RESUMEN
This paper describes the design of a low-current, multichannel, handheld electronic device integrated with nanostructured chemiresistor sensor arrays. A key design feature of the electronic circuit board is its low excitation current for achieving optimal performance with the arrays. The electronics can rapidly acquire the resistances for different sensors, not only spanning several orders of magnitude, but also as high as several hundreds of megaohms. The device tested is designed using a chemiresistor array with nanostructured sensing films prepared by molecularly-mediated assemblies of gold nanoparticles for detection. The low-current, wide-range, and auto-locking capabilities, along with the effective coupling with the nanostructured chemiresistor arrays, meet the desired performances of a low excitation current and low power consumption, and also address the potential instability of the sensors in a complex sensing environment. The results are promising for potential applications of the device as a portable sensor for the point-of-need monitoring of air quality and as a biosensor for point-of-care human breath screening for disease biomarkers.
Asunto(s)
Técnicas Biosensibles , Nanopartículas del Metal , Electrónica , Oro , HumanosRESUMEN
The need for active and stable oxidation catalysts is driven by the demands in production of valuable chemicals, remediation of hydrocarbon pollutants and energy sustainability. Traditional approaches focus on oxygen-activating oxides as support which provides the oxygen activation at the catalyst-support peripheral interface. Here we report a new approach to oxidation catalysts for total oxidation of hydrocarbons (e.g., propane) by surface oxygenation of platinum (Pt)-alloyed multicomponent nanoparticles (e.g., platinum-nickel cobalt (Pt-NiCo)). The in-situ/operando time-resolved studies, including high-energy synchrotron X-ray diffraction and diffuse reflectance infrared Fourier transform spectroscopy, demonstrate the formation of oxygenated Pt-NiOCoO surface layer and disordered ternary alloy core. The results reveal largely-irregular oscillatory kinetics associated with the dynamic lattice expansion/shrinking, ordering/disordering, and formation of surface-oxygenated sites and intermediates. The catalytic synergy is responsible for reduction of the oxidation temperature by ~100 °C and the high stability under 800 °C hydrothermal aging in comparison with Pt, and may represent a paradigm shift in the design of self-supported catalysts.
RESUMEN
Nanoscale alloying constitutes an increasingly-important pathway for design of catalysts for a wide range of technologically important reactions. A key challenge is the ability to control the surface catalytic sites in terms of the alloying composition, thermochemical treatment and phase in correlation with the catalytic properties. Herein we show novel findings of the nanoscale evolution of surface catalytic sites on thermochemically-tuned gold-palladium nanoalloys by probing CO adsorption and oxidation using in situ diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS) technique. In addition to the bimetallic composition and the support, the surface sites are shown to depend strongly on the thermochemical treatment condition, demonstrating that the ratio of three-fold vs. bridge or atop Pd sites is greatly reduced by thermochemical treatment under hydrogen in comparison with that under oxygen. This type of surface reconstruction is further supported by synchrotron high-energy X-ray diffraction coupled to atomic pair distribution function (HE-XRD/PDF) analysis of the nanoalloy structure, revealing an enhanced degree of random alloying for the catalysts thermochemically treated under hydrogen. The nanoscale alloying and surface site evolution characteristics were found to correlate strongly with the catalytic activity of CO oxidation. These findings have significant implications for the nanoalloy-based design of catalytic synergy.
RESUMEN
Uniform 3D NiMoS nanoflowers with self-assembled nanosheets were successfully synthesized via a simple hydrothermal growth method using cheap and nontoxic elemental sulfur as sulfur sources. The structure and morphology of the nanomaterials were characterized by SEM, TEM, XRD, Raman and XPS analyses, revealing that the NiMoS nanoflowers were composed of ultrathin nanosheets with a thickness of approximately 6-12 nm. The HRTEM results indicate that the curve/short MoS2 slabs on the nanosheets possess the characteristics of dislocations, distortions and discontinuity, which suggests a defect-rich structure, resulting in the exposure of additional Ni-Mo-S edge sites. The obtained NiMoS nanoflowers exhibited an excellent activity for thiophene hydrodesulfurization (HDS) and 4,6-dimethyldibenzothiophene deep HDS due to their high density of active sites. The outstanding HDS performance suggests that these NiMoS composites with a unique flower-like nanostructure could be useful as promising catalysts for deep desulfurization of fuel oils.
