[Identification of LSD Derivatives, 1cP-LSD, MIPLA and 1B-LSD in Illegal Products as Paper Sheet].

Lysergic acid diethylamide (LSD) is a hallucinogen, synthesized from ergot alkaloid, and controlled as a narcotic in Japan. Recently, LSD derivatives have appeared as designer drugs, all over the world. In previous study, we reported identification and analysis of four LSD derivatives in four paper sheet products. In this study, we detected three additional LSD derivatives from three paper sheet products, which were obtained from September 2019 to March 2020 in Japan. We extracted the compounds from paper sheet products with methanol for LC-MS, high-resolution MS and GC-MS analyses. The compounds were identified as 4-cyclopropionyl-N,N-diethyl-7-methyl-4,6,6a,7,8,9-hexahydroindolo[4,3-fg]quinoline-9-carboxamide (1cP-LSD), N-methyl-N-isopropyl-7-methyl-4,6,6a,7,8,9-hexahydroindolo-[4,3-fg]quinoline-9-carboxamide (MIPLA), 4-butyryl-N,N-diethyl-7-methyl-4,6,6a,7,8,9-hexahydroindolo[4,3-fg]quinoline-9-carboxamide (1B-LSD), by GC-MS, LC-MS, LC-Q-TOF-MS and NMR analyses. As well as other N1-acylated LSD derivatives, 1cP-LSD and 1B-LSD were easily deacylated to LSD during GC-MS analysis, we have to be careful to analyze these compounds.

Lab-made solid phase microextraction phases for off line extraction and direct mass spectrometry analysis: Evaluating the extraction parameters.

The analyses of drugs and metabolites in complex matrices have been widely studied in recent years. However, due to high levels endogenous compounds and matrix complexity, these analyses require a sample pre-treatment step. To this aim, two lab-made extractive phases were integrated to probe electrospray ionization mass spectrometry (PESI-MS) technique for direct analysis of illicit drugs in biological fluids and phorbol esters in Jatropha curcas extract. The polypyrrole (PPy) phase was electropolymerized onto a platinum wire surface by cyclic voltammetry. The molecularly imprinted polymer (MIP) was synthesized and adhered onto a stainless-steel needle with epoxy resin. The PPy-PESI-MS method showed to be linear in a concentration range from 1 to 500 µg L-1, with accuracy values between -2.1 and 14%, and precision values between 0.8 and 10.8%. The MIP-PESI-MS method showed to be linear in a concentration range from 0.9 to 30 mg L-1, with accuracy values between -1.6 and -15.3%, and precision values between 4.1 and 13.5%.

Ultrasensitive analysis of lysergic acid diethylamide and its C-8 isomer in hair by capillary zone electrophoresis in combination with a stacking technique and laser induced fluorescence detection.

This article deals with the development and validation of a novel capillary zone electrophoresis (CZE) with laser induced fluorescence detection method for the analysis of lysergic acid diethylamide (LSD) and its isomer iso-LSD in hair samples. The separation of both analytes has been achieved in less than 13 min in a 72-cm effective length capillary with 75-µm internal diameter. As running buffer 25 mM citrate, pH 6.0 has been employed and separation temperature and voltage of 20 °C and 13 kV respectively, were applied. Field amplified sample injection (FASI) has been employed for on-line sample preconcentration, using ultrapure water containing 117 µM H3PO4 as optimum injection medium. Injection voltage and time have been optimized by means of experimental design, obtaining values of 7 kV and 15s, respectively. Methylergonovine has been employed as internal standard in order to compensate irreproducibility from electrokinetic injection. The analytical method has been applied to hair samples, previous extraction of the target analytes by ultrasound assisted solid-liquid extraction at 40 °C for 2.5 h, employing acetonitrile as extracting solvent. Linear responses were found for LSD and iso-LSD in matrix-matched calibrations from around 0.400 up to 50.0 pg mg(-1). LODs (3 S/N) in the order of 0.100 pg mg(-1) were calculated for both analytes, obtaining satisfactory recovery percentages for this kind of sample.

Electrochemistry and analytical determination of lysergic acid diethylamide (LSD) via adsorptive stripping voltammetry.

Lysergic acid diethylamide (LSD) is hardly detectable and quantifiable in biological samples because of its low active dose. Although several analytical tests are available, routine analysis of this drug is rarely performed. In this article, we report a simple and accurate method for the determination of LSD, based on adsorptive stripping voltammetry in DMF/tetrabutylammonium perchlorate, with a linear range of 1-90 ng L(-1) for deposition times of 50s. LOD of 1.4 ng L(-1) and LOQ of 4.3 ng L(-1) were found. The method can be also applied to biological samples after a simple extraction with 1-chlorobutane.

