Cardiovascular and Other Competing Causes of Death in Male Breast Cancer Patients: A Population-Based Epidemiologic Study.

PURPOSE: Male breast cancer (MBC) is a rare disease that tends to occur in elderly men. Little is known about the causes of death in MBC because of the small sample size of most studies. This study aimed to investigate the causes of death in MBC patients. PATIENTS AND METHODS: MBC patient data were obtained from the Surveillance, Epidemiology, and End Results database (1975-2016). Time trends of MBC mortality in the US population were analyzed using Joinpoint software. We calculated the proportion of each cause of death in the overall cohort and in different patient subgroups. Competing risk models were used to calculate cumulative mortality at different follow-up times. The risk of cardiovascular death (CVD) in MBC patients was compared to that of the age-matched general population by calculating standardized mortality ratio (SMR). RESULTS: In total, 6426 patients were included in the analysis. MBC mortality rate increased between 2004 and 2019 (annual percentage change=1.16, 95% confidence interval [CI]: 0.50, 1.80). There were 1757 patients (27.3%) who died of non-breast cancer causes. CVD was the leading cause of death in patients who were elderly or had localized disease. MBC patients had a 6.58-fold higher risk of CVD than the general population (SMR=6.58, 95% CI: 6.14, 7.05). CONCLUSION: Non-breast cancer death accounts for the majority of deaths in MBC patients who are elderly or have localized cancer. Compared to the general population, MBC patients have an increased risk of CVD. These results highlight the importance of monitoring cardiovascular comorbidities in MBC patients.

A novel method for periapical microsurgery with the aid of 3D technology: a case report.

BACKGROUND: Three-dimensional (3D) technology has gained wide acceptance in dentistry. It has been used for treatment planning and surgical guidance. This case report presented a novel treatment approach to remove cortical bone and root-end during periapical surgery with the help of Cone-Beam Computed Tomography (CBCT), Computer Aided Design (CAD) and three-dimensional (3D) printing technology. CASE PRESENTATION: A 37-year-old female patient presented with a large periapical lesion of left maxillary lateral incisor and canine was referred for microsurgical endodontic surgery. The data acquired from a preoperative diagnostic CBCT scan and an intra-oral scan was uploaded into surgical planning software and matched. A template that could be used to locate root-ends and lesion areas was virtually designed based on the data and was fabricated using a 3D printer. With the guidance of the template, the overlying cortical bone and root-end were precisely removed by utilizing a trephine with an external diameter of 4.0 mm. The patient was clinically asymptomatic at a six-month follow-up review. One year after the surgery, the lesion was healing well and no periapical radiolucency was observed on radiographic examination. CONCLUSIONS: The digitally designed directional template worked in all aspects to facilitate the periapical surgery as anticipated. The root-ends were accurately located and resected. The surgical procedure was simplified, and the treatment efficiency was improved. This technique minimized the damage and reduced iatrogenic injury.