RESUMEN
Alloying palladium (Pd) with other transition metals at the nanoscale has become an important pathway for preparation of low-cost, highly active and stable catalysts. However, the lack of understanding of how the alloying phase state, chemical composition and atomic-scale structure of the alloys at the nanoscale influence their catalytic activity impedes the rational design of Pd-nanoalloy catalysts. This work addresses this challenge by a novel approach to investigating the catalytic oxidation of carbon monoxide (CO) over palladium-nickel (PdNi) nanoalloys with well-defined bimetallic composition, which reveals a remarkable maximal catalytic activity at Pd:Ni ratio of ~50:50. Key to understanding the structural-catalytic synergy is the use of high-energy synchrotron X-ray diffraction coupled to atomic pair distribution function (HE-XRD/PDF) analysis to probe the atomic structure of PdNi nanoalloys under controlled thermochemical treatments and CO reaction conditions. Three-dimensional (3D) models of the atomic structure of the nanoalloy particles were generated by reverse Monte Carlo simulations (RMC) guided by the experimental HE-XRD/PDF data. Structural details of the PdNi nanoalloys were extracted from the respective 3D models and compared with the measured catalytic properties. The comparison revealed a strong correlation between the phase state, chemical composition and atomic-scale structure of PdNi nanoalloys and their catalytic activity for CO oxidation. This correlation is further substantiated by analyzing the first atomic neighbor distances and coordination numbers inside the nanoalloy particles and at their surfaces. These findings have provided new insights into the structural synergy of nanoalloy catalysts by controlling the phase state, composition and atomic structure, complementing findings of traditional density functional theory studies.
RESUMEN
In situ high-energy X-ray diffraction coupled to atomic pair distribution function analysis is used to obtain fundamental insight into the effect of the reactive gas environment on the atomic-scale structure of metallic particles less than 10 nm in size. To substantiate our recent discovery we investigate a wide range of noble-transition metal nanoparticles and confirm that they expand and contract radially when treated in oxidizing (O2) and reducing (H2) atmospheres, respectively. The results are confirmed by supplementary XAFS experiments. Using computer simulations guided by the experimental diffraction data we quantify the effect in terms of both relative lattice strain and absolute atomic displacements. In particular, we show that the effect leads to a small percent of extra surface strain corresponding to several tenths of Ångström displacements of the atoms at the outmost layer of the particles. The effect then gradually decays to zero within 4 atomic layers inside the particles. We also show that, reminiscent of a breathing type structural transformation, the effect is reproducible and reversible. We argue that because of its significance and widespread occurrence the effect should be taken into account in nanoparticle research.
Asunto(s)
Nanopartículas del Metal/química , Elementos de Transición/química , Atmósfera , Gases/química , Hidrógeno/química , Oxidación-Reducción , Oxígeno/química , Tamaño de la PartículaRESUMEN
The control of the nanoscale composition and structure of alloy catalysts plays an important role in heterogeneous catalysis. This paper describes novel findings of an investigation for Pd-based nanoalloy catalysts (PdCo and PdCu) for ethanol oxidation reaction (EOR) in gas phase and alkaline electrolyte. Although the PdCo catalyst exhibits a mass activity similar to Pd, the PdCu catalyst is shown to display a much higher mass activity than Pd for the electrocatalytic EOR in alkaline electrolyte. This finding is consistent with the finding on the surface enrichment of Pd on the alloyed PdCu surface, in contrast to the surface enrichment of Co in the alloyed PdCo surface. The viability of C-C bond cleavage was also probed for the PdCu catalysts in both gas-phase and electrolyte-phase EOR. In the gas-phase reaction, although the catalytic conversion rate for CO2 product is higher over Pd than PdCu, the nanoalloy PdCu catalyst appears to suppress the formation of acetic acid, which is a significant portion of the product in the case of pure Pd catalyst. In the alkaline electrolyte, CO2 was detected from the gas phase above the electrolyte upon acid treatment following the electrolysis, along with traces of aldehyde and acetic acid. An analysis of the electrochemical properties indicates that the oxophilicity of the base metal alloyed with Pd, in addition to the surface enrichment of metals, may have played an important role in the observed difference of the catalytic and electrocatalytic activities. In comparison with Pd alloyed with Co, the results for Pd alloyed with Cu showed a more significant positive shift of the reduction potential of the oxygenated Pd species on the surface. These findings have important implications for further fine-tuning of the Pd nanoalloys in terms of base metal composition toward highly active and selective catalysts for EOR.
