Geographical distribution of nitrate pollution and its risk assessment using GIS and Monte Carlo simulation in drinking water in urban areas of Fars province-Iran during 2017-2021.

Pollution of water resources with nitrate is currently one of the major challenges at the global level. In order to make macro-policy decisions in water safety plans, it is necessary to carry out nitrate risk assessment in underground water, which has not been done in Fars province for all urban areas. In the current study, 9494 drinking water samples were collected in four seasons in 32 urban areas of Fars province in Iran, between 2017 and 2021 to investigate the non-carcinogenic health risk assessment. Geographical distribution maps of hazard quotient were drawn using geographical information system software. The results showed that the maximum amount of nitrate in water samples in 4% of the samples in 2021, 2.5% of the samples in 2020 and 3% of the samples in 2019 were more than the standard declared by World Health Organization guidelines (50 mg/L). In these cases, the maximum amount of nitrate was reported between 82 and 123 mg/L. The HQ values for infants did not exceed 1 in any year, but for children (44% ± 10.8), teenagers (10.8% ± 8.4), and adults (3.2% ± 1.7) exceeded 1 in cities, years, and seasons, indicating that three age groups in the studied area are at noticeably significant non-carcinogenic risk. The results of the Monte Carlo simulation showed that the average value of non-carcinogenic risk was less than 1 for all age groups. Moreover, the maximum HQ values (95%) were higher than 1 for both children and teenager, indicating a significant non-carcinogenic risk for the two age groups.

Systematic review and meta-analysis of arsenic concentration in drinking water sources of Iran.

Recent studies have found arsenic contamination of drinking water in some parts of Iran, as in many other countries. Thus, a comprehensive systematic review is necessary to assess the distribution and concentration of arsenic in drinking water sources. For this purpose, articles published from the first identification until December 2023, were retrieved from various national and international databases. Of all the studies examined (11,726), 137 articles were selected for review based on their conceptual relationship to this survey. A review of the extracted studies presented that ICP methods (ICP-MS, ICP-OES, 56%) and atomic absorption spectrophotometry (AAS, 34.1%) were the two most commonly used techniques for the analysis of arsenic in water samples. The order of arsenic content in the defined study areas is descending, as follows: northwest ˃ southeast ˃ southwest ˃ northeast. A review of studies performed in Iran depicted that provinces such as Kurdistan, Azerbaijan, and Kerman have the highest arsenic concentrations in water resources. Accordingly, the maximum concentration of arsenic was reported in Rayen, Kerman, and ranged from < 0.5-25,000 µg/L. The primary cause of elevated arsenic levels in water resources appears to be geologic structure, including volcanic activity, biogeochemical processes, sulfur-bearing volcanic rocks, Jurassic shale, the spatial coincidence of arsenic anomalies in tube wells and springs, and, to some extent, mining activities. The findings of the presented survey indicate that it is essential to take serious measures at the national level to minimize the health risks of arsenic contamination from drinking water consumption.

Accumulation, sources, and health risks of phthalic acid esters (PAEs) in road dust from heavily industrialized, urban and rural areas in southern Iran.

In this research, a total of 51 road dust samples were collected from three districts (Asaluyeh, Bushehr, and Goshoui) in the south of Iran from April to June 2022 and analyzed for the concentration of 7 phthalic acid esters (PAEs) compounds. Asaluyeh was considered as an industrial area (near gas and petrochemical industries), Bushehr as an urban area, and Goshoui as a rural area (far from pollution sources). The PAEs concentration of the street dust samples was determined using a mass detection gas chromatography (GC/MS). The mean ± SD levels of Æ©PAEs in samples from industrial, urban, and rural sources were 56.9 ± 11.5, 18.3 ± 9.64, and 5.68 ± 1.85 µg/g, respectively. The mean concentration levels of Æ©PAEs was significantly (P < 0.05) higher in samples from the industrial area than urban and rural areas. The mean levels of di(2-Ethylhexyl) phthalate (DEHP) in industrial, urban, and rural areas were 20.3 ± 8.76, 4.59 ± 1.71, and 2.35 ± 0.98 µg/g, respectively. The results of the PCA analysis indicate that the likely major sources of PAEs in the road dust in the studied areas are the application of various plasticizers in industry, solvents, chemical fertilizers, waste disposal, wastewater (e.g., agricultural, domestic, and industrial), and the use of plastic films and plastic-based irrigation pipes in greenhouses. As well as, it was found that the non-cancer risk of exposure to dust-bound PAEs was higher for children than for adults. These values were <1 for both age groups (children and adults) and the exposure of inhabitants to PAEs in road dust did not pose a notable non-cancer risk. The cancer risk from exposure to DEHP in road dust was below the standard range of 10-6 in all three areas. Further studies that consider different routes of exposure to these contaminants are needed for an accurate risk assessment. Moreover, since higher PAEs level was found in industrial area, decision-makers should adopt strict strategies to control the discharging of pollution from industries to the environment and human societies.

