Benzoxazine monomer derived carbon dots as a broad-spectrum agent to block viral infectivity.

Multiple viruses can cause infection and death of millions annually. Of these, flaviviruses are found to be highly prevalent in recent years with no distinctive antiviral therapies. Therefore, there is a desperate need for broad-spectrum antiviral drugs that can be active against a large number of existing and emerging viruses. Herein, we prepared a kind of benzoxazine monomer derived carbon dots (BZM-CDs) and demonstrated their infection-blocking ability against life-threatening flaviviruses (Japanese encephalitis, Zika, and dengue viruses) and non-enveloped viruses (porcine parvovirus and adenovirus-associated virus). It was found that BZM-CDs could directly bind to the surface of the virion, and eventually the first step of virus-cell interaction was impeded. The developed nanoparticles are active against both flaviviruses and non-enveloped viruses in vitro. Thus, the application of BZM-CDs may constitute an intriguing broad-spectrum approach to rein in viral infections.

pH controlled green luminescent carbon dots derived from benzoxazine monomers for the fluorescence turn-on and turn-off detection.

Emerging carbon dots (CDs) are widely used as fluorescent probes in biological and environmental fields, nevertheless, the control of CDs based on different detection mechanisms is rarely reported. In this paper, green luminescent CDs (G-CDs) were prepared by a facile hydrothermal treatment of benzoxazine monomers (BZM). The obtained G-CDs showed pH dependent photoluminescence, which could be designed as fluorescence turn-on and turn-off sensors. The G-CDs exhibited weak photoluminescence at pH = 7.0 and could be turned on by Zn(II) selectively with the limitation of 0.32 µM in the concentration range from 1 to 100 µM. When pH = 10.0, Cr(VI) could quench the strong fluorescence of G-CDs efficiently, and the limit of detection was 0.99 µM with a linear range of 1-50 µM. Furthermore, the fluorescence turn-on and turn-off performance of G-CDs was attributed to the intramolecular charge transfer (ICT) of Zn(II) and the inner filter effect (IFE) of Cr(VI), respectively. The excellent probes were successfully applied for the detection of Zn(II) in biological system and Cr(VI) in environment.

Basophilic green fluorescent carbon nanoparticles derived from benzoxazine for the detection of Cr(vi) in a strongly alkaline environment.

Fluorescent probes for heavy or transition metal ions in extreme environments are crucially important for practical use. In this work, basophilic green fluorescent carbon nanoparticles (G-CNPs) were synthesized by one-pot hydrothermal treatment of benzoxazine in NaOH aqueous solution. These G-CNPs showed favorable dispersibility in strongly alkaline conditions due to the abundant functional groups on their surface. Based on their good photoluminescence properties and excellent stability, the G-CNPs could be used to detect Cr(vi) in a strongly alkaline environment (pH = 14) through a fluorescence quenching effect. This detection process was achieved selectively among 17 anions within 30 seconds and the limitation was 0.58 µM (S/N = 3). It was revealed that the fluorescence turn-off process was caused by the inner filter effect (IFE) of Cr(vi). This study developed efficient fluorescence sensors based on fluorescent carbon nanoparticles, which could be used in strongly alkaline environments.

A green approach for the synthesis of novel Ag3PO4/SnO2/porcine bone and its exploitation as a catalyst in the photodegradation of lignosulfonate into alkyl acids.

A novel Ag3PO4/SnO2/porcine bone composite photocatalyst was successfully prepared via an ion exchange method, which can convert lignin derivatives into small molecular acids upon exposure to visible light at room temperature at ambient pressure. The composition characterization, optical absorption properties and photocatalytic activities of the Ag3PO4/SnO2/porcine bone composites were thoroughly investigated. The certain role of each component of the composites in the degradation reaction was discussed: Ag3PO4 acted as the major active component, while SnO2 and porcine bone as cocatalyst contributed to improve the photocatalytic activity and stability of Ag3PO4. The enhanced activity of the Ag3PO4/SnO2/porcine bone composite may be attributed to the synergistic effect including the matched energy band structures of Ag3PO4 and SnO2 for the decrease in the probability of electron-hole recombination and improved performance in the presence of hierarchical porous porcine bone (hydroxyapatite). This paper also analyzed the change of the molecular weight and structure of sodium lignin sulfonate in the photocatalytic reaction and discussed the possible photocatalytic mechanism of the photocatalyst composite, indicating that the benzene rings of guaiacol were oxidized into different alkyl acids (maleic acid, oxalic acid, formic acid and methoxy acetic acid).