Dispersive liquid-liquid microextraction prior to field-amplified sample injection for the sensitive analysis of 3,4-methylenedioxymethamphetamine, phencyclidine and lysergic acid diethylamide by capillary electrophoresis in human urine.

A novel capillary zone electrophoresis (CZE) with ultraviolet detection method has been developed and validated for the analysis of 3,4-methylenedioxymethamphetamine (MDMA), lysergic acid diethylamide (LSD) and phencyclidine (PCP) in human urine. The separation of these three analytes has been achieved in less than 8 min in a 72-cm effective length capillary with 50-µm internal diameter. 100 mM NaH(2)PO(4)/Na(2)HPO(4), pH 6.0 has been employed as running buffer, and the separation has been carried out at temperature and voltage of 20°C, and 25kV, respectively. The three drugs have been detected at 205 nm. Field amplified sample injection (FASI) has been employed for on-line sample preconcentration. FASI basically consists in a mismatch between the electric conductivity of the sample and that of the running buffer and it is achieved by electrokinetically injecting the sample diluted in a solvent of lower conductivity than that of the carrier electrolyte. Ultrapure water resulted to be the better sample solvent to reach the greatest enhancement factor. Injection voltage and time have been optimized to 5 kV and 20s, respectively. The irreproducibility associated to electrokinetic injection has been correcting by using tetracaine as internal standard. Dispersive liquid-liquid microextraction (DLLME) has been employed as sample treatment using experimental design and response surface methodology for the optimization of critical variables. Linear responses were found for MDMA, PCP and LSD in presence of urine matrix between 10.0 and 100 ng/mL approximately, and LODs of 1.00, 4.50, and 4.40 ng/mL were calculated for MDMA, PCP and LSD, respectively. The method has been successfully applied to the analysis of the three drugs of interest in human urine with satisfactory recovery percentages.

Ergot and its alkaloids.

This manuscript reviews the history and pharmacognosy of ergot, and describes the isolation/preparation, chemistry, pharmacodynamics, and pharmacotherapeutics of the major ergot alkaloids and their derivatives. A brief discussion of the hallucinogenic properties of lysergic acid diethylamide is also featured. An abbreviated form of the material found in this paper is presented in a 4-hour didactic format to third-professional year PharmD students as part of their study of vascular migraine headaches, Parkinson's disease, and naturally occurring hallucinogens/hallucinogen derivatives in the modular course offering Neurology/Psychiatry.

Separation of D-lysergic acid diethylamide derivatives using micellar electrokinetic capillary chromatography.

By adjusting column temperature and applied electric field, a fast separation in micellar electrokinetic capillary chromatography was developed for the separation of D-lysergic acid diethylamide derivatives. A baseline separation of nine derivatives was accomplished with a run time of less than 12 min by utilizing elevated column temperature (60 degrees C) and an applied electric field of 387 V/cm. The number of plates generated per unit time for the separations completed at elevated temperatures was significantly higher when compared to separations at the same applied electric field but at lower temperatures (20 degrees C).

Detection of lysergic acid diethylamide (LSD) in urine by gas chromatography-ion trap tandem mass spectrometry.

A confirmatory method for the detection and quantitation of lysergic acid diethylamide (LSD) is presented. The method employs gas chromatography-tandem mass spectrometry (GC-MS-MS) using an internal ionization ion trap detector for sensitive MS-MS-in-time measurements of LSD extracted from urine. Following a single-step solid-phase extraction of 5 mL of urine, underivatized LSD can be measured with limits of quantitation and detection of 80 and 20 pg/mL, respectively. Temperature-programmed on-column injections of urine extracts were linear over the concentration range 20-2000 pg/mL (r2 = 0.999). Intraday and interday coefficients of variation were < 6% and < 13%, respectively. This procedure has been applied to quality-control specimens and LSD-positive samples in this laboratory. Comparisons with alternate GC-MS methods and extraction procedures are discussed.

Immunochemical extraction and detection of LSD in whole blood.

