad battery of instruments at baseline and yearly follow-up assessments up to 3 years. Outcome is defined in terms of symptom severity level, functioning and quality of life. In particular, we aim to investigate the impact of negative symptoms as part of the ARMS concept. Results from this study can aid in refining the existing ARMS criteria, understanding the developmental course of ARMS and investigating the hypothesized pluripotentiality in outcome of ARMS. New knowledge may inform the further development of specialized early interventions. RESULTS AND CONCLUSIONS: In this article, we describe the rationale, outline and set-up of OnTheROAD.
Asunto(s)
Adaptación Psicológica , Experiencias Adversas de la Infancia/psicología , Adolescente , Adulto , Estudios de Cohortes , Femenino , Humanos , Estudios Longitudinales , Masculino , Países Bajos , Trastornos Psicóticos/diagnóstico , Trastornos Psicóticos/psicología , Trastornos Psicóticos/terapia , Calidad de Vida/psicología , Factores de RiesgoRESUMEN
The SeDeM Expert Diagram System (SeDeM EDS) was originally developed to provide information about the suitability of powders to produce direct compressible tablets. Multiple-unit pellet systems (MUPS) are dosage forms consisting of pellets compressed into tablets or loaded into hard gelatin capsules. The aim of this study was to apply the SeDeM EDS to different size pellets (i.e. 0.5, 1.0, 1.5, 2.0, and 2.5 mm) containing different APIs (i.e. doxylamine, ibuprofen or paracetamol) to determine which properties should be corrected to yield MUPS tablet formulations. The SeDeM parameter tests were conducted on the pellets, selected excipients, intermediate blends, and final blends. The study showed that the properties of the pellets depended on the active ingredient and pellet size. The SeDeM compressibility indices indicated that the final pellet blends should be suitable for compression into MUPS tablets. MUPS tablets were prepared from the final blends and evaluated in terms of physico-chemical properties and dissolution profiles. Only three of the MUPS tablet formulations containing ibuprofen and one MUPS tablet formulation containing paracetamol failed content uniformity. The water solubility of the APIs as well as the pellet size (surface area exposed to the dissolution medium) attributed to the difference in drug dissolution rate.
Asunto(s)
Implantes de Medicamentos/química , Comprimidos/química , Química Farmacéutica/métodos , Composición de Medicamentos/métodos , Liberación de Fármacos , Excipientes/química , Sistemas Especialistas , Dureza , Ibuprofeno/química , Tamaño de la Partícula , Polvos/química , SolubilidadRESUMEN
Multiple-unit pellet systems (MUPS) provide several pharmacokinetic and pharmacodynamic advantages over single-unit dosage forms, however, compression of pellets into MUPS tablets present certain challenges. Although the SeDeM Expert Diagram System (SeDeM EDS) was originally developed to provide information about the most appropriate excipient and the minimum amount thereof that is required for producing direct compressible tablets, this study investigated the possibility to apply the SeDeM EDS in the production of MUPS tablets. In addition, the effect of pellet size (i.e. 0.5, 1.0, 1.5, 2.0, and 2.5 mm) on SeDeM EDS predictions regarding the MUPS tablet formulations was investigated. The compressibility incidence factor values were below the acceptable value (i.e. 5.00) for all the pellet sizes. Kollidon® VA 64 was identified as the most appropriate excipient to improve compressibility. The compression indices, namely, the parameter index (IP), parametric profile index (IPP), and good compression index (GCI) indicated that acceptable MUPS tablets could be produced from the final pellet-excipient blends based on predictions from the SeDeM EDS. These MUPS tablets complied with specifications for friability, hardness, and mass variation. The SeDeM EDS system is therefore applicable to assist in the formulation of acceptable MUPS tablets.
Asunto(s)
Algoritmos , Composición de Medicamentos/métodos , Excipientes/química , Comprimidos/química , Dureza , Tamaño de la Partícula , Povidona/químicaRESUMEN
An improved method of piroxicam benzoate synthesis was described, and an isocratic reversed-phase high-performance liquid chromatography method for its determination was developed and fully validated. The method was found to be specific, precise (relative standard deviation 0.3%), accurate (mean recovery 99.9%), and robust. Limit of detection was estimated at 0.055 microg mL(-1) and limit of quantification at 0.185 microg mL(-1). The kinetics of piroxicam benzoate hydrolysis in aqueous buffer solutions (pH 1.1 and 10), simulated gastric and intestinal fluids was studied. The hydrolysis followed first-order kinetics. The following rate constants were obtained at pH 10: k = 1.8 x 10(-3) hr(-1) at 37 degrees C and k = 3.4 x 10(-2) hr(-1) at 60 degrees C. In acidic media, no significant hydrolysis was observed after 24 hr. During the 24-hr period in simulated intestinal fluid, only 10.9% of the starting ester was hydrolyzed.