RESUMEN
This report showed a case of temporomandibular joint (TMJ) ankylosis suspected to be associated with ankylosing spondylitis based on the observation of bony ankylosis of the cervical spine on computed tomography (CT) images. A 53-year-old man presented with a chief complaint of difficulty in opening his mouth. His medical history indicated that in his 20s, he became aware of the difficulty in moving his neck. CT revealed marked osteoarthritic changes in the right mandibular condyle, suggesting fibrotic TMJ ankylosis. In addition, bony ankylosis of the cervical vertebral body and facet joints from the axis (C2) to C5 in continuity was observed. CT of the entire spine also showed bony deformity of the sacroiliac joints and bony ankylosis. Based on these findings, ankylosing spondylitis was suspected. The possibility of an ankylosing spondylitis complication should be considered in cases of TMJ ankylosis if bony ankylosis of the cervical spine is observed.
RESUMEN
The aim of this study was to assess the utility of an actuator-driven pulsed water jet (ADPJ) as a hardness-dependent carious dentin removal device by using different outputs. Thirty-six plane surface dental caries samples were treated with the ADPJ at 150, 200, and 250 voltage (12 teeth each). The Knoop hardness number (KHN) and Ca/P mass ratio were measured at 70 µm from the deepest point of the removing groove. Furthermore, three other teeth samples were manually treated with the ADPJ at the three above mentioned voltages (one tooth each) for 1 min. The KHN and Ca/P mass ratio were measured at 70 µm from the surface of the residual dentin part. In both the KHN and Ca/P mass ratio, higher residual dentin depended on the applied voltage of ADPJ. The ADPJ enabled the removal of softened carious dentin in an applied voltage-dependent manner.