Benzoyl isothiocyanate modified surface of silica gel as the extraction material for adsorbing steroid hormones in water.

Steroid hormones have been listed as priority pollutants in the environment, and their detection and pollution control deserve our extensive attention. In this study, a modified silica gel adsorbent material was synthesized by benzoyl isothiocyanate reaction with hydroxyl groups on the silica gel surface. The modified silica gel was used as a solid phase extraction filler for the extraction of steroid hormones from water, which was further analyzed by the HPLC-MS/MS method. The FT-IR, TGA, XPS, and SEM analysis indicated that benzoyl isothiocyanate was successfully grafted on the surface of silica gel to form a bond with an isothioamide group and benzene ring as the tail chain. The modified silica gel synthesized at 40 °C showed excellent adsorption and recovery rates for three steroid hormones in water. Methanol at pH 9.0 was selected as the optimal eluent. The adsorption capacity of the modified silica gel for epiandrosterone, progesterone, and megestrol acetate was 6822 ng mg-1, 13 899 ng mg-1, and 14 301 ng mg-1, respectively. Under optimal conditions, the limit of detection (LOD) and limit of quantification (LOQ) for 3 steroid hormones by modified silica gel extraction with HPLC-MS/MS detection were 0.02-0.88 µg L-1 and 0.06-2.22 µg L-1, respectively. The recovery rate of epiandrosterone, progesterone, and megestrol was between 53.7% and 82.9%, respectively. The modified silica gel has been successfully used to analyze steroid hormones in wastewater and surface water.

Polyimidazolyl acetate ionic liquid grafted on cellulose filter paper as thin-film extraction phase for extraction of non-steroidal anti-inflammatory drugs from water.

Recently, pharmaceuticals and personal care products in the water environment exhibited potential risks to both human and aquatic organisms. In order to improve the sensitivity and accuracy of pharmaceutical detection, the polyimidazolyl acetate ionic liquid was synthesized by Radziszewski reaction and coated on cellulose filter papers as a thin-film extraction phase for extraction of non-steroidal anti-inflammatory drugs from water. The attenuated total reflection-infrared spectrometry, thermogravimetric analysis, and scanning electron microscope analyses demonstrated that the polyimidazolyl acetate ionic liquid was successfully prepared and attached to the surface of the cellulose filter paper through chemical bonding. The adsorption capacity of the homemade thin-film extraction material for the four non-steroidal anti-inflammatory drugs was greater than 8898 ng/cm2 under the optimum conditions, and the desorption rate was over 90%. Then, a paper-based thin-film extraction phase-high-performance liquid chromatography-tandem mass spectrometry method was established for the extraction of non-steroidal anti-inflammatory drugs in water. This method provided limits of detection and limits of quantification were in the range of 0.02-0.15 and 0.17-0.50 µg/L, respectively. Hence, the obtained thin-film extraction phase showed excellent recovery and reproducibility for the target non-steroidal anti-inflammatory drugs with carboxyl groups from water.