Polyclonal antibodies raised against the hallucinogenic drug, lysergic acid diethylamide (LSD), were used to detect and extract drug from whole blood samples. An indirect ELISA was used to detect as little as 1 pg of total drug in 25 microl blood. The limit of detection of the immunoassay, calculated from the mean - 3 SD was 39 pg/ml. The analytical recovery of LSD (2.5-0.2 ng/ml) from whole blood was 102-113%. Within-run CVs for LSD spiked in blood at 1.25, 0.16 and 0.04 ng/ml were 5.6, 3.1, and 8.9%, respectively (n = 4). There was an overall decrease in precision when whole blood was used in place of urine, due to the increased complexity of the matrix. However, using this technique LSD was calibrated in blood in the sub-ng/ml region of forensic interest. Immunoaffinity extraction was used to isolate LSD from blood and urine samples. The affinity support was prepared by covalently attaching anti-LSD antibodies to Protein A-coated agarose beads. No pre-treatment of the sample was required other than the addition of neutral buffer. Sub-ng/ml concentrations of LSD were routinely extracted from blood and urine samples with greater than 80% recovery of drug. This technique, which could be used to extract LSD from blood and urine samples prior to confirmatory drug analysis, could be completed in about 10 min.

Automated extraction of lysergic acid diethylamide (LSD) and N-demethyl-LSD from blood, serum, plasma, and urine samples using the Zymark RapidTrace with LC/MS/MS confirmation.

A forensic procedure for the quantitative confirmation of lysergic acid diethylamide (LSD) and the qualitative confirmation of its metabolite, N-demethyl-LSD, in blood, serum, plasma, and urine samples is presented. The Zymark RapidTrace was used to perform fully automated solid-phase extractions of all specimen types. After extract evaporation, confirmations were performed using liquid chromatography (LC) followed by positive electrospray ionization (ESI+) mass spectrometry/mass spectrometry (MS/MS) without derivatization. Quantitation of LSD was accomplished using LSD-d3 as an internal standard. The limit of quantitation (LOQ) for LSD was 0.05 ng/mL. The limit of detection (LOD) for both LSD and N-demethyl-LSD was 0.025 ng/mL. The recovery of LSD was greater than 95% at levels of 0.1 ng/mL and 2.0 ng/mL. For LSD at 1.0 ng/mL, the within-run and between-run (different day) relative standard deviation (RSD) was 2.2% and 4.4%, respectively.

The isolation and identification of lysergic acid diethylamide (LSD) from sugar cubes and a liquid substrate.

This report describes a simplified extraction technique for the analysis of LSD by GC/MS. The South Carolina Law Enforcement Division Forensic Laboratory recently received two suspected LSD cases involving four sugar cubes and seven food coloring bottles each containing a liquid substance. Following the extraction described in this report, both cases were subsequently confirmed by GC/MS and quantitated by HPLC.

Study of the extraction of LSD from illicit blotters for HPLC determination.

The effect of different parameters (extraction method, temperature, time, solvent) on the extraction efficiency of LSD from impregnated papers has been investigated. Designed experiments have been applied according to the Plackett-Burman method. For the quantitative determination of LSD reversed phase ion-pair chromatography has been used with UV detection. The experimental conditions assuring maximal LSD recovery have been determined, as well as the constant and proportional bias of the extraction procedure elaborated.

Alkaloids of Stipa robusta (sleepygrass) infected with an Acremonium endophyte.

Stipa robusta (= Stipa vaseyi) is a perennial grass found in certain areas of the southwestern United States. It is commonly known as sleepygrass, as horses that ingest this grass may become profoundly somnolent or stuporous for periods of time lasting up to several days. In an attempt to determine the active principle(s), fractionation of a methanolic extract of sleepygrass infected with an Acremonium endophyte has yielded lysergic acid amide (20 micrograms/g dry wt), isolysergic amide (8), 8-hydroxylsergic acid amide (0.3), ergonovine (7), chanoclavine-I (15), and N-formylloline (18). Related alkaloids have been found in many endophyte-infected grasses. The dominant alkaloid constituent in sleepygrass, lysergic acid amide, has not previously been identified in a grass in such high concentration. Lysergic acid amide is likely to be the basis for the extreme sedative effects on animals, given past pharmacological work on the compound from the ergot fungus Claviceps paspali.

A low-cost differential fluorimeter for the detection and determination of LSD in illicit preparations.

The construction and use of a differential fluorimeter for rapid detection of LSD in confiscated material under field conditions is described. The apparatus is robust, electronics-free, compact and inexpensive. Adequate sensitivity is ensured by the high quantum yield of LSD fluorescence and a large degree of specificity is obtained by carrying-out two separate measurements: one in water and one in 1 M NaOH.