RESUMEN
Novel octopod shaped Ag3PO4 microcrystals were successfully fabricated by a simple ion exchange method under the conditions of a hot water bath using [Ag(NH3)2]+ solution and Na2HPO4 solution as the precursors. Meanwhile, sphere and cube shaped Ag3PO4 microcrystals were also prepared followed by changing reaction materials as well as temperature. The surface morphology, microstructure and photocatalytic performance were investigated on the three different shaped crystals respectively. Compared to sphere and cube counterparts, the obtained octopod shaped Ag3PO4 crystals possess 8 symmetric feet with sharp tips and exhibit higher photocatalytic activity and better cycle stability. After further exploring its formation process, UV-vis diffusion reflectance properties as well as photocurrent transient response, it was found that the Ag3PO4 octopod had exposed high index crystal faces, and possessed a narrow band gap as well as high photoexcited transient charge separation efficiency. The results show that the improved photocatalytic activity of octopod shaped Ag3PO4 is mainly due to the synergistic action of the strong light absorption capacity and high carrier separation efficiency. These results highlight the tremendous practical application of octopod Ag3PO4 microcrystals in visible light photocatalysis.
RESUMEN
For catalytic systems consisting of Pt as the active component and CeO2-Al2O3 as the support material, the metal-support interaction between the Pt and CeO2 components is widely applied to inhibit aggregation of Pt species and thus enhance the thermal stability of the catalyst. In this work, a highly thermostable Pt catalyst was prepared by modifying the synthesis procedure for conventional Pt/CeO2/Al2O3 (Pt/Ce/Al) catalyst, that is, the CeO2 component was introduced after deposition of Pt on Al2O3. The obtained CeO2/Pt/Al2O3 (Ce/Pt/Al) catalyst exhibits significantly different aging behavior. During the hydrothermal aging process, redispersion of Pt species from the surface of Al2O3 to the surface of CeO2 occurs, resulting in a stronger metal-support interaction between Pt and CeO2. Thus, the formed Pt-O-Ce bond could act as an anchor to retard aggregation of Pt species and help Pt species stay at a more oxidative state. Consequently, excellent reduction capability and superior three-way catalytic performance are acquired by Ce/Pt/Al-a after hydrothermal aging treatment.
RESUMEN
Long life, high capacity, environmental friendliness and good rate performance are the most important elements in the research of lithium ion batteries (LIBs). In this paper, Sn-carbon composite electrode materials are prepared using Dunaliella Salinas based carbon (amorphous carbon) as an amorphous carbon precursor combined with tin. Hence, an amorphous carbon template enwrapped by Sn particles forms a core-shell structure (Sn-carbon composite), the annealed Dunaliella Salinas based carbon makes up the carbon core, and Sn particles form the shell of the material. The components of the materials, microstructure and electrochemical properties of LIBs were characterized and tested. The results show that the prepared Sn-carbon composite electrode materials have high purity and combine with amorphous carbon uniformly. The Sn-carbon composite exhibits excellent performance as a LIB anode, its discharge capacities of the 1st, 2nd, and 4th cycles are 1777.39, 944.15 and 722.46 mA h g-1 at a current density of 100 mA g-1, and the capacity is 619.09 mA h g-1 after stable cycling at a current density of 200 mA g-1. The capacity continues to rise at a high current density of 1000 mA g-1 and is 574.97 mA h g-1 at its maximum, demonstrating the excellent performance of the electrode.
RESUMEN
A colorimetric sensor based on plasmonic nanoparticles (NPs) is a promising and convenient detection tool, but its reproducibility and adjustability remain a challenge because the NPs are mainly random and uncontrollable. Herein, a colorimetric sensor with good reversibility and reproducibility was prepared by embedding the two-dimensional (2D) Au NP arrays on the surface of the polyacrylamide hydrogel film to form 2D Au NP arrays attached a hydrogel composite. For this composite, with the change of the interspacing distance of Au NPs driven by the swelling-shrinking behavior of the hydrogel carrier, the diffraction peaks faded away and plasmonic coupling peaks appeared, accompanied by a series of obvious color changes (iridescence â violet â golden yellow â red), which can be correlated to the applied water content. Importantly, the composite had good reproducibility as a result of a highly ordered array structure. Additionally, this colorimetric sensor with a dynamically tunable plasmonic band can be used as a high-quality surface-enhanced Raman scattering (SERS) substrate because the gap distance of the Au NPs can be uniformly controlled. We demonstrated that, as the active gap distance decreased, the SERS signals can be significantly intensified. When the water content reached 40%, this SERS substrate exhibited high sensitivity (10-10 M for 4-aminothiophenol and 10-9 M for thiram) and good reproducibility (relative standard deviation of <20%) using the excitation laser of 785 nm because of the small gap between two adjacent Au NPs and the highly ordered periodic structure. Such 2D Au NP arrays attached to a hydrogel composite could be a new strategy to obtain a high-quality colorimetric sensor and dynamic SERS substrate.