Asunto(s)
Aleaciones/química , Etanol/química , Nanoestructuras/química , Paladio/química , Catálisis , Cobalto/química , Cobre/química , Electroquímica , Gases/química , Concentración de Iones de Hidrógeno , Oxidación-Reducción , Propiedades de SuperficieRESUMEN
The understanding of the atomic-scale structural and chemical ordering in supported nanosized alloy particles is fundamental for achieving active catalysts by design. This report shows how such knowledge can be obtained by a combination of techniques including X-ray photoelectron spectroscopy and synchrotron radiation based X-ray fine structure absorption spectroscopy and high-energy X-ray diffraction coupled to atomic pair distribution function analysis, and how the support-nanoalloy interaction influences the catalytic activity of ternary nanoalloy (platinum-nickel-cobalt) particles on three different supports: carbon, silica, and titania. The reaction of carbon monoxide with oxygen is employed as a probe to the catalytic activity. The thermochemical processing of this ternary composition, in combination with the different support materials, is demonstrated to be capable of fine-tuning the catalytic activity and stability. The support-nanoalloy interaction is shown to influence structural and chemical ordering in the nanoparticles, leading to support-tunable active sites on the nanoalloys for oxygen activation in the catalytic oxidation of carbon monoxide. A nickel/cobalt-tuned catalytic site on the surface of nanoalloy is revealed for oxygen activation, which differs from the traditional oxygen-activation sites known for oxide-supported noble metal catalysts. The discovery of such support-nanoalloy interaction-enabled oxygen-activation sites introduces a very promising strategy for designing active catalysts in heterogeneous catalysis.
RESUMEN
The formation of nanosized alloys between a pair of elements, which are largely immiscible in bulk, is examined in the archetypical case of Pt and Au. Element specific resonant high-energy X-ray diffraction experiments coupled to atomic pair distribution functions analysis and computer simulations prove the formation of Pt-Au alloys in particles less than 10 nm in size. In the alloys, Au-Au and Pt-Pt bond lengths differing in 0.1 Å are present leading to extra structural distortions as compared to pure Pt and Au particles. The alloys are found to be stable over a wide range of Pt-Au compositions and temperatures contrary to what current theory predicts. The alloy-type structure of Pt-Au nanoparticles comes along with a high catalytic activity for electrooxidation of methanol making an excellent example of the synergistic effect of alloying at the nanoscale on functional properties.
RESUMEN
Isothermal and non-isothermal kinetic measurements on the chemical reaction between Mg(NH2)(2) and LiH, as well as the thermal decomposition of Mg(NH(2))(2), give apparent activation energies of 88.1 and 130 kJ/mol, respectively, which reveal that the thermal decomposition of Mg(NH2)(2) is unlikely to be an elementary step in the chemical reaction of Mg(NH2)(2) and 2LiH. The H-D exchange between H(delta+) in Mg(NH2)(2) and D(delta-) in LiD gives evidence for the coordinated interaction between amide and hydride. The observed linear and nonlinear kinetic growth in the reaction of Mg(NH2)(2)-2LiH indicates that the reaction rate is controlled by the interface reaction in the early stage of the reaction and by mass transport through the imide layer in the later stage. Both particle size and degree of mixing of the reacting species affect the overall kinetics of the reactions.
RESUMEN
A Zr-promoted Pd/HZSM-5 catalyst, prepared by an impregnation method, was found to possess high catalytic activity as well as thermal and hydrothermal stability for low-temperature methane combustion.