First report on BTEX leaching from waterpipe tobacco wastes (WTWs) into aquatic environment.

Waterpipe tobacco wastes (WTWs) may contain considerable levels of hazardous contaminants such as BTEX (benzene, toluene, ethylbenzene, o-xylene, and m/p-xylene). However, no research has been carried out on BTEX levels in WTWs and the release of these pollutants into the water environment. This research examined the levels of BTEX in WTWs of flavored/local tobacco and also the release rate of these toxins into three kinds of water, including seawater (SW), tap water (TW), and distilled water (DW) with different leaching times (15, 30 min, 1.2, 4, 8 h, and 1, 2, and 4 days). The mean contents of BTEX in WTW samples of Al-Mahmoud, Al-Fakher, Mazaya, Al-Ayan brands, and local tobacco samples were 17.0 ± 4.14, 19.1 ± 4.65, 19.6 ± 4.19, 18.8 ± 4.14, and 3.16 ± 0.63 µg/kg, respectively. The mean BTEX levels in flavored tobacco samples were considerably greater than that of local tobacco (p < 0.05). The WTWs leaching experiments showed that the levels of BTEX ranged from 5.26 to 6.12, 5.02-5.60, and 3.83-5.46 µg/L in DW, TW, and SW, respectively. All target compounds were found for all exposure times in DW, TW, and SW samples. After adding sodium azide as an antibacterial agent to water samples (simulating biodegradation processes), higher levels of BTEX compounds were detected in SW. Further research is needed to address the potential environmental hazards due to WTWs leaching into aquatic environments.

Post-consumption waterpipe tobacco waste as an unrecognized source of toxic metal(loid)s leachates into aquatic environments.

Waterpipe is a common form of tobacco smoking, and recently, its use has been increasing globally. Therefore, concern arises regarding the large quantity of post-consumption waterpipe tobacco waste produced and released into the environment and which can contain high levels of dangerous pollutants such as toxic meta(loid)s. This study reports the concentrations of meta(loid)s in waste from fruit-flavoured and traditional tobacco smoking as well as the release rate of these pollutants from waterpipe tobacco waste into three types of water. These include distilled water, tap water, and seawater and contact times ranging from 15 min to 70 days. The mean concentration levels of Æ©metal(loid)s in waste samples of Al-mahmoud, Al-Fakher, Mazaya, Al-Ayan brands and traditional tobacco brands were 212 ± 92.8, 198 ± 94.4, 197 ± 75.7, 214 ± 85.8 and 40.6 ± 16.1 µg/g, respectively. The concentration levels of Æ©metal(loid)s in fruit-flavoured tobacco samples were significantly higher than for traditional tobacco samples (p < 0.05). It was found that waterpipe tobacco wastes leached toxic metal(loid)s into different water samples with similar trends. In addition distribution coefficients showed that most metal(loid)s are highly likely to enter the liquid phase. The concentration levels of these pollutants (except Ni and As) in deionized water and tap water exceeded the surface fresh water standards for sustaining aquatic life during long contact time (up to 70 days). In seawater, concentration levels of Cu and Zn exceeded the recommended standards for maintaining aquatic life in the sea. Therefore, due to the possibility of contamination by soluble metal(loid)s through disposal of waterpipe tobacco waste in wastewater, there is concern that these toxic chemicals might enter the human food chain. Appropriate regulatory measures for disposal of waterpipe tobacco waste are necessary to prevent environmental pollution due to discarded wastes into aquatic ecosystems.

Application of fingernail samples as a biomarker for human exposure to arsenic-contaminated drinking waters.

This study evaluated the relationship between arsenic uptake via drinking water ingestion and arsenic concentration in fingernails as a biomarker for human exposure. For this purpose, we collected fingernail samples from 40 healthy participants of arsenic-affected rural regions of Kaboudrahang County, the west of Iran. A total of 49 fingernail samples were also collected from individuals who lived in areas where contamination of drinking water sources with arsenic had not been reported. It was found that the fingernails arsenic contents in 50 and 4.08% of the samples collected from arsenic-contaminated and reference villages were higher than the normal arsenic values of nails (0.43-1.08 µg/g), respectively. Based on the results of adjusted multiple linear regression, a significant association was found between groundwater and fingernails arsenic concentration (p < 0.001). Moreover, a statistically significant association was shown between arsenic in the fingernail samples and gender (p = 0.037). Fingernails arsenic contents were not significantly affected by other variables including age, smoking habits, and BMI (p > 0.05). In light of the results of this study, the use of biological indicators such as fingernail tissues due to easier sampling and less risk of external contamination is suitable for assessing exposure to heavy metals in contaminated areas.

