Gaining Access to Bacteria through (Reversible) Control of Lipophilicity.

The development of antimicrobial photodynamic therapy (aPDT) is highly dependent on the development of suitable photosensitizers (PSs); ideally, affinity of a PS towards bacterial cells should be much higher than that towards mammalian cells. A cationic charge on a PS may lead to its selective binding to bacteria mediated through electrostatic interaction; however, the photodynamic outcome is highly dependent on the lipophilicity of the PS. Herein, we report the aPDT effect of silicon(IV) phthalocyanine derivatives bearing four positive charges and methyl, phenyl, or naphthyl substituents at the periphery of the macrocycle. We show that through modulation of lipophilicity, it is possible to find a therapeutic window in which bacteria, but not mammalian cells, are effectively killed. The photobiological activity of these PSs was significantly lower when they were deployed as host-guest complexes with cucurbit[7]uril (CB[7]). CB[7] blocks the hydrophobic part of the PS and reduces its lipophilicity, indicating that a hydrophobic interaction with the outer membrane of bacterial cells is essential for aPDT activity. The efficacies of the obtained PSs have been evaluated by using different uropathogenic E. coli isolates and human kidney epithelial carcinoma cells.

Impact of UV and peracetic acid disinfection on the prevalence of virulence and antimicrobial resistance genes in uropathogenic Escherichia coli in wastewater effluents.

Wastewater discharges may increase the populations of pathogens, including Escherichia coli, and of antimicrobial-resistant strains in receiving waters. This study investigated the impact of UV and peracetic acid (PAA) disinfection on the prevalence of virulence and antimicrobial resistance genes in uropathogenic Escherichia coli (UPEC), the most abundant E. coli pathotype in municipal wastewaters. Laboratory disinfection experiments were conducted on wastewater treated by physicochemical, activated sludge, or biofiltration processes; 1,766 E. coli isolates were obtained for the evaluation. The target disinfection level was 200 CFU/100 ml, resulting in UV and PAA doses of 7 to 30 mJ/cm(2) and 0.9 to 2.0 mg/liter, respectively. The proportions of UPECs were reduced in all samples after disinfection, with an average reduction by UV of 55% (range, 22% to 80%) and by PAA of 52% (range, 11% to 100%). Analysis of urovirulence genes revealed that the decline in the UPEC populations was not associated with any particular virulence factor. A positive association was found between the occurrence of urovirulence and antimicrobial resistance genes (ARGs). However, the changes in the prevalence of ARGs in potential UPECs were different following disinfection, i.e., UV appears to have had no effect, while PAA significantly reduced the ARG levels. Thus, this study showed that both UV and PAA disinfections reduced the proportion of UPECs and that PAA disinfection also reduced the proportion of antimicrobial resistance gene-carrying UPEC pathotypes in municipal wastewaters.

A flow chamber assay for quantitative evaluation of bacterial surface colonization used to investigate the influence of temperature and surface hydrophilicity on the biofilm forming capacity of uropathogenic Escherichia coli.

We have established a simple flow chamber-based procedure which provides an accurate and reproducible way to measure the amount of biofilm formed on an implantable biomaterial surface. The method enables the side-by-side evaluation of different materials under hydrodynamic flow conditions similar to those found on an implanted device. We have used the method to evaluate the biofilm forming capacity of clinically isolated Escherichia coli on silicone rubber and on silicone rubber containing a hydrophilic coating. It was found that the surface chemistry influenced the colonization of the isolates very differently. In addition, the temperature was found to have a considerable influence upon the adhesion and biofilm forming capacity of some of the isolates, and that the influence of surface chemistry depended on temperature. Our results suggest that the step from using E. coli laboratory strains to clinical isolates entails a significant rise in complexity and yields results that cannot be generalized. The results should be valuable information for researchers working with pre-clinical evaluation of device-associated E. coli infections.