Effectiveness of cardiogoniometry compared with exercise-ECG test in diagnosing stable coronary artery disease in women.

AIMS: To investigate the effectiveness of cardiogoniometry, a novel, non-invasive method, in diagnosing coronary artery disease (CAD) in women and compare it with exercise-ECG test, by using coronary angiography as a reference method. METHODS: It was a single-centre, case-series study including consecutive female patients with stable angina pectoris (AP) undergoing coronary angiography. Exercise-ECG test, done according to the Bruce protocol, and cardiogoniometry were obtained prior to coronary angiography. Clinically significant CAD has been defined as one or more coronary lesions with >70% stenosis. RESULTS: Study included 114 consecutive female patients with median age of 64.0 (58.0-71.0) years, out of which 32 (28.1%) had CAD. Cardiogoniometry yielded a total accuracy of 74.6% with a sensitivity of 75.0% (95% CI 56.6-88.5) and specificity of 74.4% (95% CI 63.6-83.4). Exercise-ECG test yielded a total accuracy of 45.1% with a sensitivity of 68.1% (95% CI 42.7-83.6) and specificity 36.6% (95% CI 25.2-50.3). Cardiogoniometry showed higher accuracy than exercise-ECG test ( P < 0.001). Pathological cardiogoniometry was associated with almost nine times higher risk for CAD (OR 8.7, 95%CI 3.4-22.3, P < 0.001), which remained significant after adjustment for age, and hypokinesia. CONCLUSION: Cardiogoniometry is a non-invasive, easy-to-use and free-of-risk method which showed high effectiveness in diagnosing stable CAD in women and superior to exercise-ECG test. Cardiogoniometry could be introduced as a part of the diagnostic algorithm of screening women for stable CAD and is suitable for use in the primary setting, especially in women unable to undergo stress-testing.

Large single crystal growth, transport property, and spectroscopic characterizations of three-dimensional Dirac semimetal Cd3As2.

The three dimensional (3D) Dirac semimetal is a new quantum state of matter that has attracted much attention recently in physics and material science. Here, we report on the growth of large plate-like single crystals of Cd3As2 in two major orientations by a self-selecting vapor growth (SSVG) method, and the optimum growth conditions have been experimentally determined. The crystalline imperfections and electrical properties of the crystals were examined with transmission electron microscopy (TEM), scanning tunneling microscopy (STM), and transport property measurements. This SSVG method makes it possible to control the as-grown crystal compositions with excess Cd or As leading to mobilities near 5-10(5) cm(2)V(-1)s(-1). Zn-doping can effectively reduce the carrier density to reach the maximum residual resistivity ratio (RRRρ300K/ρ5K) of 7.6. A vacuum-cleaved single crystal has been investigated using angle-resolved photoemission spectroscopy (ARPES) to reveal a single Dirac cone near the center of the surface Brillouin zone with a binding energy of approximately 200 meV.

Fermi surface and pseudogap evolution in a cuprate superconductor.

The unclear relationship between cuprate superconductivity and the pseudogap state remains an impediment to understanding the high transition temperature (T(c)) superconducting mechanism. Here, we used magnetic field-dependent scanning tunneling microscopy to provide phase-sensitive proof that d-wave superconductivity coexists with the pseudogap on the antinodal Fermi surface of an overdoped cuprate. Furthermore, by tracking the hole-doping (p) dependence of the quasi-particle interference pattern within a single bismuth-based cuprate family, we observed a Fermi surface reconstruction slightly below optimal doping, indicating a zero-field quantum phase transition in notable proximity to the maximum superconducting T(c). Surprisingly, this major reorganization of the system's underlying electronic structure has no effect on the smoothly evolving pseudogap.