Co Nanoparticles/Co, N, S Tri-doped Graphene Templated from In-Situ-Formed Co, S Co-doped g-C3N4 as an Active Bifunctional Electrocatalyst for Overall Water Splitting.

The development of high-performance electrocatalyst with earth-abundant elements for water-splitting is a key factor to improve its cost efficiency. Herein, a noble metal-free bifunctional electrocatalyst was synthesized by a facile pyrolysis method using sucrose, urea, Co(NO3)2 and sulfur powder as raw materials. During the fabrication process, Co, S co-doped graphitic carbon nitride (g-C3N4) was first produced, and then this in-situ-formed template further induced the generation of a Co, N, S tri-doped graphene coupled with Co nanoparticles (NPs) in the following pyrolysis process. The effect of pyrolysis temperature (700, 800, and 900 °C) on the physical properties and electrochemical performances of the final product was studied. Thanks to the increased number of graphene layer encapsulated Co NPs, higher graphitization degree of carbon matrix and the existence of hierarchical macro/meso pores, the composite electrocatalyst prepared under 900 °C presented the best activity for both hydrogen evolution reaction (HER) and oxygen evolution reaction (OER) with outstanding long-term durability. This work presented a facile method for the fabrication of non-noble-metal-based carbon composite from in-situ-formed template and also demonstrated a potential bifunctional electrocatalyst for the future investigation and application.

Facile Synthesis of Carbon-Coated Spinel Li4Ti5O12/Rutile-TiO2 Composites as an Improved Anode Material in Full Lithium-Ion Batteries with LiFePO4@N-Doped Carbon Cathode.

The spinel Li4Ti5O12/rutile-TiO2@carbon (LTO-RTO@C) composites were fabricated via a hydrothermal method combined with calcination treatment employing glucose as carbon source. The carbon coating layer and the in situ formed rutile-TiO2 can effectively enhance the electric conductivity and provide quick Li+ diffusion pathways for Li4Ti5O12. When used as an anode material for lithium-ion batteries, the rate capability and cycling stability of LTO-RTO@C composites were improved in comparison with those of pure Li4Ti5O12 or Li4Ti5O12/rutile-TiO2. Moreover, the potential of approximately 1.8 V rechargeable full lithium-ion batteries has been achieved by utilizing an LTO-RTO@C anode and a LiFePO4@N-doped carbon cathode.

Improved Electrochemical Performance of LiFePO4@N-Doped Carbon Nanocomposites Using Polybenzoxazine as Nitrogen and Carbon Sources.

Polybenzoxazine is used as a novel carbon and nitrogen source for coating LiFePO4 to obtain LiFePO4@nitrogen-doped carbon (LFP@NC) nanocomposites. The nitrogen-doped graphene-like carbon that is in situ coated on nanometer-sized LiFePO4 particles can effectively enhance the electrical conductivity and provide fast Li+ transport paths. When used as a cathode material for lithium-ion batteries, the LFP@NC nanocomposite (88.4 wt % of LiFePO4) exhibits a favorable rate performance and stable cycling performance.

Animal Bone Supported SnO2 as Recyclable Photocatalyst for Degradation of Rhodamine B Dye.

