RESUMEN
Single crystals of BaTiO3 exhibit small switching fields and energies, but thin-film performance is considerably worse, thus precluding their use in next-generation devices. Here, we demonstrate high-quality BaTiO3 thin films with nearly bulk-like properties. Thickness scaling provides access to the coercive voltages (<100 mV) and fields (<10 kV cm-1) required for future applications and results in a switching energy of <2 J cm-3 (corresponding to <2 aJ per bit in a 10 × 10 × 10 nm3 device). While reduction in film thickness reduces coercive voltage, it does so at the expense of remanent polarization. Depolarization fields impact polar state stability in thicker films but fortunately suppress the coercive field, thus driving a deviation from Janovec-Kay-Dunn scaling and enabling a constant coercive field for films <150 nm in thickness. Switching studies reveal fast speeds (switching times of ~2 ns for 25-nm-thick films with 5-µm-diameter capacitors) and a pathway to subnanosecond switching. Finally, integration of BaTiO3 thin films onto silicon substrates is shown. We also discuss what remains to be demonstrated to enable the use of these materials for next-generation devices.
RESUMEN
Magnetostrictive materials transduce magnetic and mechanical energies and when combined with piezoelectric elements, evoke magnetoelectric transduction for high-sensitivity magnetic field sensors and energy-efficient beyond-CMOS technologies. The dearth of ductile, rare-earth-free materials with high magnetostrictive coefficients motivates the discovery of superior materials. Fe1-xGax alloys are amongst the highest performing rare-earth-free magnetostrictive materials; however, magnetostriction becomes sharply suppressed beyond x = 19% due to the formation of a parasitic ordered intermetallic phase. Here, we harness epitaxy to extend the stability of the BCC Fe1-xGax alloy to gallium compositions as high as x = 30% and in so doing dramatically boost the magnetostriction by as much as 10x relative to the bulk and 2x larger than canonical rare-earth based magnetostrictors. A Fe1-xGax - [Pb(Mg1/3Nb2/3)O3]0.7-[PbTiO3]0.3 (PMN-PT) composite magnetoelectric shows robust 90° electrical switching of magnetic anisotropy and a converse magnetoelectric coefficient of 2.0 × 10-5 s m-1. When optimally scaled, this high coefficient implies stable switching at ~80 aJ per bit.
RESUMEN
Indirect excitons (IX) in semiconductor heterostructures are bosons, which can cool below the temperature of quantum degeneracy and can be effectively controlled by voltage and light. IX quantum Bose gases and IX devices were explored in GaAs heterostructures where an IX range of existence is limited to low temperatures due to low IX binding energies. IXs in van der Waals transition-metal dichalcogenide (TMD) heterostructures are characterized by large binding energies giving the opportunity for exploring excitonic quantum gases and for creating excitonic devices at high temperatures. TMD heterostructures also offer a new platform for studying single-exciton phenomena and few-particle complexes. In this work, we present studies of IXs in MoSe2/WSe2 heterostructures and report on two IX luminescence lines whose energy splitting and temperature dependence identify them as neutral and charged IXs. The experimentally found binding energy of the indirect charged excitons, that is, indirect trions, is close to the calculated binding energy of 28 meV for negative indirect trions in TMD heterostructures [Deilmann, T.; Thygesen, K. S. Nano Lett. 2018, 18, 1460]. We also report on the realization of IXs with a luminescence line width reaching 4 meV at low temperatures. An enhancement of IX luminescence intensity and the narrow line width are observed in localized spots.
RESUMEN
A dual wavelength range spectrometer system has been designed and constructed which can simultaneously perform single pass UV absorption spectroscopy and cavity enhanced absorption spectroscopy in the green region of the visible spectrum. Using the system the absorption spectrum of molecular chlorine has been measured, in the wavelength range 509-570 nm, using cavity enhanced absorption spectroscopy. Absolute absorption cross sections were obtained by simultaneous measurement of the UV spectrum to obtain the Cl(2) concentration. These are the first temperature dependent measurements of the Cl(2) absorption cross sections in this region which are vibronically resolved. Laboratory measurements were conducted at four temperatures (298, 273, 233, and 197 K). Spectral modelling of the Cl(2) B(3)Π(0(u)(+))-X(1)Σ(g)(+) electronic transition has been performed, the results of which are in good agreement with our measured spectra.
RESUMEN
STUDY DESIGN: Randomized control post-test only. OBJECTIVES: To investigate the reliability and validity of the EPIC Lift Capacity test's indicators of sincere effort. SUMMARY OF BACKGROUND DATA: The EPIC Lift Capacity test (ELC) (Employment Potential Improvement Corp., Santa Ana, CA) is a functional evaluation tool used to identify physical limitations involved in lifting and manual materials handling. Identification of insincere effort is an integral component of such functional testing because of the potential secondary gain issues surrounding the various populations typically involved in this form of testing. The purpose of this study was to determine the sensitivity and specificity of the "indicators of sincere effort" of the EPIC Lift Capacity test when used on a previously injured population typical of subjects for which the test is designed. METHODS: Subjects consisted of 41 volunteers (age 22 to 58 years) with a previously diagnosed musculoskeletal pathology of the spine or extremities. Volunteers were randomized into either the control group, instructed to give a sincere maximum effort, or the experimental group, instructed to give an insincere effort at 50% of their perceived maximum effort. All tests were administered by certified clinical evaluators according to the standardized EPIC Lift Capacity test protocol.- RESULTS: Overall accuracy in identifying participants' level of effort was 86.84%. The indicators of valid effort exhibited both high positive (94.44%) and negative (80.00%) predictive values. The indicators of valid effort accounted for 94.9% of the total variance in the determination of the subjects' overall effort level. Interrater reliability for agreement of subjects' overall effort was good (interclass correlation coefficient = 0.82). CONCLUSIONS: Through use of standardized indicators of sincere effort, certified EPIC Lift Capacity test evaluators were able to predict sincerity of effort with a high degree of reliability and validity. The rater's systematicobservational evaluation of effort was shown to be the single best indicator of sincere effort.