ABSTRACT
The present paper reported on the analysis of structural defects and their influence on the red-emitting γ-Al2O3:Mn4+,Mg2+ nanowires using positron annihilation spectroscopy (PAS). The nanowires were synthesized by hydrothermal method and low-temperature post-treatment using glucose as a reducing agent. X-ray diffraction (XRD), scanning electron microscopy (SEM), photoluminescence (PL), and photoluminescence excitation (PLE) were utilized, respectively, for determining the structural phase, morphology and red-emitting intensity in studied samples. Three PAS experiments, namely, positron annihilation lifetime (PAL), Doppler broadening (DB), and electron momentum distribution (EMD), were simultaneously performed to investigate the formations of structural defects in synthesized materials. Obtained results indicated that the doping concentration of 0.06% was optimal for the substitution of Mn4+ and Mg2+ to two Al3+ sites and the formation of oxygen vacancy (VO)-rich vacancy clusters (2VAl + 3VO) and large voids (~0.7 nm) with less Al atoms. Those characteristics reduced the energy transfer between Mn4+ ions, thus consequently enhanced the PL and PLE intensities. Moreover, this optimal doping concentration also effectively controlled the size of nanopores (~2.18 nm); hence, it is expected to maintain the high thermal conductivity of γ-Al2O3 nanowire-phosphor. The present study, therefore, demonstrated a potential application of γ-Al2O3 nanowire-phosphor in fabricating the high-performance optoelectronic devices.
Subject(s)
Aluminum Oxide , Magnesium , Manganese , Nanowires , Aluminum Oxide/chemistry , Cations/chemistry , Manganese/chemistry , Magnesium/chemistry , Electrons , Spectrophotometry , X-Ray Diffraction , Nanowires/chemistry , Nanowires/ultrastructure , Microscopy, Electron, ScanningABSTRACT
A technique using two measurements from opposing directions for the assay of the activity of radioactive waste drums, mainly consisting of organic materials, has been studied. A model for the calculation of systematic errors is given by simulating the measurement system. The calculated values are in good agreement with the experimental values. This confirms the validity of the model and proofs the good performance of this technique in practice. These results may provide guidelines for setting up a measuring system for the assay the radwaste drums.