SnO2 nanoparticles supported on an animal bone which serves as inexpensive and environment-friendly natural products were developed by a facile hydrothermal approach. As a promising photocatalyst, the novel SnO2/porcine bone material exhibited high photocatalytic activity towards the degradation of rhodamine B (RhB) dye under UV-Vis irradiation. About 97.3% of RhB can be effectively decomposed by the catalysis with the SnO2/porcine bone in 90 min, while only 51.5% of RhB can be degraded by pure SnO2 nanoparticles. Moreover, the photocatalytic activity was incremental with the increase of cycle times in previous five cycles. It is mainly because the photocatalyst which has been used for several times possesses a stronger ability of light absorption and utilization compared to the fresh catalyst according to the results of the characterization and relative experiments. It is noteworthy that the animal bone support can improve the activity for the photocatalyst, which would provide further impetus to alternate synthesis strategies for photocatalysts and make the photocatalysis process faster, less expensive, and more environmentally friendly.

Gas-liquid countercurrent integration process for continuous biodiesel production using a microporous solid base KF/CaO as catalyst.

A continuous-flow integration process was developed for biodiesel production using rapeseed oil as feedstock, based on the countercurrent contact reaction between gas and liquid, separation of glycerol on-line and cyclic utilization of methanol. Orthogonal experimental design and response surface methodology were adopted to optimize technological parameters. A second-order polynomial model for the biodiesel yield was established and validated experimentally. The high determination coefficient (R(2)=98.98%) and the low probability value (Pr<0.0001) proved that the model matched the experimental data, and had a high predictive ability. The optimal technological parameters were: 81.5°C reaction temperature, 51.7cm fill height of catalyst KF/CaO and 105.98kPa system pressure. Under these conditions, the average yield of triplicate experiments was 93.7%, indicating the continuous-flow process has good potential in the manufacture of biodiesel.

Transdermal evaporation delivery system of praziquantel for schistosomiasis japonicum chemotherapy.

A transdermal evaporation delivery system (TEDS) of praziquantel (PZQ) was developed by selecting ethylene glycol monophenyl ether as a nonvolatile component solvent and ethanol as a volatile component solvent to control efficiently the transmission and morbidity of the global schistosomiasis, providing a convenient administration system of PZQ for both humans and domestic animals. The solubility of PZQ in TEDS was more than 400 mg/mL when the ethanol concentration was 50% (w/w) in the solvent mixture at 32 °C, enabling to adapt requirements for the treatment of schistosomiasis. The highest serum drug concentration reached 35.93 µg/mL after transdermal administration of TEDS of PZQ in rabbits, being 6.3-fold higher than that after oral administration at the same dose. The TEDS of PZQ achieved treatment efficacy with the worm reduction of 100% when it was applied in the experimental treatment of Schistosoma japonicum in rabbits. The TEDS of PZQ that provides passive and nonocclusive delivery, having the inexpensive cost, low skin irritation rates, and precise dose of administration, should find application in the transmission control and chemotherapy of global schistosomiasis.

Transdermal delivery of praziquantel: effects of solvents on permeation across rabbit skin.

To explore a new method for the transdermal delivery of praziquantel (PZQ), the effects of solvents on permeation across rabbit skin were investigated. The solubility of PZQ in five different solvents, ethylene glycol monophenyl ether (EGPE), 1,4-dioxane, tetrahydrofuran, dimethyl sulfoxide, and oleic acid, were measured with a UV-Vis spectrophotometer. The determination of the n-octanol/water partition coefficient of PZQ in the five different solutions and assay of serum concentration following PZQ transdermal administration in rabbits were performed using HPLC. The results indicated that the transdermal absorption of the drug was related to the partition coefficient and lipophilic characteristics of the solvent. The optimal solvent for PZQ transdermal delivery was EGPE in our protocol. The solubility of PZQ in EGPE is >400 mg/ml, and the apparent partition coefficient of PZQ in the solution is 0.895 (log P value). After transdermal administration of PZQ in EGPE solution, the bioavailability is 2.85-fold that after oral administration. The serum drug concentration was maintained at 4.0 mug/ml over 4 h, which is sufficient for the treatment of schistosomiasis. At the same time, no apparent side effects were found on the skin. EGPE may thus be a promising vehicle for the transdermal delivery of PZQ in the future.