Mucoadhesive chitosan films as a potential ocular delivery system for ofloxacin: preliminary in vitro studies.

OBJECTIVE: The objective of the study is to evaluate the physical properties, in vitro release profile, and antibacterial efficiency of chitosan films prepared with ofloxacin. PROCEDURE: Mucoadhesive films were prepared by means of a casting and solvent evaporation technique performed in a 2 wt% acetic acid solution and distilled water. Physical properties were characterized by release and swelling studies, differential scanning calorimetry (DSC) analysis, and attenuated total reflectance Fourier transformed infrared spectroscopy (ATR-FTIR) analysis. The in vitro evaluation of the films was performed by inhibiting Staphylococcus aureus and Pseudomonas aeruginosa through activity studies. RESULTS: Circular ofloxacin-loaded chitosan-developed films with 0.3 mg of drug weighed 7 mg were 110 µm thick and 5 mm in diameter. The DSC curve of ofloxacin-loaded chitosan films suggests an amorphous dispersion of ofloxacin within these films. ATR-FTIR analysis showed that ofloxacin is indeed present in the matrix film. The drug was released in vitro over a 1-h period. No statistical difference could be observed between the ofloxacin-loaded chitosan films and sterile disk soaked for 1 min in 0.3% commercial ofloxacin ophthalmic solution for S. aureus and P. aeruginosa (P = 0.1686, P = 0.1172, respectively).The films presented a significantly larger mean bacterial inhibition zone of S. aureus than did the commercial ciprofloxacin control disk (P = 0.0002) and a significantly larger mean bacterial kill zone of P. aeruginosa than did the commercial enrofloxacin control disk (P < 0.0001). CONCLUSIONS: Ofloxacin was successively incorporated onto chitosan films and was not inactivated during the process of manufacturing, thus preserving antibacterial proprieties.

Determination of Mycophenolic acid in the vitreous humor using the HPLC-ESI-MS/MS method: application of intraocular pharmacokinetics study in rabbit eyes with ophthalmic implantable device.

Mycophenolic acid (MPA) is an immunosuppressive agent widely used in the treatment of solid organ transplant rejection. The success of MPA in the treatment of inflammatory intraocular diseases has been reported in recent literature. The treatment of inflammatory eye diseases in the posterior chamber is a challenge due to the anatomy of the eye, which presents certain barriers to drug access. Thus, the bioavailability of drugs in the eye is quite low, and successful drug delivery may well represent a key limiting factor to attaining a successful therapeutic strategy. Ophthalmic controlled drug delivery offers the potential to enhance the efficacy of treatment for pathological conditions. Thus, a novel delivery system based on a biodegradable polymeric device, which can be implanted inside the eye and deliver MPA directly to the target, is being developed. Specific analytical methods to determine the use of effective drugs within the eye are needed to characterize this device. A liquid chromatography-electrospray ionization tandem mass spectrometry (HPLC-ESI-MS/MS) method for the quantitation of MPA in the vitreous humor of rabbits was developed and validated. The vitreous was collected from rabbits, extracted by a protein precipitation extraction procedure and then separated on a C18 column with a mobile phase comprised of 0.15% aqueous acetic acid and methanol (60:40, v/v). The calibration curve was constructed within the range of 3-10,000 ng/mL for MPA. The mean R.S.D. values for the intra-run and inter-run precision were 5.15% and 4.35%. The mean accuracy value was 100.16%. The validated method was successfully applied to determine the MPA concentration in the vitreous humor of rabbits treated with an ocular implantable device.

Determination of ofloxacin in tear by HPLC-ESI-MS/MS method: comparison of ophthalmic drug release between a new mucoadhesive chitosan films and a conventional eye drop formulation in rabbit model.

Ofloxacin, second-generation fluoroquinolone derivative, is one of the most commonly used to treat and prevent superficial ocular infection in animals and human beings. However, poor bioavailability, rapid elimination, and non compliance by patients are several problems associated with ocular route. Ophthalmic controlled drug delivery offers the potential to enhance the efficacy of treatment for pathological conditions, while reducing the side effects and the toxicity associated with frequent applications. Specific analytical methods to determine drugs in eye are needed to analyze and compare the new controlled release ocular devices with those conventional eye drops. The topical eye administration of ophthalmic drugs induces lachrymation, and the tear promotes a drug wash out. Quantify drugs in tear is a good tool to study their kinetic comportment in the eye. A liquid chromatography-electrospray ionization tandem mass spectrometry (HPLC-ESI-MS/MS) method for quantitation of ofloxacin in rabbits' tears was developed and validated. The tear was collected with tear strips, extracted by a liquid extraction procedure and then separated on an ACE C(18) column with a mobile phase composed of 0.15% aqueous formic acid and methanol (60:40, v/v). Calibration curve was constructed over the range of 10-5000 ng/mL for ofloxacin. The mean R.S.D. values for the intra-run and inter-run precision were 5.15% and 4.35%, respectively. The mean accuracy value was 100.16%. The validated method was successfully applied to determine the ofloxacin concentration in tears of rabbits treated with a mucoadhesive chitosan films and a conventional eye drop formulation.