RÉSUMÉ
In the planar heterostructure of perovskite-based solar cells (PSCs), tin oxide (SnO2) is a material that is often used as the electron transport layer (ETL). SnO2 ETL exhibits favorable optical and electrical properties in the PSC structures. Nevertheless, the open circuit voltage (VOC) depletion occurs in PSCs due to the defects arising from the high oxygen vacancy on the SnO2 surface and the deeper conduction band (CB) energy level of SnO2. In this research, a cerium (Ce) dopant was introduced in SnO2 (Ce-SnO2) to suppress the VOC loss of the PSCs. The CB minimum of SnO2 was shifted closer to that of the perovskite after the Ce doping. Besides, the Ce doping effectively passivated the surface defects on SnO2 as well as improved the electron transport velocity by the Ce-SnO2. These results enabled the power conversion efficiency (PCE) to increase from 21.1% (SnO2) to 23.0% (Ce-SnO2) of the PSCs (0.09 cm2 active area) with around 100 mV of improved VOC and reduced hysteresis. Also, the Ce-SnO2 ETL-based large area (1.0 cm2) PSCs delivered the highest PCE of 22.9%. Furthermore, a VOC of 1.19 V with a PCE of 23.3% was demonstrated by Ce-SnO2 ETL-based PSCs (0.09 cm2 active area) that were treated with 2-phenethylamine hydroiodide on the perovskite top surface. Notably, the unencapsulated Ce-SnO2 ETL-based PSC was able to maintain above 90% of its initial PCE for around 2000 h which was stored under room temperature condition (23-25 °C) with a relative humidity of 40-50%.
RÉSUMÉ
Keratins are an integral part of cell structure and function. Here, it is shown that ectopic expression of a truncated isoform of keratin 81 (tKRT81) in breast cancer is upregulated in metastatic lesions compared to primary tumors and patient-derived circulating tumor cells, and is associated with more aggressive subtypes. tKRT81 physically interacts with keratin 18 (KRT18) and leads to changes in the cytosolic keratin intermediate filament network and desmosomal plaque formation. These structural changes are associated with a softer, more elastically deformable cancer cell with enhanced adhesion and clustering ability leading to greater in vivo lung metastatic burden. This work describes a novel biomechanical mechanism by which tKRT81 promotes metastasis, highlighting the importance of the biophysical characteristics of tumor cells.
Sujet(s)
Tumeurs du sein , Kératines spécifiques du cheveu , Femelle , Humains , Tumeurs du sein/métabolisme , Tumeurs du sein/anatomopathologie , Expression génique ectopique , Kératines spécifiques du cheveu/génétique , Kératines spécifiques du cheveu/métabolisme , Isoformes de protéines/génétiqueRÉSUMÉ
Introduction: Cell proliferation represents a major hallmark of cancer biology, and manifests itself in the assessment of tumor growth, drug resistance and metastasis. Tracking cell proliferation or cell fate at the single-cell level can reveal phenotypic heterogeneity. However, characterization of cell proliferation is typically done in bulk assays which does not inform on cells that can proliferate under given environmental perturbations. Thus, there is a need for single-cell approaches that allow longitudinal tracking of the fate of a large number of individual cells to reveal diverse phenotypes. Methods: We fabricated a new microfluidic architecture for high efficiency capture of single tumor cells, with the capacity to monitor cell divisions across multiple daughter cells. This single-cell proliferation (SCP) device enabled the quantification of the fate of more than 1000 individual cancer cells longitudinally, allowing comprehensive profiling of the phenotypic heterogeneity that would be otherwise masked in standard cell proliferation assays. We characterized the efficiency of single cell capture and demonstrated the utility of the SCP device by exposing MCF-7 breast tumor cells to different doses of the chemotherapeutic agent doxorubicin. Results: The single cell trapping efficiency of the SCP device was found to be ~ 85%. At the low doses of doxorubicin (0.01 µM, 0.001 µM, 0.0001 µM), we observed that 50-80% of the drug-treated cells had undergone proliferation, and less than 10% of the cells do not proliferate. Additionally, we demonstrated the potential of the SCP device in circulating tumor cell applications where minimizing target cell loss is critical. We showed selective capture of breast tumor cells from a binary mixture of cells (tumor cells and white blood cells) that was isolated from blood processing. We successfully characterized the proliferation statistics of these captured cells despite their extremely low counts in the original binary suspension. Conclusions: The SCP device has significant potential for cancer research with the ability to quantify proliferation statistics of individual tumor cells, opening new avenues of investigation ranging from evaluating drug resistance of anti-cancer compounds to monitoring the replicative potential of patient-derived cells. Supplementary Information: The online version contains supplementary material available at 10.1007/s12195-023-00773-z.