Deterministic and probabilistic human health risk assessment approach of exposure to heavy metals in drinking water sources: A case study of a semi-arid region in the west of Iran.

In the current study, the concentration of heavy metals (Ba, Mn, Pb, and Cd) in drinking water resources of 328 villages in Hamadan Province were measured using ICP-OES apparatus during two dry (September 2018) and wet (April 2019) seasons. The assessment of the non-carcinogenic risk of selected heavy metals was conducted based on the recommendations of the USEPA. Also, sensitivity analysis and uncertainty of the effective variables were performed using Monte-Carlo simulations. Based on the results, Mn level in drinking water samples ranged 0.08-25.63 µg/L and 0.08-20.03 µg/L in dry and wet seasons, respectively. Similarly, Ba levels in water samples ranged 0.15-70.13 µg/L and 0.84-65 µg/L. Also, Cd and Pb concentrations in all sampling sites were below the limits of detection (LOD) of the ICP-OES apparatus. The hazard index (HI) values for adult and children were 2.17 × 10-3 and 3.29 × 10-3, respectively, which show a lack of non-carcinogenic risk for the examined heavy metals (Mn and Ba) to the local inhabitants. The results of the sensitivity analyses for adults and children revealed that two variables including metal concentration and ingestion rate of drinking water (IR) had the highest positive effects on the non-carcinogenic risk estimates. It was also found that there was no significant non-carcinogenic risk for the local residents in the studied area due to drinking water consumption.

The relationship between chronic exposure to arsenic through drinking water and hearing function in exposed population aged 10-49 years: A cross-sectional study.

It has been documented that arsenic has a potential risk to human health and identified as a risk factor for hearing impairment. However, there are few studies that confirm the ototoxic effect of arsenic, especially on the human auditory system. Therefore, the current study was conducted to investigate the correlation between auditory thresholds at different frequencies (0.25, 0.5, 1, 2, 4 and 8 kHz) and arsenic levels in drinking water samples. A total of 240 people, divided into two equal groups: exposed and reference, were selected for the auditory tests. It should be noted that, at frequencies from 0.25 to 1 kHz, no hearing loss was observed in the both groups. Based on the results, no significant correlations (p > 0.05) were found between hearing thresholds and confounding variables including gender and BMI. However, smoking and age are known to be the main variables for hearing loss in univariate regression analysis. In the case of age, the hearing loss risk in the older participants was increased compared with the younger participants (4 kHz (OR =1.09; 95% CI: 1.04, 1.13) and 8 kHz (OR =1.12; 95% CI: 1.06, 1.18)). Smoking habits had significant associations with hearing loss risk at 4 kHz (OR = 3.48; 95% CI: 1.47, 8.22) and 8 kHz (OR = 3.01; 95% CI: 1.14, 7.95). The multivariate regression analysis showed that age, smoking status, and exposure to arsenic were significantly associated with increased risk of hearing loss. Moreover, no statistically significant correlation (p˃0.05) was observed between arsenic exposure and hearing loss in the logistic regression model compared to the reference group. These outcomes suggest that further investigation and cohort studies with a larger number of participants should be conducted to find an association between arsenic exposure and hearing loss in general population.

Study of the efficiency of moving bed biofilm reactor (MBBR) in LAS Anionic Detergent removal from hospital wastewater: determination of removing model according to response surface methodology (RSM).

Detergents are considered one of the important pollutants in hospital wastewater. Achieving efficient and bio-friendly methods for the removal of these pollutants is considered as a concern for environmental researchers. This study aims at studying the efficiency of a moving bed biofilm reactor (MBBR) system for removing linear alkyl benzene sulfonate (LAS) from hospital wastewater with utilization of response surface methodology (RSM). The present study was carried out on a reactor with continuous hydraulic flow using media k1 at pilot scale to remove detergent from hospital wastewater. The effect of independent variables including contact time, percentage of media filling and mixed liquor suspended solids (MLSS) concentration of 1000-3000 mg/l on the system efficiency were assessed. Methylene blue active substances (MBAS) and chemical oxygen demand (COD) 750-850 mg/l were used by closed laboratory method in order to measure the concentration of LAS. The results revealed that the removal efficiency of LAS detergent and COD using media k1, retention time of 24 hours, and MLSS concentration of around 3,000 mg/l were 92.3 and 95.8%, respectively. The results showed that the MBBR system as a bio-friendly compatible method has high efficiency in removing detergents from hospital wastewater and can achieve standard output effluent in acceptable time.