RESUMEN
Measuring the spectral response (SR) of large-area (>100cm2) luminescent solar concentrators (LSCs) has proven difficult because common laboratory photovoltaic (PV) instruments that offer monochromatic incidence measure devices with limited sizes (typically <50cm2). This report addresses this issue through a method called regional measurements. In this method, large-area LSCs are configured to small surface and edge regions, which are sequentially illuminated and measured, respectively. The measured SRs of large-area LSCs are consistent with those from the conventional method and the Monte Carlo ray-tracing simulation. This method is also applied to analyze scattering effects in the LSCs, showing the relationships of the scattering-induced power gain and power loss to the surface root-mean-squared roughness (Rq) of the devices. The results explain why the PV performance of the LSCs can be improved through proper surface scattering treatment.
RESUMEN
A rubber-like stretchable semiconductor with high carrier mobility is the most important yet challenging material for constructing rubbery electronics and circuits with mechanical softness and stretchability at both microscopic (material) and macroscopic (structural) levels for many emerging applications. However, the development of such a rubbery semiconductor is still nascent. Here, we report the scalable manufacturing of high-performance stretchable semiconducting nanofilms and the development of fully rubbery transistors, integrated electronics, and functional devices. The rubbery semiconductor is assembled into a freestanding binary-phased composite nanofilm based on the air/water interfacial assembly method. Fully rubbery transistors and integrated electronics, including logic gates and an active matrix, were developed, and their electrical performances were retained even when stretched by 50%. An elastic smart skin for multiplexed spatiotemporal mapping of physical pressing and a medical robotic hand equipped with rubbery multifunctional electronic skin was developed to show the applications of fully rubbery-integrated functional devices.
RESUMEN
An accurate extraction of physiological and physical signals from human skin is crucial for health monitoring, disease prevention, and treatment. Recent advances in wearable bioelectronics directly embedded to the epidermal surface are a promising solution for future epidermal sensing. However, the existing wearable bioelectronics are susceptible to motion artifacts as they lack proper adhesion and conformal interfacing with the skin during motion. Here, we present ultra-conformal, customizable, and deformable drawn-on-skin electronics, which is robust to motion due to strong adhesion and ultra-conformality of the electronic inks drawn directly on skin. Electronic inks, including conductors, semiconductors, and dielectrics, are drawn on-demand in a freeform manner to develop devices, such as transistors, strain sensors, temperature sensors, heaters, skin hydration sensors, and electrophysiological sensors. Electrophysiological signal monitoring during motion shows drawn-on-skin electronics' immunity to motion artifacts. Additionally, electrical stimulation based on drawn-on-skin electronics demonstrates accelerated healing of skin wounds.