RESUMEN
This study investigated the effect of different carrier materials on the in vitro properties of progesterone solid dispersions. The solid dispersions of the insoluble drug progesterone were prepared by hot melt extrusion technique using rheological properties as the index of investigation, and the in vitro properties of the solid dispersions were characterized. Scanning electron microscope revealed solid dispersions with rough surfaces and agglomerated microstructures into irregular lumpy particles. Differential scanning calorimetry and powder X-ray diffraction showed the change of progesterone crystalline form in solid dispersions from crystalline to amorphous state. In vitro dissolution studies showed that solid dispersions prepared with different carrier materials can effectively improve the dissolution rate of drugs. The results of the study showed that the type of carrier material had a significant effect on the in vitro properties of solid dispersions, providing a reference for the study of solid dispersions in the controlled release of insoluble drugs.
RESUMEN
Puerarin (PUE), as an isoflavone component, has a wide range of pharmacological activities, while its poorly aqueous solubility limits the development of solid oral dosage forms. In this study, PUE along with nicotinamide (NIC) were prepared into the coamorphous system by solvent-evaporation method and characterized by powder X-ray diffraction (PXRD), differential scanning calorimetry (DSC) and Fourier transform infrared spectroscopy (FT-IR). In addition, its dissolution behavior and solubilization mechanism were also investigated. PUE-NIC coamorphous was a single homogeneous binary system, with a single glass transition temperature at 35.1 ℃. In comparison to crystalline PUE, during the dissolution process, coamorphous PUE-NIC not only exhibited the "liquid-liquid phase separation" (LLPS) phenomenon, but the formation of Ap type complexation (1∶1 and 1∶2) between PUE and NIC molecules was also verified, which significantly improved the solubility of PUE and prolonged the supersaturation time, and would benefit its absorption.
RESUMEN
Compared with crystalline drugs, their amorphous forms present long-range disordered molecular arrangements, and often exhibit higher apparent solubility and dissolution. However, several small molecule amorphous drugs may exhibit gelation phenomenon during the dissolution process, and show abnormal dissolution behavior with significantly lower dissolution than crystalline drugs. The current study aims to discover the relationship between the gelation of amorphous drugs and their abnormal dissolution, and further explore the internal gelation mechanism. Amorphous simvastatin (SIM), carvedilol (CAR), and irbesartan (IRB) were prepared by melt cooling method and characterized via X-ray powder diffraction (XRPD), differential scanning calorimetry (DSC), and Fourier transform infrared spectroscopy (FT-IR). Gel formation causes the dissolution of these three amorphous drugs to be significantly lower than their crystalline state. The formed gels were characterized as three-dimensional dense network structures by scanning electron microscope (SEM). Furthermore, amorphous SIM, CAR and IRB showed the critical gel temperature at 8-15 ℃, 25-30 ℃ and 45-50 ℃, and amorphous CAR and IRB showed the critical gel pH at 1 and 0.25. The mechanism of gel formation was proposed to be closely related to the transformation of amorphous drugs into the supercooled liquid state (as the important driving force) and the protonation induced self-assembling under acidic conditions. In addition, the wettability and properties of amorphous drugs also affect the formation of gelation.
RESUMEN
Biphasic dissolution test, consisting of immiscible aqueous and organic phase, is an in vitro dissolution method that simultaneously measures the dissolution and partition of drugs. Due to the advantages of simulating in vivo absorption and overcoming the influence of surfactants on dissolution, it has been widely used to evaluate the poorly soluble drugs in vitro dissolution. Based on the relevant research in this field in recent years, this review summarizes the history, dissolution device, theoretical model and application of the biphasic dissolution test. Finally, the prospects in the development of biphasic dissolution test are also outlined.
RESUMEN
The solubility of nebivolol hydrochloride was determined in acidic aqueous media in the absence and presence of different concentration of NaCl, NaBr, or NaI at 37 ℃ in order to facilitate proper selection of dissolution media that have adequate discriminating power for enhancing the likelihood of a generic drug product to successfully pass in-vivo bioequivalence test. In the range of pH 5.0 to pH 1.0, the solubility of nebivolol hydrochloride decreased with the decrease in the pH of aqueous solution, and the solubility of nebivolol hydrochloride further decreased with the increase in the concentration of added sodium chloride. The solubility decrease of a few weakly basic drug molecules in acidic media and in higher concentration of added chloride was published previously by other researchers, and the observed decrease in the solubility in the presence of higher chloride concentration was interpreted in terms of common-ion effect. However, the results in this paper showed that the solubility of nebivolol hydrochloride also decreased when sodium chloride was replaced with sodium bromide or iodide. The approach described in this paper (i.e. substituting sodium chloride with sodium bromide or iodide) provides an effective method to verify whether common-ion effect is the true (or at least the sole) driving force behind the observed decrease in the solubility of nebivolol hydrochloride in the presence of sodium chloride. The solubility decrease reported in this paper can be interpreted in terms of salting-out effect of sodium chloride, bromide, and iodide. For hydrochloride salt of a weakly basic drug molecule like nebivolol hydrochloride, its solubility in an acidic dissolution medium can be purposely decreased to the lower end of sink condition by adding sodium chloride to make the resulting medium more discriminating. As shown in this paper, a medium at pH 1.2 with added sodium chloride is discriminating and this medium is shown to be bio-relevant to the in-vivo data collected under fasting condition (in-vivo study protocol was approved by Institutional Review Board).
RESUMEN
The aim of this study is to investigate the influence of flufenamic acid (FFA) on the solubility, dissolution and bioavailability of sorafenib (SFN) in the combined administration of the MSNM@SFN and FFA. The MSNM@SFN&FFA was prepared by mixing the MSNM@SFN with FFA. The solubility, dissolution and bioavailability of SFN in the MSNM@SFN&FFA complex was investigated in comparison with those of the MSNM@SFN. This study was performed following the National Institutes of Health guidelines for the use of experimental animals; all care and handling of animals were performed with the approval of the Experimental Animal Center of Peking University Health Science Center. The MSNM@SFN&FFA showed no significant influence on the solubility, dissolution and bioavailability of SFN when compared with the MSNM@SFN. These data indicated that FFA had almost no influence on the solubility, dissolution and bioavailability of SFN in the combined administration of MSNM@SFN and FFA, thus providing an experimental foundation for the subsequent formulation research on the combined usage of drugs.