RESUMEN
The TiO2/C composites with approximately 40 wt% of carbon were prepared by calcination of precursors, formed from a one-pot liquid phase reaction between Ti(SO4)2 and flour. All TiO2/C composites displayed mesoporous structures with high BET surface areas (117-138 m2 g-1) and small crystal sizes of TiO2 (8-27 nm). The contents of graphitic carbon and rutile TiO2 increased, while the surface area and TiO2 crystal size decreased for the TiO2/C composite on increasing the calcination temperature from 650 to 800 °C; when calcinated at 800 °C, the anatase TiO2 completely changed into rutile TiO2 in the TiO2/C composite. The TiO2/C composite calcinated at higher temperatures exhibited better adsorptive and photocatalytic degradation performance in the removal of methylene blue (MB). For the entire rutile TiO2/C-800 composite, the adsorption process of MB can be well described by the pseudo-second-order kinetic model and is governed by chemical adsorption with the maximum adsorption capacity value equal to about 15 mg g-1. Under continuous illumination with a 254 nm UV lamp (15 W) for 3 h, the percentage of MB (14 mg l-1) photocatalytic degradation on 50 mg of TiO2/C-800 was 25.1% higher than that of the maximum adsorption removal. These results suggest that the graphitized carbon has a significant effect on the adsorptivity and photocatalytic activity of the TiO2/C composite.
RESUMEN
Thermoradiotherapy acts as an important antitumor modality because heating can increase the blood flow and improve the oxygen level in tumor, thus remission of hypoxia-associated resistance for radiotherapy (RT). However, most agents for thermoradiotherapy are used either in the first near-infrared biological window or low photothermal conversion efficiency. Here, a facile method to prepare CuxS/Au nanocomposites via reduction methods from CuxS templates in mild synthetic conditions (i.e., aqueous solution and room temperature) is presented. After the growth of Au nanoparticles, the CuxS/Au nanocomposites have greater benefits for photothermal efficiency than that of CuxS nanoparticles due to the enhanced absorbance in the second near-infrared window. Moreover, biocompatibility and stability of these nanocomposites are greatly improved by lipoic acid poly(ethylene glycol). After the tumors were irradiated with a 1064 nm laser, their oxygenation status is subsequently improved, and the combination of photothermal therapy and RT achieves remarkable synergistic therapeutic effects. This work provides a novel idea to design a new-generation nanomedicine for tumor thermoradiotherapy.
Asunto(s)
Absorción Fisicoquímica , Hipertermia Inducida , Nanopartículas del Metal/química , Neoplasias/terapia , Animales , Línea Celular Tumoral , Supervivencia Celular , Cobre/química , Oro/química , Humanos , Nanopartículas del Metal/ultraestructura , Ratones , Fototerapia , Transductores , Hipoxia TumoralRESUMEN
A novel glucose sensor was reported that consisted of two-dimensional (2D) Au nanosphere arrays and glucose-responsive hydrogel film. This sensor exhibited an intense diffraction signal and an obvious diffraction color on a quartz slide due to the strong diffraction intensity of the Au nanosphere arrays. Thus, glucose was detected via the variation of diffraction wavelength and diffraction color, without a high reflective mirror. In addition, by introducing poly(vinyl alcohol) (PVA) to crosslink the phenylboronic acid (PBA)-modified hydrogel film, the diffraction wavelength of the 2D Au nanosphere arrays/hydrogel composite film shifted in the same direction in high ionic strength condition. In particular, it showed a nearly linear red-shift when the glucose concentration increased from 0 mM to 20 mM. Moreover, this glucose sensor displayed good reproducibility. The nearly linear response and good reproducibility were highly helpful for improving practical application of this glucose sensor.
