ABSTRACT
The research and development of low-power-consumption and room-temperature hydrogen sensors are of great significance for the safe application of hydrogen energy. Herein, orthorhombic Nb2O5-x nanobelts are prepared through a combined procedure of hydrothermal, ion exchange, and annealing treatment in Ar. The topological transformation process results in the formation of abundant surface defects including chemical defects such as Nb4+, oxygen vacancies, and disordered microregions, which lead to the abnormal p-type conducting and hydrogen sensing behavior. Moreover, the orthorhombic Nb2O5-x nanobelts exhibit fast and sensitive room-temperature hydrogen sensing performance, which shows greater advancement than the monoclinic, tetragonal, and hexagonal Nb2O5 one-dimensional (1D) nanostructures. The response time and lowest limit of detection of the as-fabricated room-temperature sensor decrease to 28 s and 3.5 ppm, respectively. The sensor also exhibits a highly selective hydrogen response against CO, CH4, ethanol, H2S, and NH3. The hydrogen response of the Nb2O5-x nanobelts can be attributed to the redox reaction between hydrogen and preadsorbed oxygens. The defective surface structure and the prolonged dimension of the nanobelts give rise to the highly reactive surface and the suppression of the negative nanojunction effect, which greatly improves the sensing performance. The orthorhombic lattice structure can also promote gas adsorption and diffusion behavior due to its specific catalytic and pathway effect. The results of this work can be helpful for the rational design and defect engineering of the Nb2O5-based 1D nanostructures for room-temperature hydrogen sensing applications.
ABSTRACT
This work systematically investigated the thermoelectric properties of p-type Na and M (M = K, Li, Ag) codoped polycrystalline SnSe. It is found that the electrical properties of polycrystalline SnSe can be improved significantly for (Na, Ag) codoped samples, contributed by the enhanced carrier concentration. Specifically, a carrier concentration of 6.23 × 1019 cm-3 was obtained in Sn0.98Na0.016Ag0.004Se sample at 335 K, an increase of 18% compared with that of the Na single-doped sample (5.22 × 1019 cm-3). The power factor reached â¼0.73 mW m-1 K-2 for the Sn0.98Na0.016Ag0.004Se sample at 785 K, enhanced by â¼26% compared with Na single-doped one. In addition, Sn-rich and Ag-rich particles/areas observed in the matrix of Sn0.98Na0.016Ag0.004Se contribute to the reduction of lattice thermal conductivity from 0.61 W m-1 K-1 for Sn0.98Ag0.02Se to 0.47 W m-1 K-1 at 785 K. The combination of simultaneously enhanced power factor and depressed thermal conductivity leads to a maximum ZT ≈ 1.2 at 785 K and a high average ZT ≈ 0.74 at 335-785 K for Sn0.98Na0.016Ag0.004Se, and generating a high theoretical conversion efficiency of â¼11%. These illuminating discoveries could provide routes to enhance the thermoelectric performance in p-type polycrystalline SnSe.
ABSTRACT
The aim of this study is to evaluate the influence of Tooth Mousse (TM) application, smear layer removal, and storage time on resin-dentin microtensile bond strength (µTBS). Dentin specimens were divided into two groups: (1) smear layer covered; (2) smear layer removed using 15% EDTA for 90 s. In each group, half the specimens were treated once with TM for 60 min. After bonding procedures using a two-step self-etching adhesive (Clearfil SE Bond (CSE); Kuraray Medical, Tokyo, Japan), an all-in-one adhesive (G-Bond (GB); GC Corp, Tokyo, Japan), and a total-etch adhesive (Adper Single Bond 2 (SB); 3M ESPE, St. Paul, MN, USA), the specimens were stored for 3 d or 6 months in deionized water at 37 °C, and µTBS was tested and analyzed. With the exception of SB (no TM application) and GB, the µTBS was significantly increased for CSE and SB using EDTA pre-conditioning and 3 d of storage (P≤0.001). Bond strength of GB decreased significantly when using EDTA (3 d storage, P<0.05). TM application only increased the µTBS of GB (no EDTA) and SB (with EDTA) after 3 d (P≤0.02). Comparing the adhesives after 3 d of storage, CSE exhibited the greatest µTBS values followed by GB and SB (P≤0.02). The factors of adhesive, EDTA, and TM did not show any significant impact on µTBS when specimens were stored for 6 months (P>0.05). The additional application of TM and EDTA for cavity preparation seems only to have a short-term effect, and no influence on µTBS of dentin bonds after a period of 6 months.
Subject(s)
Caseins/chemistry , Dental Bonding , Resins, Synthetic , Smear Layer , Humans , Microscopy, Electron, Scanning , Time FactorsABSTRACT
Eucommia ulmoides Oliv. (EuO), also known as Duzhong, native to China, has been reported to have antioxidative function, but its cellular mechanism is not fully examined yet. We investigated inhibitory effects of EuO leaf ethanol extracts on H(2)O(2)-induced apoptosis in rat osteoblastic MC3T3-E1 cells and underlying mechanisms. Locally-grown Duzhong leaves were extracted with ethanol. MC3T3-E1 cells were treated with EuO (6.25, 12.5, 25, 50, and 100 µg/ml) for 24 h, and then H(2)O(2) (800 µmol/L) for an additional 24 h. Cell survival rate, percentage of apoptosis, and expressions of caspases 3, 6, 7, and 9 were examined using 3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyltetrazolium bromide (MTT) assay, microscopic analysis, Western blotting, and reverse transcription polymerase chain reaction (RT-PCR). The final EuO leaf ethanol extract powder was detected to contain caffeotannic acid at 58 mg/g and geniposide at 3.45 mg/g by high performance liquid chromatography (HPLC). EuO remarkably restrained cell oxidative damage and increased cell survival rate in a dose-dependent manner: 0 µg/ml, 0.21; 6.25 µg/ml, 0. 28; 12.5 µg/ml, 0.31; 25 µg/ml, 0.48; 50 µg/ml, 0.54; and 100 µg/ml, 0.66 (P<0.05), with the half-effective concentration being around 25 µg/ml. MTT results were confirmed by microscopic analysis. Western blotting and RT-PCR analyses showed that the expressions of caspases 3, 6, 7, and 9 were significantly decreased in the EuO-treated cells compared with the control (EuO- and H(2)O(2)-free) (P<0.05), with the half-effective concentration of EuO ranging from 12.5 to 25 µg/ml. We conclude that the ethanol-extracted EuO leaf extracts promoted the growth of MC3T3-E1 cells, and suppressed the H(2)O(2)-induced apoptosis in a rat MC3T3-E1 osteogenic cell model, likely due to the inhibition of caspases' activities. The results indicate that EuO is a potent antioxidant, which may contribute to its many cellular protective functions, including the promotion of bone growth.