ABSTRACT
l-carnitine is an essential dietary supplement of physiological importance. Handling and manufacture of l-carnitine is difficult due to its hygroscopic nature, resulting in impairing its flow properties, as well as solid dosage form stability. The study aimed at reducing l-carnitine hygroscopicity through its encapsulation within a hydrophobic, pH-insensitive polymer. A solid in oil in oil (s/o/o) emulsion solvent evaporation technique for microencapsulation was adopted to exclude the possibility of water uptake. The polymers used were two ethyl cellulose (EC) grades with different viscosities. The chosen solvent for the polymer was acetone, and liquid paraffin was the dispersion medium in which both the drug and polymer were insoluble. Sixteen formulations were developed, and evaluated to study the formulation parameters as anti-coalescent type, mixing speed, surfactant type and polymer ratio, and viscosity grade. A "One Factor at A Time" (OFAT) design of experiment, and a factorial design were utilized. Study results revealed that successful microencapsulation occurred by using Aerosil 200 (0.1 %) as anti-coalescent, a mixing speed of 1000 rpm, and Ethocel Std 20 at a 3:1 drug-to-polymer ratio. Microcapsule formulation containing l-carnitine base, successfully compressed into tablets, showed acceptable water content, disintegration time, hardness, and dissolution. Moreover, it showed acceptable stability upon storage at 40 °C at 75 % RH for six months compared to l-carnitine tablets prepared by wet granulation.
ABSTRACT
L-carnitine-L-tartrate, a non-essential amino acid, is hygroscopic. This causes a problem in tablet production due to pronounced adhesion of tablets to punches. A 33 full factorial design was adopted to suggest a tablet formulation. Three adsorbents were suggested (Aerosil 200, Aerosil R972, talc) to reduce stickiness at three concentrations (1, 3 and 5 %), and three fillers (mannitol, Avicel PH 101, Dibasic calcium phosphate) were chosen to prepare 27 formulations. Micromeritic properties of formulations were studied, and tablets were prepared by wet granulation. Absence of picking, sticking or capping, recording of sufficient hardness, acceptable friability and tablet ejection force indicated formulation success. The resulting formulation prepared using Avicel PH 101 and 1 % Aerosil 200 was submitted to further investigation in order to choose the most suitable compression conditions using a 33 full factorial design. Variables included compression force, tableting rate and magnesium stearate (lubricant) concentration. The formulation prepared at compression force of 25 kN, using 2 % magnesium stearate, at a production rate of 30 tablets/ minute, was found to be the most appropriate scale up candidate.