RESUMEN
In order to clarify the mechanism that zinc and phosphorus elements entering the micro-arc oxidation (MAO) coatings developed on Ti-6Al-4V alloys, anodic coatings containing different zinc and phosphorus were fabricated using an orthogonal experiment of four factors with three levels in an electrolyte containing EDTA-ZnNa2, KOH, and phytic acid. Surface morphology, element composition, chemical state and phase structure of MAO coatings were characterized by scanning electron microscope (SEM), energy dispersive X-ray spectrometer (EDS), X-ray photoelectron spectroscopy (XPS) and X-ray diffraction (XRD). The concentrations of zinc and phosphorus in the electrolyte were analyzed by an inductively coupled plasma optical emission spectrometry (ICP-OES). The results show that zinc and phosphorus elements in MAO coatings exist in the form of Zn3(PO4)2. Phytic acid is the most important factor on both zinc and phosphorus contents of MAO coatings. With the increase of phytic acid concentration or the decrease of KOH concentration, the contents of zinc and phosphorus in MAO coatings present a similarly increasing tendency. Our results indicate that phosphorus takes part in coating formation mainly by diffusion, while zinc enters into MAO coatings with phosphorus from phytic acid.
RESUMEN
Two-dimensional (2D) periodic micro/nanostructured arrays as SERS substrates have attracted intense attention due to their excellent uniformity and good stability. In this work, periodic hierarchical SiO2 nanopillar arrays decorated with Ag nanoparticles (NPs) with clean surface were prepared on a wafer-scale using monolayer Au NP arrays as masks, followed by reactive ion etching (RIE), depositing Ag layer and annealing. For the prepared SiO2 nanopillar arrays decorated with Ag NPs, the size of Ag NPs was tuned from ca. 24 to 126 nanometers by controlling the deposition thickness of Ag film. Importantly, the SiO2 nanopillar arrays decorated with Ag NPs could be used as highly sensitive SERS substrate for the detection of 4-aminothiophenol (4-ATP) and rhodamine 6G (R6G) due to the high loading of Ag NPs and a very uniform morphology. With a deposition thickness of Ag layer of 30 nm, the SiO2 nanopillar arrays decorated with Ag NPs exhibited the best sensitive SERS activity. The excellent SERS performance of this substrate is mainly attributed to high-density "hotspots" derived from nanogaps between Ag NPs. Furthermore, this strategy might be extended to synthesize other nanostructured arrays with a large area, which are difficult to be prepared only via conventional wet-chemical or physical methods.
RESUMEN
Periodic alloyed (Au-Ag, Au-Cu, Au-Ag-Cu) nanoparticle (NP) arrays with uniform size, controllable composition and center-to-center spacing were fabricated by a novel and facile strategy based on physical vapor deposition on a monolayer colloidal crystal template and further heat treatment. The composition and center-to-center spacing were manipulated by adjusting the sputtering target in the deposition process and the size of colloidal spheres of the template, respectively. The shadow effect and a dewetting model were employed to analyze the whole process of evolution from a metallic thin film to spherical nanoparticles with uniform size. The localized surface plasmon resonance (LSPR) and diffraction peaks of these alloyed arrays were systematically measured. The dielectric constant has an important influence on LSPR peaks and diffraction peaks. Both the LSPR and diffraction peaks of Au-Ag alloyed NPs arrays exhibit a blue shift due to their lower dielectric constant than that of pure Au NPs. However, compared with Au, Cu possesses a higher dielectric constant, leading to a red shift of the LSPR and diffraction peaks of Au-Cu alloyed NPs arrays. With the increase of NP size, the diffraction peaks of both binary alloyed NPs exhibit a slight red shift. Moreover, the LSPR absorption peaks were more sensitive to the composition of the NPs than the diffraction peaks. This work would open up a novel strategy in the production of alloyed NP arrays with tunable LSPR peaks and diffraction peaks, which would be very helpful to improve their practical applications in various fields.