RÉSUMÉ
In this research, a heterostructure of the CuO-ZnO-based solar cells has been fabricated using low-cost, earth-abundant, non-toxic metal oxides by a low-cost, low-temperature spin coating technique. The device based on CuO-ZnO without a hole transport layer (HTL) suffers from poor power conversion efficiency due to carrier recombination on the surface of CuO and bad ohmic contact between the metal electrode and the CuO absorber layer. The main focus of this research is to minimize the mentioned shortcomings by a novel idea of introducing a solution-processed vanadium pentoxide (V2O5) HTL in the heterostructure of the CuO-ZnO-based solar cells. A simple and low-cost spin coating technique has been investigated to deposit V2O5 onto the absorber layer of the solar cell. The influence of the V2O5 HTL on the performance of CuO-ZnO-based solar cells has been investigated. The photovoltaic parameters of the CuO-ZnO-based solar cells were dramatically enhanced after insertion of the V2O5 HTL. V2O5 was found to enhance the open-circuit voltage of the CuO-ZnO-based solar cells up to 231 mV. A detailed study on the effect of defect properties of the CuO absorber layer on the device performance was theoretically accomplished to provide future guidelines for the performance enhancement of the CuO-ZnO-based solar cells. The experimental results indicate that solution-processed V2O5 could be a promising HTL for the low-cost, environment-friendly CuO-ZnO-based solar cells.
RÉSUMÉ
This article reports a solution-processed synthesis of copper oxide (Cu x O) to be used as a potential photocathode for solar hydrogen production in the solar water-splitting system. Cu x O thin films were synthesized through the reduction of copper iodide (CuI) thin films by sodium hydroxide (NaOH), which were deposited by the spin coating method from CuI solution in a polar aprotic solvent (acetonitrile). The phase and crystalline quality of the synthesized Cu x O thin films prepared at various annealing temperatures were investigated using various techniques. The X-ray diffraction and energy dispersive X-ray spectroscopy studies confirm the presence of Cu2O, CuO/Cu2O mixed phase, and pure CuO phase at annealing temperatures of 250, 300, and 350 °C, respectively. It is revealed from the experimental findings that the synthesized Cu x O thin films with an annealing temperature of 350 °C possess the highest crystallinity, smooth surface morphology, and higher carrier density. The highest photocurrent density of -19.12 mA/cm2 at -1 V versus RHE was achieved in the photoelectrochemical solar hydrogen production system with the use of the Cu x O photocathode annealed at a temperature of 350 °C. Therefore, it can be concluded that Cu x O synthesized by the spin coating method through the acetonitrile solvent route can be used as an efficient photocathode in the solar water-splitting system.
RÉSUMÉ
The transport of deformable objects, including polymer particles, vesicles, and cells, has been a subject of interest for several decades where the majority of experimental and theoretical studies have been focused on circular tubes. Due to advances in microfluidics, there is a need to study the transport of individual deformable particles in rectangular microchannels where corner flows can be important. In this study, we report measurements of hydrodynamic mobility of confined polymeric particles, vesicles, and cancer cells in a linear microchannel with a square cross-section. Our operating conditions are such that the mobility is measured as a function of geometric confinement over the range 0.3 < λ < 1.5 and at specified particle Reynolds numbers that are within 0.1 < Rep < 2.5. The experimental mobility data of each of these systems is compared with the circular-tube theory of Hestroni, Haber, and Wacholder [J. Fluid Mech. 41, 689-705 (1970)] with modifications made for a square cross-section. For polymeric particles, we find that the mobility data agrees well over a large confinement range with the theory but under predicts for vesicles. The mobility of vesicles is higher in a square channel than in a circular tube, and does not depend significantly on membrane mechanical properties. The mobility of cancer cells is in good agreement with the theory up to λ ≈ 0.8, after which it deviates. Comparison of the mobility data of the three systems reveals that cancer cells have higher mobility than rigid particles but lower than vesicles, suggesting that the cell membrane frictional properties are in between a solid-like interface and a fluid bilayer. We explain further the differences in the mobility of the three systems by considering their shape deformation and surface flow on the interface. The results of this study may find potential applications in drug delivery and biomedical diagnostics.
RÉSUMÉ
There is growing recognition that cell deformability can play an important role in cancer metastasis and diagnostics. Advancement of methods to characterize cell deformability in a high throughput manner and the capacity to process numerous samples can impact cancer-related applications ranging from analysis of patient samples to discovery of anti-cancer compounds to screening of oncogenes. In this study, we report a microfluidic technique called multi-sample deformability cytometry (MS-DC) that allows simultaneous measurement of flow-induced deformation of cells in multiple samples at single-cell resolution using a combination of on-chip reservoirs, distributed pressure control, and data analysis system. Cells are introduced at rates of O(100) cells per second with a data processing speed of 10 min per sample. To validate MS-DC, we tested more than 50 cell-samples that include cancer cell lines with different metastatic potential and cells treated with several cytoskeletal-intervention drugs. Results from MS-DC show that (i) the cell deformability correlates with metastatic potential for both breast and prostate cancer cells but not with their molecular histotype, (ii) the strongly metastatic breast cancer cells have higher deformability than the weakly metastatic ones; however, the strongly metastatic prostate cancer cells have lower deformability than the weakly metastatic counterparts, and (iii) drug-induced disruption of the actin network, microtubule network, and actomyosin contractility increased cancer cell deformability, but stabilization of the cytoskeletal proteins does not alter deformability significantly. Our study demonstrates the capacity of MS-DC to mechanically phenotype tumor cells simultaneously in many samples for cancer research.