Pd-catalysed cross-coupling of allenylic carbonates with gem-diborylalkanes: efficient synthesis of isoprenylboronates.

A simple and novel Pd-catalysed cross-coupling reaction of allenylic carbonates with different gem-diborylalkanes was developed. Under mild reaction conditions, synthetically useful and versatile isoprenylboronates could be obtained selectively in moderate to high yields. Furthermore, the utility of the novel isoprenylboronate is demonstrated through isoprenylboration and homologation.

Evaluation on thermal explosion induced by slightly exothermic interface reaction.

An asphalt-salt mixture (ASM), which once caused a fire and explosion in a reprocessing plant, was prepared by imitating the real bituminization process of waste on a lab scale to evaluate its actual thermal hazards. Heat flux reaction calorimeters were used to measure the release of heat for the simulated ASM at a constant heating rate and at a constant temperature, respectively. Experimental results show that the reaction in the ASM below about 250 degrees C is a slightly exothermic interface reaction between the asphalt and the salt particles contained in the asphalt, and that the heat release rate increases sharply above about 250 degrees C due to melting of the salt particles. The reaction rates were formulated on the basis of an assumed reaction model, and the kinetic parameters were determined. Using the model with the kinetic parameters, temperature changes with time and drum-radius axes for the ASM-filled drum were numerically simulated assuming a one-dimensional infinite cylinder system, where the drum was being cooled at an ambient temperature of 50 degrees C. The minimum filling temperature, at which the runaway reaction (MFTRR) can occur for the simulated ASM in the drum is about 194 degrees C. Furthermore, a very good linear correlation exists between this MFTRR and the initial radius of salt particles formed in the bituminization product. The critical filling temperature to the runaway reaction is about 162 degrees C for the asphalt-salt mixture, containing zero-size salt particles, filled in the same drum at an ambient temperature of 50 degrees C. Thus, the runaway reaction will never occur in the drum filled with the asphalt-salt mixture under the conditions of the filling temperature below 162 degrees C and a constant ambient temperature of 50 degrees C. As a consequence, the ASM explosion occurred in the reprocessing plant likely was due to a slightly exothermically reaction and self heating.